Having problems with your Roomba Generic Discovery 400 Series Replacement Battery, Fits P ?

Connector broke off motherboard roomba 400 series. how do i fix it

Answers :

Replace the motherboard if you are a handyman.
replace the connector if you know how to solder
Repair Help & Product Troubleshooting for Roomba Generic Discovery 400 Series Replacement Battery, Fits P

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Connector broke off motherboard roomba 400 series. how do i fix it

Replace the motherboard if you are a handyman.replace the connector if you know how to solder ... Roomba Generic Discovery 400 Series Replacement Battery, Fits P

Roomba Stops I've had a Roomba for about 2 months. Lately, it runs for about 45 secs, then stops, makes a two-tone (descending) sound, and flashes the CLEAN button while the STATUS button is red. I've emptied the dustbin on it. Can you help? I am seeing the same problem on my roomba today. I cleaned all that I could., the brushes, the pins on the sides and all that and it still gives the same problem..Any other fix?

Run your roomba through a self diagnostic test. I have posted the link below. Tell me your findings.\015\012\015\012\015\012http://mysite.verizon.net/gsplews/Diagnositic-Tests_Proc.v.0.5.htm ... iRobot Roomba 4210 Bagless Robotic Vacuum

My roomba pro elite just goes around in a circle. how can I fix this? I have cleaned the roomba as thoroughly as I can. Could it be a recently changed wheel tread?

The infrared sensor circuit has failed, u will need to have it repaired ... Roomba Pro Elite Bagless Robotic Vacuum

Roomba 595 black carpet fix - Roomba Vacuums

... Roomba Vacuums

Brushes won't fix back into holder without being forced, so Roomba clicks when it runs. It will only run a little while and then stop and say to clean Roomba's brushes.

It sounds like you didn't clean the bearings. On one end of each brush is a bearing, probably in a yellow housing. Pull the bearing off the axle, and you'll find it's full of hair underneath.Obviously, the brushes should turn freely and s ... Roomba Vacuums

It no longer stands upright as a 1 inch piece of arched plastic broke off. Is there a replacement part? what does it entail to fix it? Is it worth fixing?

Mine did the same thing.To date I have yet to find a replacement part.I do not think it is all that important either.And most likely not worth your time. ... Vacuums

Fix roomba 550 charging error 3 - iRobot Roomba 550 Vacuum

... iRobot Roomba 550 Vacuum

How to to fix censores in roomba scheduler - iRobot Roomba Scheduler 4230 Bagless Robotic Vacuum

... iRobot Roomba Scheduler 4230 Bagless Robotic Vacuum

Roomba 770 fixes - Roomba 770 Robotic Vacuum

... Roomba 770 Robotic Vacuum

Roomba 595 black carpet fix - Roomba Vacuums

... Roomba Vacuums

Roomba's deck height adjustment string broke

You can solve this problem if you are on the handy side. I had the same problem and fixed it, allowing Roomba to live until getting an all-too-characteristic fatal brain problem later.\015\012\015\012You have to open up Roomba and guage t ... Roomba Robotic Floor Bagless Vacuum

Belt broke how do i fix it

To my knowledge model F7220900 SteamVac doesn't require a belt. Are you sure that is your model? If you have a different Hoover model you can get a replacement belt here: h ... Hoover F7220900 SteamVac V2 Upright Vacuum

My Roomba no longer cleans the entire room. Rather, it spins in circles and then turns itself off. Is it possible to fix this?

Ah yes. You, or rather your Roomba is experiencing what is commonly referred to as the "Roomba Circle Dance".This is caused by the a sensor called the "Optical Encoder".The image is a before and after cleaning of this sensor. This will re ... iRobot Roomba 560 Robotic Vacuum

I have an older model roomba 400 series. It was running fine until it hung itself on a power cord. Now it sits there with the clean button flashing orange. How can I fix this.

