Having problems with your Rainbow E series Canister Wet/Dry Vacuum ?

How to replace the motor in rainbow e series power nozzle


Answers :

Repair Help & Product Troubleshooting for Rainbow E series Canister Wet/Dry Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to replace the motor in rainbow e series power nozzle


... Rainbow E series Canister Wet/Dry Vacuum

Power nozzle on E-series won't start when cold unless the red 'reset' button is pressed multiple times while also holding the trigger to 'warm it up'...this is w/the power nozzle off the floor - no restriction on it turning. Once it's been running and then turned off the button must be pressed w/the trigger to get it to run - again w/the nozzle off the floor. It also seems to shut off too easily while vacuuming. I replaced the motor,which didn't fix it. Is the reset switch next on my list? T


... Rainbow E series Canister Wet/Dry Vacuum

Have a rainbow e series with 2 speed motor replaced motor with another now after 5 minutes on the vacuum the motor cuts off intermitently like a power surge. all the connections and wires have continuity any ideas???


... Vacuums

Have an e-series rainbow. Belt and brush bar have been replaced in power head. But the red reset button can still be pushed and it is not staying going like it should. May it be the motor?


... Rainbow E series Canister Wet/Dry Vacuum

There was a foam piece above the motor of my rainbow d4c power nozzle. When I took the plate off it desintigrated and fell off. Was that supposed to be there? If so how do I find a replacement?


You said "above the motor", so I assume you meant the smaller foam piece located there, and not the gasket seal that is affixed to the inside of the metal bottom plate, (which is what the previous solution responder was referring to).Most ... Rainbow 75th Anniversary Canister Vacuum

Replace on/off switch on rainbow D3 vacuum - Rainbow D3 Canister Vacuum Cleaner Power Nozzle Reset Switch Vac Cleaner Power Nozzle Reset Switch


... Rainbow D3 Canister Vacuum Cleaner Power Nozzle Reset Switch Vac Cleaner Power Nozzle Reset Switch

Rainbow E Series Power Nozzle I'm not sure which part of it is not working?


<p>The power nozzle brush roll bearings could be locking up from hair and debris wrapped around them. If that is the case, then the brush roll will be hard to turn and will cause the belt to heat up and give a burning smell. If you need to spea ... Rainbow E series Canister Wet/Dry Vacuum

Power nozzle for rainbow vaccum is getting power but the motor does not work nozzle model r-2800c


Hi there it's SmartAlec from NelsonVacuums.com.au here. It will either be the fuse or the motor itself. If you disconnect the wires from the fuse and join them together and ... Vacuums

How do I get the motor out of the power nozzle on the E-series?


The eSERIES Rainbow has several versions of the power nozzle. Some screw apart and others have snap connections. Look at our website on the manuals page to determine your model. You can also call us and speak to a Rainbow Specialist.RainVac ... Rainbow E series Canister Wet/Dry Vacuum

Replacement instructions forEureka Electrolux PN5, PN6 Power Nozzle motor #62058-1


... ELECTROLUX Commercial Upright SANITAIRE DURALITE UPRIGHT VACUUM Each

Replace power cord on rainbow aquamate 2 - Rainbow E series Canister Wet/Dry Vacuum


... Rainbow E series Canister Wet/Dry Vacuum

Where can I get a new power head motor replacement for SE series,original motor GS ELECTRIC 5570-02-1 in UK or Ireland,Thank you,Liam.


... Rainbow E series Canister Wet/Dry Vacuum

Rainbow vaccum power nozzle model number r-2800c is getting power but the motor does not run


Check circuit breaker inside of power nozzle shell. Bypass it temporarily to see if motor will run without circuit breaker wired in.If motor runs without it, it's a faulty circuit breaker (expensive to replace) ..... if motor still does n ... Vacuums

My Rainbow E Series poweres on but after a while that it is working it sounds like it wants to power off, the motor seems to loose speed and then it continues.


