Having problems with your Rainbow E series Canister Wet/Dry Vacuum ?

Rainow e series vacuum

\015 Water is blowing thru rear filter and is leaking onto floor.\015

Answers :

Is the filter installed at the bottom of the Rainbow the sits above the water pan?
Repair Help & Product Troubleshooting for Rainbow E series Canister Wet/Dry Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Rainow e series vacuum


Is the filter installed at the bottom of the Rainbow the sits above the water pan? ... Rainbow E series Canister Wet/Dry Vacuum

I have a Eureka 4800 series the Boss upright with a bag and Hepa filter. I love it! I was just vacuuming with the hose part and all was well and then suddenly the lower brush came on and a "burning" smell followed. Thought it was the belt so my husband was going to put on the new belt which I had on hand! When he turned it over, the "bar" that holds the belt looks as though it "shot through" the plastic side of the housing on the vacuum. There is melted plastic on the outside of the vacuum and o


I had the same problem. Take out the old belt if possible. Remove the 4 screws inside the filter and the 3 on the front of that housing. pull out the foam around the motor. carefully pull out the suction tube that is press fit against the motor. ... Eureka 4874 Bagged Upright Vacuum

My simplicity 7 series vacuum belt turns the agitator (beater brush) turns freely by hand when the vacuum is unplugged or off but when I turn the vacuum on the agitator does not spin even though the belt is moving. Could there be a worn out part at the agitator pin where it connects to the flywheel that the belt is connected to?


... Vacuums

I have a Series G Kirby Model G7D. The other day when I was vacuuming all of a sudden the TechDrive (Power Drive Assist N/D) pedal fell off. I see the hole that it goes into but when I put it in it's loose and falls out and doesn't control the power drive anymore. When I shook the vacuum I heard something rattling around inside the vacuum head. So I unscrewed the bottom and looked inside and found a small metal part labeled K3 on one side and T on the other side. It looks like it would fit


Hi, I have a Kirby G4 and i'v replaced the carbon brushes myself using a step by step guide however since its been back together it worked for about five minutes it then started sparking from the inside!!(a lot!!) I'v obviously touched something i sh ... Kirby Ultimate G Bagged Upright Vacuum

My electrolux epic series 6000 sr vacuum is not working. I was vacuuming when it shut off and the bag light came on. After changing the bag I tried turning it on and the question mark light comes on instead of the vacuum. What does this mean? How can I fix this?


... Vacuums

The brush on my Hoover Windtunnel T series won't turn when I'm vacuuming carpet. It does, however, turn when I'm vacuuming bare floor, and I didn't think it was supposed to do that.


1) test the belt +brush for worn and replace2) test the motor God bless you ... Hoover WindTunnel TSeries Bagless Upright Vacuum Cleaner UH70107

I have a Hoover windtunnel T series. Model #UH70105. The system check indicator was almost red so I cleaned the filter. There are no clogs and it vacuums fine without the hose, but when I go to use the hose there is very little suction and all the vacuum dust flys out of the end the hose piece fits into when not in use. Can you please tell me what is wrong?


... Hoover Vacuums

I have a Eureka Upright vacuum (4800 Series). When I try to start it by turning the switch on, it wont. For few days, I was able to get around this problem by repeatedly turning the switch on and off until it turned on but that does not work any more. Could it be something related to the switch it self or the power cable. My wife mentioned that one of my kids might have pulled the power cable too hard (at the back of the vacuum). Any help to solve this problem will be very much appreciated. Tha


... Eureka Smartvac 4870 Bagged Upright Vacuum

How to fix my rainbow vacuum cleaner - Rainbow E series Canister Wet/Dry Vacuum


We need more information on what the problem is. Give us a call and speak to a Rainbow Specialist. We have pickup service at your home the next business day at not charge.RainVac ... Rainbow E series Canister Wet/Dry Vacuum

I have a simplicity 6 series vacuum. the bag overfilled and vacuum will not run. No power. is there a fuse of relay inside the unit?


No just on /off switch and direct power to vac motor sounds like its burned up from bag being overfilled , now you have to get to the vac motor test it with switch on to see if its getting power if so then motor is burnt.use an ohms meter for power t ... Simplicity 7250 Deluxe Vacuum

Hoover windtunnel t series vacuum won't turn on. power source has been checked so it's something with the vacuum


... Hoover Vacuums

I have a Hoover Tempo plus attached tools vacuum cleaner, 12 amps, Model #S2541, Series J3.6 and I do not have instructions on how to use it. Can you e-mail me the instructions for this vacuum cleaner? Thanks!!!


