Having problems with your Roomba Pro Elite Bagless Robotic Vacuum ?

Roomba pro elite change drive wheels

\015 How do I change the drive wheels on a Roomba Pro Elite.\015\012\015\012I need a manual on how to take out the drive wheel(S) and replacing them so it will work. \015\012\015\012One of the drive wheels has lost the rubber tread. I have to complete drive wheels but no other instructions on how to replace them. I have all the screw out but there is some thing still holding the unit together so I can not get at the drive wheels.\015\012\015\012Please help.\015\012\015\012Clayton Knapp\015\[email protected]\015

Answers :

Just click the below link...ur pro will be solve


thanks for using fixya...
rate tis solution
You can get that here
\015\012Click me
Repair Help & Product Troubleshooting for Roomba Pro Elite Bagless Robotic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Roomba pro elite change drive wheels

Just click the below link...ur pro will be solvehttp://www.wikihow.com/Fix-a-Vacuum-Cleanerthanks for using fixya...rate tis solut ... Roomba Pro Elite Bagless Robotic Vacuum

My roomba pro elite just goes around in a circle. how can I fix this? I have cleaned the roomba as thoroughly as I can. Could it be a recently changed wheel tread?

The infrared sensor circuit has failed, u will need to have it repaired ... Roomba Pro Elite Bagless Robotic Vacuum

My romba doesn't keep it's charge very long - Roomba Pro Elite Bagless Robotic Vacuum

This happens over time as the battery wears out. Time to replace the battery. Or, perhaps the battery is not receiving a full charge when it needs to (and damage has been done). Power supply might be culprit of not receiving full charge. ... Roomba Pro Elite Bagless Robotic Vacuum

Roomba 550 will not go forward, only turns and moves a few inches in reverse. I changed out the wheel motors with no results. Cleaned bumper and sensors with no results.

... iRobot Roomba 550 Vacuum

I bought a roomba pro elite robotic floorvac at a tag sale from an elderly couple who apparently used this vac very little as it was very clean and she had never even used it enough to use the extra filters that came with it, she said it was just too much for her to bend down to work it or move it. i suspect she stored it but kept the battery in it. after charging it, it powers up and sings a little tune, but then shuts off. i cleaned everything, including the sensors. it still shuts off, do you

... Roomba Pro Elite Bagless Robotic Vacuum

My Discovery 4210 Roomba will run normally for about 20 minutes on a smooth, wooden floor. It then begins the following sequence: run forward a few inches, turn in a tight counter-clockwise circle a few revolutions, stop, power off a few seconds, power up, repeat cycle from forward run. The sequence can be repeated seemingly endlessly if I don't turn off the power manually. I've replaced the motor, and led revolution sensor system on the left drive wheel. I've blown the dust out of everywhere. A

This robot vacuum has a electronic micro processor that controls the unit and tells it how to operate and where to go based on programmed parameters. It's quite a technical marvel. I have dropped a link here for contacting the company tech support li ... iRobot Roomba 560 Robotic Vacuum

Changed wheel and roomba starts but shuts off in 2-3 seconds

Make sure all wires are connected properly, make sure all parts move freely with ease and nothing is binded up. Make sure any service doors are completely shut.If problem still remains, then either there is a faulty control circuit, or a part ... Roomba Pro Elite Bagless Robotic Vacuum

Needle rubbing I have a singer pro finish and recently I broke a needle and the lower looper also busted clean off. I ordered the lower looper and replaced the broken one and changed both the needles. Now when I turn the hand wheel and the lower looper moves to the left and the needles descend they pass in front of the looper but when the needles begin to move up and the looper moves back to the right the needles bend back and go behind the looper. Help! Thank You!

... Singer 14CG754.CS Pro Finish Industrial Commercial-Grade Serger

I have a Roomba 560 (it's still in warranty !!) and, after my summer vacation, it has a problem. When I'm charging Roomba, the orange light blinks (and this is normal!) but this orange blinking continues forever.... the light doesn't change to green. If I detach Roomba from the charger, the light become green and it works normally until the light changes to red and I have to charge it again. WHY, DURING THE CHARGING PHASE, THE LIGHT DOESN'T CHANGE FROM ORANGE-BLINKING TO GREEN? HAVE I

The problem is not with the charger itself but it is with the battery inside the Roomba. It sunds like one or more of the cells has gone bad so its not holding the same charge as it did. I would recomend sending it in while the warranty is still vali ... Roomba Robotic Floor Bagless Vacuum

Roomba circles My Roomba circles for a few minutes, then beeps 9 times and stops. A red exclamation mark appears on the left hand side of the controls. If you persist in restarting it, eventually I have been asked to clear Roombas wheels. As far as I can see, there isn't anything blocking the wheels.