If you have used it alot, then the brushes are PROBABLY worn and failing. You should take it to have this checked as it will wreck the commutator to run that way requiring whole motor to be replaced. Take it to a repair facility. ... Rainbow E series Canister Wet/Dry Vacuum

Rainbow e series smells burnt when power nozzle in use


Replace the belt in the power nozzle, it has to be changed yearly. ... Rainbow E series Canister Wet/Dry Vacuum

I have a Rainbow E2 series, 23, for about 3 years. It has now a different and very aloud sound coming fron around the motor and also I feel it is not suctioning with the same power. If I close the hose like closing totally the suction entrance, the sound comes normally. I will appreciate if some one can tell me what to do, becouse there is not a Dealer in my Contry any more. Thank You. Pierre Chabaneix - Lima-Peru [email protected]


Hi there, Pierre!\015\012Sorry, but I think this is bad news. From your description, I suspect that a motor bearing has failed. The only way to fix it is to replace the motor, and without a dealer in your country, that could be a big problem.\015\012 ... Rainbow E series Canister Wet/Dry Vacuum

The power nozzle works but only on tile. the brush does not turn. the belt is intact. could the motor that turns the belt be broke? is this something i can replace myself or is it better to bring it to be serviced


Depends on you if you feel you could possibly repair it by replacing the electrical motor or you may just have a wire thats nolonger getting continity. enevitably it's your decision if you can repair it you will come off cheaper :) ... Electrolux Guardian Bagged Canister Vacuum

Power nozzle of my S3670 does not work (vacuum itself does work), the headlight bulb in the nozzle is broken. This happened in the past several times - we would bring the vacuum to service center - I don't know what they did other than replacing the bulb. I decided to go to ACE and buy replacement bulb myself, replaced the one in the nozzle - this did not fix the problem. I don't see any fuzes or anything in the nozzle. However, the manuals says to "Use only HOOVER part no. 27317307, which is a


... Hoover S3670 Bagged Canister Vacuum

I have a Kirby Dual Sanitronic '50' Vacuum Cleaner I bought in 1966. The motor does not start when I attach the belt lifter of the rug nozzle. When I remove the rug nozzle and detach the belt from the motor fan shaft the motor starts when I depress the nozzle switch and the power switch . Seems like the brushes in the motor are worn out. I do not have a manual for this unit. Can you assist me as to what newer unit is this compatible to and the problem I'm having at present??


... Kirby Vacuums

Electrolux 2100 power nozzle motor doesn't run


... Vacuums

Problem with E series rainbow, motor starts then slows down to a halt and smells.


From what you describe, you will probably have to replace the motor. But you could take it apart and see if it just needs carbon brushes. ... Vacuums

Electrolux 6500sr power nozzle motor


If you go to aerusonline.com, there is a dealer locater function that will allow you to find the nearest aerus electrolux store. If there isn't one local, I would call one of them and have them ship it to you. You may be able to find an aftermarket m ... Electrolux Epic 6500 Vacuum

The motor on my Epic 6500 works, the hose is sucking, but the power head isn;t working... I tried the sidestep power head and that one works. Ive opened and replaced the belt and that is fine. The bulb was already burned out and wasn't replaced so I cant tell if theres power to the head. What else could it be?


Connect the power nozzle directly to the hose and try.\015\012Check the terminals where the wand connects to the PN. If any are discolored or cracked, that may be the problem.\015\012Open the PN and check for loose or broken wires and co ... Electrolux Epic 6500 Vacuum

Wiring diagram for a rainbow vacumn cleaner power nozzle


... Vacuums

Replacing Power Cord to Power Nozzle


The height adjust mech. has 2 tabs, that you have to unlock, It also is easier when you tip the power head so as not to puit pressure on the Ht. Adj. wheels. Use a flat blade screwdriver and if you look down bertween the ht. adj. mech. and the elbo ... Kenmore 22812 Bagged Canister Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0595 seconds