Having problems with your Roomba 415 ?

How do I install filter in Roomba 415?

\015 Since I cleaned the filter I can't get it back in the machine. When I do have it in, it runs eratically like it is bumping into things. It seems to run fine without it.\015

Answers :

Repair Help & Product Troubleshooting for Roomba 415

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do I install filter in Roomba 415?

TRY this linkhttp://www.irobot.com/images/consumer/cs/097.06-Roomba-Gnrc-Manual.pdf ... Roomba 415

How do i install the FilterQueen Genuine Filter Queen High Density Silencing Foam Filter Bat

... FilterQueen Genuine Filter Queen High Density Silencing Foam Filter Bat

No vacuum My Floormate has plenty of air moving, but no vacuum at the nozzle. When I turn it on, the filter hops up to the black rubber "intake", rather than staying in its spot. It seems to me that the intake should be in contact with the filter when the reservoir is installed. And I don't understand why the intake isn't closer to it, but it seems fixed there, almost an inch higher than the filter. When I remove the bottom reservoir and turn the h3000 on, I feel vacuum at the intake, and air

Someone must have lost the filter cover from the machine. It is a clear blue plastic cover that goes over the filter and has a hole that lines up with the motor intake. It is approx. 3 inches square and has an angular top to coincide with the motor i ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

How to change f 17 filter kone? i bought the display model and i don't have the instructions. it spits dirt everywhere when i use it, so i assumed there was no filter, ordered f17 filter but now have no idea how to install it or where to???

... Dirt Devil Kone Cordless Bagless Handheld Vacuum - Pink

Roomba works but the dirt stops at the filter. New filter did not help.

The robot dirt tray has a vacuum motor to assist the dirt flow from the floor brushes. Yours is not working. recheck the connections on the dirt tray. ... iRobot Roomba Discovery SE Bagless Robotic Vacuum


Check your hose for a clog, id even check from where brushroll is at bottom to the end of hose. sounds like that could be your problem. ... Electrolux Vacuums

Need directions on how to remove old cotton filter and install new one and same for HEPA filter on Nilfisk GM/GS 80.

This link should help:http://www.fixya.com/search.aspx?cstm=0&_s=Nilfisk+GM%2FGS+80+instruction+manualJim ... Nilfisk Family Vac Bagged Canister Vacuum

Installing filter I took the filter out and can't figure out how to put it back. How does it go back in?

... Hoover Elite U5061-900 Bagged Upright Vacuum

My shop vac is plugged. The hose is clear. The filter is removed. The filter bag is not installed. It still won't draw a suction. It sounds like it is plugged. The motor whines at a higher-than-usual pitch. What can I do?

Turn off the vac, take the head off of it and remove the filter paper. Inside, there's a white ball (bigger than golf ball, smaller than baseball) that's inside a cage. This is designed to keep water out of the blower when the vac tips over, and sh ... Vacuums

I Have two questions concerning my AIRVAC AV2500 Red Series Vacuum System. How do you replace the light in the floor power head sweeper and can you replace the permanent fabric filter? We had the system installed in 2004 and the light in the sweeper head just went out and can not find any manual on line on how to replace it. The filter if not torn but avter 6 years it probably needs some kine of cleaning or replaced even though it says permanent. Any help would be appreciated. Jim McCluskey

... Vacuums

Roomba Scheduler Hi, my roomba scheduler is wobbling back and forth then stopping after a few minutes. It beeps "uh oh" and the orange status light comes on. I've cleaned every part I can think of or read about. I've replaced all the brushes and filters. Any suggestions?

... iRobot 4296 Robotic Vacuum

How do i install a filter on a eurika optima upright model 431? I was given a filter model hf-7 and was wondering how it would fit.

Hi nena,The hf7 model is not made to fit the 431 series.I believe I can find the filter and instructions for you if you give me the entire model number.The 431 series include several models.Do you have your i ... Eureka Vacuums

Nikken Air Purifier, Model NKAP100: Change Filter red indicator stays lit after new filter has been installed

Under the front panel, under and to the right of the control panel is two holes, one the size of a pencil eraser and below it is one the size of a dime. In the hole (the size of a dime), is a pin hole use a paperclip and poke the hole. It will reset ... Vacuums

Kenmore Elite 721.66463500 Microwave died. Didn't even notice until I went to use it. Changed fuse and screen asked to enter the time of day. Entered the time and hit start. The microwave buzzed for 0.5sec and it blew the new fuse I installed.. put in another fuse and the same thing happened.. I measured the resistance in the noise filter. Results: L1-L2 < 1ohm N1-N2 < 1ohm L1 or L2 - N1 or N2 = 0ohms I'm thinking I need a new filter but I also was unable to measure any resistance o

... Vacuums

My eureka smartvac 4870 has no suction at hose or floor. all hoses are clear, filters clean and properly installed. bag not full and properly installed

Your eureka has no suction kuz the vacum hose needs cleaning ... Eureka Smartvac 4870 Bagged Upright Vacuum

I can't get the filter door to shut after installing a new generic filter.

Is there one of the attachments (If this unit stores attachments under this door?)-- is one of the attachments just a little out of its 'proper' spot?Sometimes generic filters need to e trimmed down, to fit better than manufacture specifi ... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

I have a Shop vac model 90L550A wet/dry vac. Do I remove the cartridge filter when I install the disposable filter bag?

... Shop Vac 925-09-62 QSP Plus Wet/Dry Vacuum

I purchased a bissell model #6583 and it did not have a owners manuel and i am confuded about the filter instalation can you show me where to get this on the internet for free since it should have been in the box upon my purchase,(and was not there!) I feel I have already paid for it once,and some what cheated, or at least e-mail me the instruction part of proper filter use. Thanks, Shirley

Go to http://www.bissell.com/powerforce-bagless-vacuum/. On the right side of the page, under "Downloadable Documents", click on "User Guide - English". ... Bissell Vacuums

Installation of a Dyson filter

Hi Nancy.\015\012\015\012Thre are 2 filters on the DC4.\015\012The first is A one piece filter which colud just be circular pad or purple plastic hepa filter this filter fits directly on top of motor.\015\012To fit this remove ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

How do I install height adjust cable on roomba 415?

... iRobot 4150 Roomba Vacuum

Roomba dirt in filter but NOT in bin

Possibly the vacuum fan is plugged up or not spinning fast enough to pick up heavier items. disassemble the back canister and clean the fan chamber.(THis is one area of regular maintenance). if it is all clean then try to replace the motor. The other ... iRobot Roomba Discovery SE Bagless Robotic Vacuum

Installing cloth bag filter on Hoover S2571

... Hoover S2571 Quick Broom Bagless Stick Cyclonic Vacuum

Install filter on shop vac H875550A portable wet

... Vacuums

Owners manual's for installation of the two filters

Sponge side faces out ... Kenmore Vacuums

Install hepa filter

... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0389 seconds