Having problems with your Rainbow Technologies D4 Bagless Vacuum ?

I would like theexpertman for rainbow sweepers to tell me how to replace the power switch in a d4

Answers :

I have been off line. Do you still want a walk through on this procedure.
Repair Help & Product Troubleshooting for Rainbow Technologies D4 Bagless Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I would like theexpertman for rainbow sweepers to tell me how to replace the power switch in a d4

I have been off line. Do you still want a walk through on this procedure. ... Rainbow Technologies D4 Bagless Vacuum

Replace the rainbow d4 switch

... Rainbow Technologies D4 Bagless Vacuum

Replace on/off switch on rainbow D3 vacuum - Rainbow D3 Canister Vacuum Cleaner Power Nozzle Reset Switch Vac Cleaner Power Nozzle Reset Switch

... Rainbow D3 Canister Vacuum Cleaner Power Nozzle Reset Switch Vac Cleaner Power Nozzle Reset Switch

I Have two questions concerning my AIRVAC AV2500 Red Series Vacuum System. How do you replace the light in the floor power head sweeper and can you replace the permanent fabric filter? We had the system installed in 2004 and the light in the sweeper head just went out and can not find any manual on line on how to replace it. The filter if not torn but avter 6 years it probably needs some kine of cleaning or replaced even though it says permanent. Any help would be appreciated. Jim McCluskey

... Vacuums

Rainbow D4C power switch replacement

As far as I know, that switch with 6 terminals is still available. But if not, I would wire the 2 for the power head and the 2 motor wires together. Then you would have 4 leads to attach. ... Rainbow 75th Anniversary Canister Vacuum

The battery will not charge in the sweeper. I can remove the battery and wire it to the power supply for charging and it will charge up and run the sweeper. So the power supply and the battery are both good. Obviously there is a circuit failure in the on board charging control. Anyone know a fix or a likely faulty component? I had a shark handheld about 8 years ago and it developed the same problem. I examined the little circuit board inside but saw no visible indications that would isolate t

... Euro-Pro Cordless Bagless Upright Sweeper - Blue/Gray

My electrolux ambassador power wand quit working. I replaced the switch that shuts it off when the roller stops, but it wasn't the problem. The on/off switch is fine, the motor is fine. We have traced the problem to the wires inside the canister by opening the inside cover to the bag container. We see the power cords going into the canister but we're not able to get to anything. We can't find any screws to undo that would open it up in order to follow the wires deep into the canister. We've bypa

... Electrolux Vacuums

My power nozzle has stopped working. The vacuum itself is still working but not the power bar. I would like to order a power nozzle. Can you tell me how I can order a nozzle for a Kenmore Whisper Belt 12.0 amps

... Kenmore 23313 Whispertone Bagged Canister Vacuum

When connecting the wand into the brush component. sporatic power (sometimes runs sometime nothing) the power is on again off again. when hold pressure down on the wand the power stays on. do you think the coupling connection is bad on the wand? would the wand replacement likely be the culprit?

There is is switch or sensor in the connection. Likely that piece is worn or shorted out. You may be better off getting a new wand piece ... Kenmore 23913 Progressive PowerMate Bagged Canister Vacuum

I replaced the motor on shopvac model 92L625A and a little black plastic piece fell out between the switch on top and the actual rocker switch. I would like to know how toput it back together properly because it keeps falling out. Can you help or send a schematic?

... Shop Vac Vacuums

My Vacuum just stop working. I was cleaning my car carpets when it just went off. I tough it got disconnected from the outlet (power supply). The vacuum was connected and it is like when a fuse go bad, just like that it won't turn on anymore. Is there a switch that needs to be reset or a fuse to be replace? How do you do it?? Thanks

There is not any of that. Buy a new one ... Hoover Empower Bagless Upright Vacuum

I have a Dyson slim DC18 all floors, the power switch is bad it won't stay latched I would like to get 2 of the switches. Dyson 18 s/n 334-US- A 26163 Nelson LePla 5495 S.Fordney RD Hemlock MI 48626

You can order the switch from the following sites. According to the first site, the DC17 and DC18 switches have the same part number, so I'd use the second site. It costs less. I didn't check the shipping costs, though.\015\012 ... Dyson DC18 all floors Bagless Upright Cyclonic Vacuum

I have the new power on/off switch to replace the old one(Rainbow vacuum). However the new switch has 4 contacts & the old one has 6. Need wiring diagram.

