Having problems with your Roomba Pro Elite Bagless Robotic Vacuum ?

Roomba left wheel too slow

\015 My old Sage's left wheel is much slower than the right one. I tried vacuuming it, also tried to dismount it, but I could not find anything wrong with it. I did not unscrew it all the way though (not sure how to do this). I saw how slower it is when I ran the tests 7, 8 and 9: left wheel much slower (and everything else fine). \015\012\015\012Any idea?\015

Answers :

Repair Help & Product Troubleshooting for Roomba Pro Elite Bagless Robotic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Roomba left wheel too slow

... Roomba Pro Elite Bagless Robotic Vacuum

Roomba circles My Roomba circles for a few minutes, then beeps 9 times and stops. A red exclamation mark appears on the left hand side of the controls. If you persist in restarting it, eventually I have been asked to clear Roombas wheels. As far as I can see, there isn't anything blocking the wheels.

Yes, this is known issue and if your bumper moves freely, you might be facing a sensor fault caused by poor quality of components.Here is a guide to fix ithttp://www.schneordesign.com/Avi/irobot/roomba_mod2.htmHave fun ... iRobot Roomba 560 Robotic Vacuum

The left wheel just stops working. - Roomba Robotic Floor Bagless Vacuum

You should take it back to the store ... Roomba Robotic Floor Bagless Vacuum

My Discovery 4210 Roomba will run normally for about 20 minutes on a smooth, wooden floor. It then begins the following sequence: run forward a few inches, turn in a tight counter-clockwise circle a few revolutions, stop, power off a few seconds, power up, repeat cycle from forward run. The sequence can be repeated seemingly endlessly if I don't turn off the power manually. I've replaced the motor, and led revolution sensor system on the left drive wheel. I've blown the dust out of everywhere. A

This robot vacuum has a electronic micro processor that controls the unit and tells it how to operate and where to go based on programmed parameters. It's quite a technical marvel. I have dropped a link here for contacting the company tech support li ... iRobot Roomba 560 Robotic Vacuum

My roomba won't go forward; it just rotates right ~90 degrees and then left ~90 degrees. I've cleaned the brushes, taken it apart and cleaned the brush gears, popped off the front wheel and cleaned the hair off that, taken off the front bumper panel and cleaned off the cliff sensors. Please help!

Compare your Roomba to the video on http://www.eesolutions.ca and look for the fix. ... iRobot Roomba 550 Vacuum

Roomba wheel -- stuck

I had a similar problem, I just took my Roomba Red apart and put it back together about four times before I fixed it.  In my case it turned out to be a dirty sensor, fixed as described at\015\012\015\012http://mysteryroad.blogs.com/photos/ ... Roomba Robotic Floor Bagless Vacuum

I have a 5260D Baby Lock Serger, which I had tuned up a year ago. I haven't used it very much since. When I took it in, and again now, it sews fine for awhile, then starts slowing down until it is barely sewing, even with the foot all the way down. The hand wheel seems very tight. - it doesn't turn freely, but takes a some push, like it is resisting a bit. Any idea what could cause this slow down and the tight hand wheel? I appreciate any ideas. Thank you. Maura

Hi,Since you say that you didn't use it for many years then does it make noise?If so it need oiling on its parts.oil orifice and point of contact.Please do rate the solution if the issue is resolved or post a comme ... Vacuums

Roomba wont stop going in circles,code 9 comes up, cleaned front caster wheel to no avail. 500 series roomba. called company said we need a new one, if this is the best we can get out of a roomba they are junk.