... Vacuums

Wind tunnel t series vacuum won't turn on - Hoover WindTunnel TSeries Bagless Upright Vacuum Cleaner UH70107


I had the same problem and used a tool to clean out the suction tube on my Windtunnel Series T. It was full of junk packed in tight. After cleaning it out there's no more turning off or overheating. It actually works better than when I first got it ( ... Hoover WindTunnel TSeries Bagless Upright Vacuum Cleaner UH70107

Do i need a special hose to vacuum up water? - Rainbow E series Canister Wet/Dry Vacuum


Yes. You need a non-corded hose so there is no power running through it when vacuuming up liquids. ... Rainbow E series Canister Wet/Dry Vacuum

Now that I just fixed my Lux Legacy canister vacuum, I need help on my other Electrolux Regency Series upright! The vacuum works fine but the rotating brush does not work and the brush motor does not turn on. Tried cleaning the brush and hitting hte reset button to no avail. This upright has a triple setting switch and I checked the each of the wires seem to be attached. Tried rotating the brush by hand and it would not budge. Was going to "encourage" the brush to turn with a set of articula


There are a couple rectangular holes on the bottom of the power nozzle, beside the wheels. These have tabs in them that need released with a standard screwdriver. \015\012 ... Vacuums

Is there a diagram/picture to help me visualize how to put cleaner belt back in vacuum? I was taking base of vacuum apart so I could get rid of hair that were wrapped on the roller. The cleaner belt came to loose and I could not figure how to fix it back. the model is eureka upright bagless series 430


Hi,Sorry to hear your belt fell out. Not good if you've never replaced a belt before...Here is a website where you can read a detailed description of how to change a belt: http://www.ehow.com/how_8034505_eureka-belt-replacemen ... Eureka 431A Optima Bagless Upright Vacuum

Rainbow E Series Vacuum - Vacuums


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=767132\015\012Generic problem for all Vacuums\015\012Rainbow E Series Vacuum\015\012Posted by bekahness ... Vacuums

Vacuum is plugged in but won't come on - Rainbow E series Canister Wet/Dry Vacuum


See if you are getting 120Vac to the main on off switch with respect to ground.\015\012\015\012Sometimes, the plug end's have a fuse melded in to the plug in and can only be replaced.\015\012\015\012Check to see if the bag, if ... Rainbow E series Canister Wet/Dry Vacuum

HOW REPLACE SWITCH ON RAINBOW E2 SERIE - Rainbow E series Canister Wet/Dry Vacuum


... Rainbow E series Canister Wet/Dry Vacuum

How to maintain up keep on my rainbow vacuum - Rainbow E series Canister Wet/Dry Vacuum


Keep the bottom clean, make sure the rubber seal in the bottom doesn't start to crack and every 10 years or so replace the brushes.\015\012\015\012I wrote a tutorial on how to take apart an E-Series rainbow. \015\012\015\012 ... Rainbow E series Canister Wet/Dry Vacuum

Should the arrow point in towards vacuum or out on the replacement exhaust hepa filter for my kenmore prgressive 400 series vacuum?


I'm assuming the arrow you are referring to is on a new dust bag. If that's the case, the arrow should be pointing down toward the bottom of the machine.Jim Hart ... Kenmore 34613 Bagged Upright Vacuum

Rainbow E-series will not turn on - Rainbow E series Canister Wet/Dry Vacuum


Hi, there is no reset button on a Rainbow vacuum. There is a safety switch on all E series and E2 series Rainbow vacuums, that keep it from running without the water basin on it.If you have any more questions let me know. I am a Rainbow s ... Rainbow E series Canister Wet/Dry Vacuum

Rainbow vaccuum e series will not turn on - Rainbow E series Canister Wet/Dry Vacuum


Most likely the motor is dead, or the switch is bad. ... Rainbow E series Canister Wet/Dry Vacuum

Manual for e2 type 12 rainbow vacuum - Rainbow E series Canister Wet/Dry Vacuum


... Rainbow E series Canister Wet/Dry Vacuum

I have a rainbow e series vacuum cleaner that quit working while vacuuming and will not come back on. I know there is a reset button on the wand sweeper but I was not using that attachment when it sh


<p>If you have the <a rel='nofollow' href="http://www.rainvac.com/rainbow-vacuum-parts">eSERIES</a> single speed model, then it could be the <a rel='nofollow' href="http://www.rainvac.com/motor-rainbow-120v-e">motor</a> ... Rainbow E series Canister Wet/Dry Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0846 seconds