Having problems with your Rainbow E series Canister Wet/Dry Vacuum ?

Rainbow se trying to fix

\015 The silver disks or fans how do they go back together\015

Answers :

Small red washer on top - motor is the top. Also on only everyother fan spins.
\015\012Small fan with the small hole up
\015\012Barrel Spacer
\015\012Large Fan with the the hole down
\015\012Hour Glass spacer - this spacer has a washer welded to the bottom of it - spacer down!
\015\012small fan hold down.
\015\012Lower motor housing
\015\012
\015\012Hope you changed the bearing while you were where here.
\015\012
\015\012Give it a spin by hand and make sure there is no grinding.
\015\012
\015\012Hope this is right, doing it from memory, have a picture at work.
\015\012
\015\012Good luck
\015\012
\015\012M
\015\012
Repair Help & Product Troubleshooting for Rainbow E series Canister Wet/Dry Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My rainbow wont start. When I try to turn it on it makes a beeping nose and then nothing. How do I fix this? Or what could the problem be?


Most likely your controller is bad. Give us a call and we can see if you are still covered under the warranty.RainVacwww.rainvac.com800-523-0510 ... Rainbow E series Canister Wet/Dry Vacuum

Rainbow se trying to fix


Small red washer on top - motor is the top. Also on only everyother fan spins.\015\012Small fan with the small hole up\015\012Barrel Spacer\015\012Large Fan with the the hole down\015\012Hour Glass spacer - this spacer has a w ... Rainbow E series Canister Wet/Dry Vacuum

My rainbow wont start. When I try to turn it on it makes a beeping nose and then nothing. How do I fix this? Or what could the problem be?


I am having the same issue did you ever get an answer of what the problem was? ... Rainbow E series Canister Wet/Dry Vacuum

My Rainbow SE vacuum was working fine until I ran over the edge of a rug and it went in to the nozzle. I immediately switched the vacuum off and proceeded to move the rug. When I tried to turn the Rainbow back on the brush was no longer spinning. I've tried the reset button and checking the nozzle for any debris, there are none. The brush just won't spin.


Hello lilbutmunch1,\015\012The brush is motor/belt driven so you probably either broke the belt or it shifted off the motor or brush shaft. I suggest you unplug it,flip it over and look for screws that hold the baseplate together.. remove those ... Rainbow E series Canister Wet/Dry Vacuum

Hoover upright 2000w, HL2005 001 problems:the hoover made a pop sound & turned off. Tried leaving it for 30 mins as suggested in the manual but it still won turn on. Really cannot afford to buy a new 1 & would like to fix it. partner is an electrician so if we have some guidance as to what the problem may be i am confident we can fix it. the hoover is only 18 months old so not very old at all.


... Vacuums

I HAVE A BISSEL 5200 FLIP IT AND WHEN CLEAN WATER TANK IS ON THE MACHINE AND IT IS BEING USED AS DRY VAC ALL THE SOLUTION LEAKS OUT. I TRIED TIGHTENING THE CAP , I CHECKED FOR CROSS THREADING , I HAVE TRIED EVERYTHING I COULD THINK OF THAT IT COULD BE NOTHING FIXED IT. MY FRIEND HAS ONE AS WELL AND HERS DOES THE SAME THING. IS IT A MANUFACTUER DEFECT?


Yes, they pretty much all leak, that can be chalked up to lousy manufacturing. Sorry. ... Vacuums

Now that I just fixed my Lux Legacy canister vacuum, I need help on my other Electrolux Regency Series upright! The vacuum works fine but the rotating brush does not work and the brush motor does not turn on. Tried cleaning the brush and hitting hte reset button to no avail. This upright has a triple setting switch and I checked the each of the wires seem to be attached. Tried rotating the brush by hand and it would not budge. Was going to "encourage" the brush to turn with a set of articula


There are a couple rectangular holes on the bottom of the power nozzle, beside the wheels. These have tabs in them that need released with a standard screwdriver. \015\012 ... Vacuums

I have had my Black and Decker Crush Master blender for years and have been happy with it. I made smoothies a few days ago and smelled a funny smell. I turned it off, but when I tried to turn it back on it didn't work, I even tried to plug it up in another socket, but it still didn't work. Is my blender beyond fixing?


Sounds like death to me,. you could take it apart to look see to be sure, what do you have to loose?Best regardsCk ... Vacuums

We bought a new home in march. It is a brand new home, with brand new First Alarm smoke/CO detectors. The very first night, we noticed the iving room (main) smoke alarm was "chirping". So we tried to replace the batteries, but when we did, all of the smoke alarms started going off (they are hardwired). We took out the new battery & dealt with the chirp. It is getting to be too much. So we are trying to fix it, but everytime we replace the batteries, the alarms are silent for a little bit, & then


... Vacuums

I have a Wertheim 4808 Barrel vacuum cleaner that has suddenly stopped working. I believe that there is a problem with the electrical cord connection inside. I have tried unsuccessfully to open the compartment that leads to that area. One side unscrewed with a phillips head screwdriver but the other side seems to have a different type of fixing screw that I am unable to undo. It is awkward to get at and in a deep slot and the head of the fixing screw? is not visible.


... Vacuums

Am i going mad? I've just brought an electrolux Cyclone Ultra 2000W hoover. I've got it out of the box and have tried to fix the cover to the unit (i.e the bag free area which collects the dust). It won't fit. I've tried everything and think it must be faulty. Has anyone ever come across this before? Grrrrrr.


