Having problems with your Roomba Pro Elite Bagless Robotic Vacuum ?
Very short vacuum cycle time.
\015 I recently replaced the battery, but the roomba still runs less than 5 minutes. I charged the battery 24 hours before using.\015
The charger sounds like its out take to service center.
Repair Help & Product Troubleshooting for Roomba Pro Elite Bagless Robotic Vacuum
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
My robot will not charge. Tried multiple resets and new battery from irobot.com (both suggested by Irobot customer service) but got nowhere. The vacuum did work for a short time (until the new partially charged battery ran out). If I bypass the internal charging circuits and charge directly from the charger (with jumpers) the robot seems to work fine. Unfortunatey, there is no mechanism to turn off the charge cycle, so this is not practical.
Replace the battery charger ... iRobot Roomba 4210 Bagless Robotic Vacuum
Very short vacuum cycle time.
The charger sounds like its out take to service center. ... Roomba Pro Elite Bagless Robotic Vacuum
Vacuum shots down after a short time, restarts but runs only a short time
Yes that unit has 2 sensors 1 on the motor and 1 on the relay board 1 of them is bad which is making the vacuum shut its like a heat sensors its malfuctioning it shuts the unit down ... Broan-NuTone VX550 Bagged Central System Vacuum
The last time the vacuum cleaner was used the outlet sparked causing it to smoke when turning on vacuum cleaner. I replaced the outlet and plugged it in and things seemed o.k. Today I turned on the vacuum, it stayed on for a mili second and went off. I checked the switch on the vacuum and it showed voltage coming and going, but would not turn on again. I checked all the wires in the area of the switch all seemed o.k. I thought maybe there might be a short in the cord. When I went to plug
... Sharp Twin Energy EC-12TWT4 Bagged Upright Vacuum
I just bought a westinghouse unplugged vacuum cleaner.( It is new) The design is awesome, and when it works it works great . But it has very short battery life. 1 battery lasts only about 5 minutes, and the other is even less. I did all the instructions told me as far as conditioning and charge yet I still do not get a very solid amount of vacuuming time. Is there any thing I can do?
Usually a short battery life means bad battries that aren't holding its charge. Being new I would think it would have a year's warranty on it. Find out who is the closest warranty shop and have them fix it. ... Vacuums
The motor is overheating and shutting off -- after vacuuming for a short time the vacuum motor shuts off
Sounds like there is a clog somewhere or a filter needs to be cleaned if it has one. Or the bag may need emptied.Jim ... Vacuums
I have a miele S4210 vacuum. It has a SAB100 accu nova battery brush which will not work. After charging the battery, light comes on saying not charged and now the power head brush won't turn. I had problems with my first powerhead so I purchased another and it worked for a short time and now I have the same problem again. I have four batteries I use interchangeably but nothing seems to work. I spent a fortune on this vacuum and to tell you the truth I hate it! Contacted Miele after 1st year of
... Miele S300 Bagged Canister Vacuum
I have a Dyson upright vacuum cleaner makes a helluva racket whilst in use. Called up Dyson and they told me to flip the floor/carpet knob 10 times back and forth. That did the trick for a short while and it started again. Continue attempts useing that technique does not work. I think in spite of the big bragging I see on the TV this guy braying about how superior his product is it is a piece of junk. I should have bought a Eureka or something, at least it would have been less expensive. I
Hi there,I'm sorry to hear you're having difficulties with your DC07. Your cleaner's brush control system is designed to make a ratcheting sound to warn you if the brushbar is jammed. Since you haven't been able to resolve your issue with ... Dyson DC07 Bagless Upright Cyclonic Vacuum
Electrolux vacuum mod c153c canister runs for a short time then turns off and after about 10-15 seconds it turns back on again.
... Electrolux Vacuums
Rain bow e series vacuum- will run for short time then shuts off
... Rainbow E series Canister Wet/Dry Vacuum
Could I have a short in my cord? I can vacuum & then when I move the canister it shuts off, if I wiggle the cord it will turn back on. This last time, it just revs like a car trying to start & then does nothing. I live in a VERY remote area (80 miles from nearest Wal-Mart or McDonalds) so I know I will not be able to find someone to repair this for me. I have great doubt that I will be able to do it myself & my husband is an accountant so he is unavailable for another 6 weeks!!!!! Any suggestion
Whit the vacume plugged in and turned on start where the cord goes in to it and hold the cord whith each hand and bend it slightly. Move up the cord and do the same if there is a brake in the cord the machine will loose power until you bend the secti ... Miele Red Star Bagged Canister Vacuum
I have a Z5930 vacuum and i want to trace an electrical fault. I need to disassemble it to get to the electrical connections and it is quite a tricky one to get in side. The machine will run and then cut out after a short time. It will then re-start in about 2-3 minutes and run normally again and so on. I was not able to give you the exact model but it is Ultra Filtration Oxygen line
... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum
While vacuuming, the unit will stop/shut down. A short time later the unit will operate again but not for much longer. All filters are clean/new.