\015\012\015\012Your bump sensors are malfunctioning. The best thing to do is order a repair kit. I ordered mine from EESolutions.ca and it worked great.. ... iRobot Roomba 560 Robotic Vacuum

Roomba pro elite change drive wheels

Just click the below link...ur pro will be solvehttp://www.wikihow.com/Fix-a-Vacuum-Cleanerthanks for using fixya...rate tis solut ... Roomba Pro Elite Bagless Robotic Vacuum

Leaking from left wheel when applying trigger onmodel 7901

Sounds like a problem with the left spray nozzle, may be out of place. Either that or a line is loose and leaking. Either way you will have to pull the top housing off to check it over. ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Roomba stutters on one wheel causing it to quit

Try setting the Roomba on the floor, powering it up, pressing down hard on the front, just above the front wheel, and hitting "clean" or "spot." My Roomba had the same problem, and this seems to do the trick for it. I think it has something to do wit ... iRobot 4150 Roomba Vacuum

My Bissell Proheat left wheel cracked and I have a replacement wheel but can't figure out how to take it off. There seems to be no way to unscrew the bolt that is holding it on. Can you advise?

I believe it just pops straight out. Carefully pry it straight out with a screwdriver. It should snap back in ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

IRobot rumba 4000 seems to run ok and then starts making a kinda hi pitched growling noise and slows way down. it is very clean(blown clean with air compressor)sensors are clear ,newly installed well lubricated on ends of brush and beater bar, new battery. it seems like the wheel tracks may be dragging . i have cleaned and lubricated where i could on them but can't find a way to totally remove and inspect wheel tracks.

It sounds like your Roomba's brush gears are not working. Run the robot without the dust bin to see if the brushes are turning. If they are not, the robot will need to be replaced. Contact iRobot CS for support at (877) 855-8593. ... iRobot Roomba 4000 Bagless Robotic Vacuum

Roomba turns in circles going one direction and then another but can not go forward in a straight line. Aftter a few moments of going in circles, it cuts off and says inspect and clean roomba's wheels. We have done that 5 times and to no avail.

... iRobot Roomba 530 Robotic Vacuum

Will sew for 2-3 inches and then slows and stops. Hand wheel very stiff. End having to remove fabric and start over turning hand wheel until it loosens and then will sew for few inches and repeat the problem.

... Vacuums

Roomba goes in a circle moves about 5 inches and then turns in a circle again. It won't dock or go any farther than a few inches before turning in a circle again. The roomba has been cleaned inside and out. All hair and debri as been taken out of the wheels and brushes. i opened the case and cleared all the debri and i dusted the sensors in the front. Not sure what to do now.

... iRobot Roomba 550 Vacuum

My roomba pro elite just goes around in a circle. how can I fix this? I have cleaned the roomba as thoroughly as I can. Could it be a recently changed wheel tread?

The infrared sensor circuit has failed, u will need to have it repaired ... Roomba Pro Elite Bagless Robotic Vacuum

Roomba wheels not turning - iRobot Roomba 4000 Bagless Robotic Vacuum

... iRobot Roomba 4000 Bagless Robotic Vacuum

My Roomba 4210 plays the dead battery song 10 seconds after I press Clean, Spot or Max. But I notice that I can put my roomba in diagnostic mode (with brushes, wheels etc) for long periods of time with plenty of strong power. Why won't it clean for more than five seconds without that dreadful tune, flashing power light and an amber status light?

... Roomba Robotic Floor Bagless Vacuum

Hello, Last night my Roomba got stuck on a blind cord and now it keeps repeating Error move roomba to a new location and I've done it a dozen times, it still won't work. I've checked the wheels and are fine. What's wrong? Thanks

... Roomba Vacuums

Roomba stating inspect and clean wheels

... iRobot iRoomba 4000 Robotic Vacuum

Castor wheel on Roomba falls off

... iRobot Roomba 560 Robotic Vacuum

My roomba 4150 is running very slow. It is fully

May need to clean inside.the wheels pick up trash and deposit it on and near motors.also try to take ends of roller brushes off and clean hair ect. ... iRobot 4150 Roomba Vacuum

Front wheel problem

I would send it to protechrobotics. they will test all your components and let you know what needs to be done. if the repair is more than it's worth--they will help you out too.http://www.protechrobotics.com/ ... iRobot Roomba 4210 Bagless Robotic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0314 seconds