Yes, this is known issue and if your bumper moves freely, you might be facing a sensor fault caused by poor quality of components.Here is a guide to fix ithttp://www.schneordesign.com/Avi/irobot/roomba_mod2.htmHave fun ... iRobot Roomba 560 Robotic Vacuum

Hoover elite belt change model number U4245

You have to take the top (hood) off. Mine is red. I'm not sure if they are all the same, but I suspect they are. There are 4 tabs that hold it on. First, gently wedge a screwdriver between the red hood and the black bottom plate around the side of th ... Hoover Elite U5061-900 Bagged Upright Vacuum

I want to open a Hoover S3825 Elite Cyclonic Vacuum to see if I can repair or replace the cord reel assembly. Currently the reel slowly draws the cord back into the canister once it is pulled out. I found the mounting screws under the rear wheels once I removed the hub but I do not know how to remove the rear wheels, everything is plastic. The front screws are under the front caster wheels and I think I need to take a screwdriver and pry off the little cylinder wheel to get to them by rotating

... Vacuums

Roomba wont stop going in circles,code 9 comes up, cleaned front caster wheel to no avail. 500 series roomba. called company said we need a new one, if this is the best we can get out of a roomba they are junk.

\015\012\015\012Your bump sensors are malfunctioning. The best thing to do is order a repair kit. I ordered mine from EESolutions.ca and it worked great.. ... iRobot Roomba 560 Robotic Vacuum

Ihave a Hoover Windtunnel self-propel model U6445-920. The belt from the drive motor to the big wheel will not run in the center of the wheel. The belt runs about 1/3 off the wheel. I have tried several new belts and still the same problem. What do I need to do to repair this problem.

The large wheel may be worn off center. If the belt stays on and is not thrown, you can run the vac. if there is wobble in the wheel causing a genuine belt to slide off replace the wheel mechanism. ... Vacuums

Roomba wheel -- stuck

I had a similar problem, I just took my Roomba Red apart and put it back together about four times before I fixed it.  In my case it turned out to be a dirty sensor, fixed as described at\015\012\015\012http://mysteryroad.blogs.com/photos/ ... Roomba Robotic Floor Bagless Vacuum

Front wheel problem

I would send it to protechrobotics. they will test all your components and let you know what needs to be done. if the repair is more than it's worth--they will help you out too.http://www.protechrobotics.com/ ... iRobot Roomba 4210 Bagless Robotic Vacuum

Roomba stutters on one wheel causing it to quit

Try setting the Roomba on the floor, powering it up, pressing down hard on the front, just above the front wheel, and hitting "clean" or "spot." My Roomba had the same problem, and this seems to do the trick for it. I think it has something to do wit ... iRobot 4150 Roomba Vacuum

Need drive wheels for my eureka selfpropelled model 5060F

... Vacuums

How do you change belt on Bissell pro heat carpet cleaner. can you please send diagram or instruction how to change belts.

Http://www.bissell.com/images/UserGuides/7950_1204.indd.pdfhere is the complete manual (it is in pdf form)includes diagrams & instructions on belt replacment.thanx for using fix-ya!!!please rate all replys. ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Neato right wheel stuck - Neato Robotics Neato Right Drive Wheel

... Neato Robotics Neato Right Drive Wheel

On the ultimate g the drive pedal came out of the machine. tried to slide it in but it will not change the drive mode. take off the bottom to see what is in there?

First you need to remove the top cover before you take the three corner screws out of the bottom. Remove handle, bag , two screws on the scuff plate and stick a flat head in the slot of the scuff plate and pry up. you will have two screws under there ... Kirby Ultimate G Bagged Upright Vacuum

Fan belt wheel missing. Took it apart and discovered fan belt torn and no wheel on drive shaft for brush. I am assuming that there was one there originally.Did it shatter or what.What is solution. Can I get exploded view of this model or others like it.

Get another fan belt wheel of the model and place it over it ... Vacuums

I replaced the agitator bar drive belt on a Hoover Model U6432-900 upright vacuum cleaner, but it just slips when the drive wheel is spinning. Is there an adjustment I need to make? I don't see any adjustment spots.

You probably should have replaced the flat belt(38528035) also. But the drive belt has a idler wheel(#13) to engage it, is it riding on the belt, if not if may have jammed to one side and able to spring up against the V belt. It could have broke al ... Vacuums

My Roomba 4210 plays the dead battery song 10 seconds after I press Clean, Spot or Max. But I notice that I can put my roomba in diagnostic mode (with brushes, wheels etc) for long periods of time with plenty of strong power. Why won't it clean for more than five seconds without that dreadful tune, flashing power light and an amber status light?

... Roomba Robotic Floor Bagless Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0618 seconds