Simply pair 1 each of the power head leads and motor leads on to one terminal and wire the cord as on previous switch. ... Rainbow E series Canister Wet/Dry Vacuum

The power nozzle on my c141b model aerus electrolux canister vaccum no longer turns on. It was working when a large stringy object was sucked in. When hitting the red reset button, nothing happens. Is it likely that it is the fuse that needs to be replaced? All wires appear intact (I replaced the elbow assembly a few months ago.), and the sweeper moves freely.

It's not a fuse.\015\012Turn the power nozzle on it's top. Try to rotate the brush. If it won't spin, there's till something holding it. Remove all strings, threads, and whatnot from the roller. Try to rotate it again. If it still won't sp ... Vacuums

I have a Shark sweeper Model # V1900W would like to know how to get replacement parts. The rubber sweeper on the under side is coming apart and is interfering with the operation.

... Euro-Pro S3325 Handheld Steam Vacuum

Have an e-series rainbow. Belt and brush bar have been replaced in power head. But the red reset button can still be pushed and it is not staying going like it should. May it be the motor?

... Rainbow E series Canister Wet/Dry Vacuum

I had to replace the handle. The wiring is inside the handle. I would like to verify the position of all the switches and the location of a spring that fell out.

Dear Heidimtaylor,\015\012\015\012For this first we will required your model no. I will advised you too visit the following site and search for your model's service manual. It contains details which you required. Following link will help you... ... Vacuums

My Rainbow E2 has been working great for years now, but recently it has stopped working on the vaccuuming setting, but will still run on the low speed air cleaning setting. I hope it is something as easy as replacing the switch. Would appreciate any tips to determine if that is the issue or possibly something larger. Tks in advance for the info/help.

Still need help, let me know.\012\012Thank you,\012Ralph ... Rainbow E series Canister Wet/Dry Vacuum

I have a Rainbow E2 series, 23, for about 3 years. It has now a different and very aloud sound coming fron around the motor and also I feel it is not suctioning with the same power. If I close the hose like closing totally the suction entrance, the sound comes normally. I will appreciate if some one can tell me what to do, becouse there is not a Dealer in my Contry any more. Thank You. Pierre Chabaneix - Lima-Peru [email protected]

Hi there, Pierre!\015\012Sorry, but I think this is bad news. From your description, I suspect that a motor bearing has failed. The only way to fix it is to replace the motor, and without a dealer in your country, that could be a big problem.\015\012 ... Rainbow E series Canister Wet/Dry Vacuum

Wiring diagram for Model #11635922500 - KENMORE Upright vac I took the cover off of the vacuum to repair the power cord and must have pulled a wire out of its wire nut by the sweeper bar. If I had a diagram it would be no problem to replace. The bad has four short gray wires coming out of it. It is one of the gray wires that has come loose.

... Kenmore Vacuums

Have a rainbow e series with 2 speed motor replaced motor with another now after 5 minutes on the vacuum the motor cuts off intermitently like a power surge. all the connections and wires have continuity any ideas???

... Vacuums

Rainbow mod. D4C have new on /off switch, 2 black, 2 blue wires. need to connect power cord, motor and carpet sweeper?

Are the wires still attached to the old switch? If they are, hook them up to the new switch in the same, physical way. If they aren't attached, you might take it into a vacuum repair shop- they could probably help you figure it out, if you bought ... Rainbow Technologies D4 Bagless Vacuum

The on/off switch on my kirby g-3 vacumn needs to be replaced I would like to know the best procedure.

Get the parts ... locally or at some place like Repairclinic.com then set aside a Saturday afternoon in a quiet place with screw driver, pliers and a box of band aids and go to it.\015\012\015\012Repairclinic.com will also provide you wit ... Kirby Generation 3 Bagged Upright Vacuum

I need to replace the power cord on my Eureka 2271, and would like know how to get into the connections?

... Eureka 2271 Bagged Upright Vacuum

How do you replace th power switch on a bissell model# 6594 pictures or diagrams would be great

... Bissell 6594 PowerForce Bagless Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0900 seconds