Take it back to the store and compare it to another one, and possibly have a store manager help you, if they can't get it, then they should give you a different one and make sure that it will work before leaving ... Vacuums

Hi all, I have a Janome 234D overlocker and when I try to sew with it, it misses stitches. What could be causing this problem and how do I fix it? I tried rethreading,checked the tension and stitch length dials on the side and I dont have a manual for any instructions, help is desperately needed, regards Wendy


... Vacuums

I have a Miele S5980 vacuum cleaner, and recently had to change the Hepa filter. After doing the change, I tried resetting the reset button to switch off the Hepa filter indication light and it would not switch off. After a few tries, I accidentally depressed the switch, and it has dislodged from its cradle. Help, what can I do to fix this?


... Miele Vacuums

How to fix my rainbow vacuum cleaner - Rainbow E series Canister Wet/Dry Vacuum


We need more information on what the problem is. Give us a call and speak to a Rainbow Specialist. We have pickup service at your home the next business day at not charge.RainVac ... Rainbow E series Canister Wet/Dry Vacuum

I have singer fashion maker 2818. The problem is the bobin casing (the one which holds the bobin)is coming out (i.e) loose. trying to fix it in place but not sucessful. can someone explain how to open and fix the case and place the other supporting covering so that there is smooth motion of the needle and the bobin.


... Singer Vacuums

My vacuum just stopped working, so I don't know what the problem is. I used it in the kitchen to vacuum the hard wood floor. I turned it off, and a few minutes later, turned it back on to finish vaccuuming the kitchen floor. It just would not turn on. I had not unplugged it or did anything to it. I then tried to see if it would work in another plug, and no luck. I'm trying to figure out if it can be fixed or if I need to look for a new vacuum.


When I get most Vacuums that have dies on people most of them the wire has been worn and cut one or more wires on the plug cord. Sometimes the cut can be over looked. Please unplug and check the wire carefully.Also please post the make model a ... Kenmore 23913 Progressive PowerMate Bagged Canister Vacuum

The top of my rainbow is broken can it be fixed?


<p>Yes, the early version eSERIES on the <a rel='nofollow' href="http://www.rainvac.com/cap-cover-asm-120v-e">Cap Cover Assembly</a> was a disc that was glued into place. You can order the new design that is one complete piece so th ... Rainbow E series Canister Wet/Dry Vacuum

I need the manual for a 1988 Hino Rainbow CH160A With a : WO6E Hino Engine, I am trying to lean out the fuel mix from the injectors to compensate for a hydrogen conversion kit


Dear Conway sanhttp://vicbus.com/portfolio/hino-rainbow-ch160/Can't you get the manual in English from this Australian company since it seem ... Vacuums

I have a bissell healthy home vacuum and the roller bar on the base of it is not working. I have checked it for obstructions and it is clear. I have also tried reseating the canister and just about everything I can think of. It's almost like the switch that deterrmines whether or not the vacuum is in the upright position is broken and always says it is upright... any way to fix that? Thanks, Scott Hammersley


... Bissell Vacuums

Rainbow SE I turned the vacuum on and it worked to do one room Then I shut it off to wait until my husband got of his call. I realized that their was cloggage in the vacuum part that vacuums the carpet and unclogged it. I then tried to turn on and it was dead. I have the water filled just above the stick.


The clog may have over heated the motor, usually if you unplug it then after little while, try it again. If it still won't go, does the separator turn easily or is it bound up and won't turn. Take it off and see if the motor will run(without water) ... Rainbow E series Canister Wet/Dry Vacuum

Have a bissel proheat plus. There is no water flow. It has been used once,but was not flushed with water. Tried to fix it myself. Don't know if it is put together correcly. Or sommthing may be plugged up.


If the belts are new and it still doesn't spray then its probably a clogged heater core, it isn't easy to unclog so i would take it to a bissell repair center. ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Vacuum clogged Just had new carpet installed. In trying to vacuum the carpet for the first time, fine particles have clogged the sweeper. I'm using a rainbow sweeper with water reservoir.


If you are talking about the electric hose, try using your none electric hose with the crevice tool attachment to extract the particles from the other one. When using any of the hose please leave it running a few minutes to make sure everything in th ... Rainbow E series Canister Wet/Dry Vacuum

I have a sanyo performaX 900W UPRIGHT and in the last week i have not been able to get it to work anymore, ive tried different outlets and nothing at all happens, this occured just after i changed the bag Can you please guide me in how to fix this problem? does the vacuum have a hidden button inside somewhere?


... Sanyo Permax SC-A114 Bagged Upright Vacuum

We have a Hover F7411-900 which runs great but for some reason the wash does not dispense the cleaning solution. It works fine on rinse but not on wash. We tried cleaning the round piece at the base of the cleaning solution but that did not fix the problem. How can you repair so that the wash will work.


That would be the wash silonod, the thing that makes the soap and water mix together in order to make the soap come out at the bottom were the brushes are. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I have a Shop Vac (Wet/Dry) Model 5275 (120V 60Hz 6.4A), Peak HP of 2.75 While vacuuming the Shop Vac fell over, stopped working, and would not come back on again. Tried plugging into another outlet, etc., but nothing works. Is there some internal problem that I can fix myself?


... Shop Vac Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0355 seconds