... iRobot Roomba 410 Robotic Vacuum

We have a Hoover F7222900 and need a waste water tank latch that broke. I think the item number is 39457068, but not positive as no photograph was available in parts manual. Can this part be purchased or fixed. Causes a lack of vacuum. John

Http://www.usavacuum.com/Hoover-Steamvac-s/291.htm ... Hoover F7222-900 SteamVac Upright Vacuum

Bissell Powersteamer 1694W won't extract water from carpet. Was extracting fine until the pump/brush belt gear broke off off the pump. I repaired the gear with super glue and the brush is once again working fine. I now have an extraction problem. What did I do wrong? I took it apart and was so proud of myself when I fixed the original problem. Now I'm lost.

Check your re-assembly.\015\012\015\012Have you missed a pipe connection somewhere? ... Bissell Powersteamer 1694 Upright Vacuum

Roomba turns in a circle then stops gives seven beeps when I press the button I have checked the wheels where can I get it fixed?

... Roomba Robotic Floor Bagless Vacuum

How do I fix the dirt fan on a bissell style 2 model # 3512-R? It broke in half and fell off.

I also have the same problem with my 3912-9 model. The fan is broken and I cannot find another one. I have looked all over but the ilustrated parts breakdowns that I have found only shows the motor and not the fan that is attached to the motor. All I ... Bissell 3594 CleanView PowerTrak Bagless Upright Vacuum

Power Issue Hi...my Miele vacuum cleaner (S314) will not turn on, unless I lean it on its side (the side that the power switch is on). I took it apart and the wires are all well attached, and I do not see any issues with the connectors. Is this a common problem with an easy fix? Thanks! Todd

Could be the cord reel causing the problem. Sometimes the contacks on the inside of the reel loose contact and won't conduct. If this is the problem, then you will have to replace the reel cord asm. Part # 06777540, may cost about $150 approx. ... Vacuums

Houver Cleaner My self propelled windtunell baged Vacumn has a broken belt. The small visible one that is visible is intact. This is the thick belt. I cannot for the life of me figure out what to open and how to replace it. The model # is U6 401-9RM I keep asking for a manual online but it doesn't recognize this number. I am 67 yrs old broke and fix it challenged..lol can you help me?

Take off the bottom plate, The flat belt ges around the motor shaft and then around the bigger pulley by the V belt. It will stretch to o on.\015\012\015\012 ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Broken hose The hose on my Hoover F5837-900 Steam vac Supreme broke away from the coupler on the bottom of the unit - under/behind the recovery tank (solution tube is till attached). It might have gotten pinched in there a couple times. Problem - it was glued in the coupler really well, and I cannot get the whole thing out - hose will be too short anyway - is there a way to fix this or a part I can order instead??

You will have to replace the complete hose asm, part # 90001337 ... Hoover F5837-900 SteamVac Supreme Wet/Dry Vacuum

I brought an eureka model 2591av shapoo machine in 2004 I've only used the machine 4 times. now the it does not spray out the solution on the floor but it will **** up water, the vacuum part works. I took it to a repair shop, they said it was the pump that was broke and will cost $95.00 to fix. The purchase price of unit was only $129.00 My question to you is does that sounds like an honest or comparible diagnosis.please respond at ([email protected])

Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=559297\015\012Generic problem for all Vacuums\015\012I brought an eureka model\015\012Posted by wadda08 on Apr 3 ... Vacuums

End of power cord loose broke need to find a kirby store to fix

You dont need kirby just take it to a local electronics repair shop as we are all trained to fix simple cord and plug problemstake care ... Kirby Vacuums

How to fix error 3 - iRobot Roomba 550 Vacuum

... iRobot Roomba 550 Vacuum

I have a Filter Queen Majestic canister vacuum cleaner. At the end of the wand, a button to release the attachement not only broke, but also one eyehole on the wand where one nipple on the button falls into. So therefore a new button isn't going to fix the wand because there isn't a hole on one side of the area where the button falls in place for a nipple to secure the button in place. IS THERE A REPLACEMENT PART FOR A NEW SECTION OF THE WAND WHERE THE RELEASE BUTTON IS SECURED IN PLACE THAT I C

... Filter Queen Majestic Canister Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0336 seconds