Check your hose for a clog. It's likely there is a plug somehwere. Run it (not while vacuming the carpet) with all three filters removed. See if you get good suction. If not then look around for a plug of dirt and hair somewhere. ... Bissell 3750 Lift Off Bagless Upright Vacuum
My Kirby Heritage II vacuum is not picking up dirt up out of the carpet like usual, and I have to keep setting it lower to pick anything up. I finally get it to such a low setting that it starts sucking the carpet up and makes a whirring noise, and starts smelling. Every time this happens, we find the belt has been burned. We are wondering if the brush roll inside with the brushes that pick up dirt are worn out and too short?
... Kirby Heritage II Vacuum
Vacuum shuts off after short run time . it will turn back on after about 5 minutes but then dies again
Hi,\015\012 This is overheating and tripping the thermal cut-out on the motor.\015\012 You need to strip off all filters, clean or replace them (if caked solid). Very often panel filters can be cleaned by knocking them on an outside wall, ... Vacuums
Vacuum shuts down after a short time and needs to cool off before being restarted.
Trash it! ... Dirt Devil Reaction Twin Cyclone Upright Vacuum
Battery weaki after only a short time - Readivac 35145 Handheld WetDry Vacuum
... Readivac 35145 Handheld WetDry Vacuum
My handle won't go back up after an extended vacuuming session during which I used the hand/broom/animal hair attachments several times, thus pulling the hose out/putting it back in, starting/ stopping, and suddenly no matter what I do short of forcing it (and even if I try forcing it a bit) I can't raise the handle to put it away.
Do you know what model number Dyson you have? Is it the ball style one? Just find a similar product here on this page and let me know what model number is closest: ... Dyson Vacuums
Belts on my vacuum last only a short time, the keep getting chewed up. Seems that the belt does not align properly between the brush bar and the motor shaft.
The belt is either contacting the \015\0121. Check to see that the roller is installed properly (make sure it is not reversed and that it is all the way in).\015\0122. Check to see if there is any play in the motor shaft and that the mo ... Eureka Smartvac 4870 Bagged Upright Vacuum
Vacuum only runs a short time then shuts itself off
... Eureka 4700A Maxima Bagless Upright Vacuum
Vacuum stops My Wind Tunnel stops working in a very short time when using. It takes awhile for it turn back on. It still shuts off quick. I have cleaned the hoses and inside of the power brush. This doesn't correct problem. Delbert Briggs
Your thermal cutout is tripping. This only happens when the motor heat gets very high, and the reason it takes a while to turn back on is that the motor has to cool down before it will reset. Ensure that absolutely every air pathway is clear, because ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum
Rainbow stops shortly after starting to vacuum
There is a thermal fuse on the motor field that sometimes fails. Sometimes the fuse does what it is supposed to do - prevents motor from ov ... Rainbow E series Canister Wet/Dry Vacuum
I have no power on a brand new Electrolux Oxygen canister vacuum. This is the second time. After the first time, I took it back to Sears where I bought the vacuum and they gave me a brand new vacuum. This is the second time it's happened, basically on both units after the time that i brought them home.
Ensure that the tools and the bucket are installed properly, if the bucket is not well in place, the unit wont start.If the electric power does not come on, disconnect from mainsand check plugs, cable and fuses where appropriate. ... Electrolux Vacuums
My Riccar 1700 will intermittently lose power while vacuuming. I have had the vacuum for 4 years and this is the second time that I have had this problem. The first time the authorized repairperson said the problem was a dirty hepa filter. The second time, the repairperson put on a "pig-tail"(?) and said that he did not have a shut-down problem when he tested the vacuum in the store. I just picked it up from the store today, brought it home and the same problem occurred within minutes.
... Riccar RC1100 Compact Vacuum
I have a Simplicity S24 canister vacuum. It's about 3 yrs. old. In the past year I have had it in the shop 4 times because when using the rug piece, the piece turns on & off, on & off. The actual vacuum doesn't... just the rug piece. I recently spent $65 on a new part, after spending countless dollars the other 3 times it was in the shop for this problem. I'm ready to buy another name vacuum altogether as I feel this vacuum is not worth the money that was spent on it. I'm very frustrated.
Repair shop has not fixed the problem? complain until they fix it properly. This is a pressure fault / jamming issue or slipping drive. Repair shop should have fixed it 1st time. ... Vacuums