Having problems with your Roomba Robotic Floor Bagless Vacuum ?

Roomba Discovery is burning up batteries. I fried 2 batteries in a row with it. I suspect it is overcharging. Want to fix it myself if I can.


Answers :

Yes, if the cleaning head is clogged with debris, it will drain battery. Open up your robot and clean it.
Repair Help & Product Troubleshooting for Roomba Robotic Floor Bagless Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Roomba Discovery is burning up batteries. I fried 2 batteries in a row with it. I suspect it is overcharging. Want to fix it myself if I can.


Yes, if the cleaning head is clogged with debris, it will drain battery. Open up your robot and clean it. ... Roomba Robotic Floor Bagless Vacuum

Burning smell how do I get the bottom section apart to clean it out- burning smell when i have the spin brushes turned on. Any help would be appreciated cause I love this machine and hubby told me it couldn't be taken apart to be fixed. Thank you.


The bottom doesn't come apart. you have to remove the top cover to get to any components. But if you have a burning smell, then it is probably ther motor and would have to be replaced. Motors cost anywhere from $70 to $90. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My hoover Wind Tunnel vacuum cleaner's motor spindle keeps overheating. Because of the high temperature, it keeps burning through belts (the big, wide ones). I have taken it in to the vacuum repair shop about three times now, and the problem has never been fixed. Does anyone have any advice on how to fix this or should I just buy a new vacuum?


... Vacuums

Burning smell When i start up my vaccuum it gives off a burning smell, it still picks up & operates like it should just leaves the house smelling like ive had a fire. Any advice on how to fix will be greatly appreciated.


Replace the belt. It is probably stretched and is slipping. This will produce the smell your describing. These belts should be changed at least once a year. ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

BURNING SMELL My DC 07 has suffered from poor suction in the upright position for some time now but this morning it ground to a halt. It was if the motor had burned out. I turned it upside down and some small stones etc tumbled out. I tried switching on again and the motor kicked in but the smell was horrendous so i switched off immediately. If it's likely to be **** inside the motor area i don't no how to access it. I've removed for fixing screws but still unable to prise apart. Is it just the


Hi.\015\012\015\012Try this site http://dysonmanuals.llc.nu/ has service manuals covering removing the Dc07 motor. ... Dyson DC07 All Floors Bagless Upright Cyclonic Vacuum

Bristles quit rotating and smelled like something was burning. It isn't the belt that turns the bristles. Can't afford a repairman, can you help me fix it?


Belt can reamin intact but still jam and burn. It won't necessarily break. I suggest you remove the bottom of the vacuum where the bristles spins and where the belt is located. You may have something jammed in there. You may need to remove the bristl ... Bissell 6594 PowerForce Bagless Upright Vacuum

I have had my Bissell Healthy Home for just over a year. I use it once or twice a week on five area rugs and two small bedrooms with wall to wall carpet. Just recently, the motor started to sound extremely loud and it smells like it's burning. The vacuum still picks up everything and all the brushes are turning. Advice? I really like this vacuum and would really like to fix it rather than replace it!


Hi,Here is a tip that I wrote about my Bissel but I bet you have the same problem and the hose is clogged...Bissell Bagless Upright Vacuum no ... Bissell 5770 Healthy Home Bagless Upright Cyclonic Vacuum

Kenmore cannister vacuum model 116.2411290 has begun exhausting a 'burned' smell. Suspect bad blower bearing. How to access?(Can't find manual online.)


Hi,how are you so sure the problem is from the blower bearing and not the belt,well to know if the problem is from the blower bearing or the belt you have to know how to access your vacuum first,so from all angle you need the manual You can download ... Kenmore Vacuums

Vorwerk VK121 vacuum cleaner - smell of burning from housing enclosing motor. How do I get into the housing to inspect the motor? After tilting the bag sideways, there are two screws holding the housing visible, but there seems to be a thrid fixing inside the point where the handle shaft is attached - is the handle simply clipped in place? Thanks


Yes the handle is clipped in place and should come out when the button in front is pushed. Remove the screws you wrote about. After that the puzzle begins. At the bottom of the vacuum where the head is attached, remove the head by pressing the but ... Vacuums

My Kenmore Handi-Mate Jr., Model # 116.36622501 generates a burning smell once i turn it on. It is out of warranty. There is any way i can look at the vacuum myself and figure out what is broken/burned and understand if it is worth fixing it? It vacuumed very nicely for about 2 years and it wasn't a cheap vacuum. Thank you very very much.


... Kenmore Vacuums

HOOVER VACUUMS MY MOTHER'S WORK, MERRY MAIDS, USES ALL HOOVER VACS. THEY ARE LIGHTWEIGHT-UPRIGHT-BAGGED VACS. I TRY TO FIX THEM WHEN THE MAIDS BREAK THEM; BUT, I'M HAVING PROBLEMS WITH A BURNING SMELL AND ONE MOTOR EVEN SMOKES. I'M NOT SURE THE MODEL. CAN YOU HELP? THANK YOU.....


Go to thehooverstore - this site lists a whole bunch of hoover machines, exploded diagrams and parts lists. ... Hoover Soft Light Supreme U4262-930 Bagged Upright Vacuum

We have a Bissell 3750e Upright Cleaner which has become very very noisy.It still works but there is a slight rubbery burning smell. Can I fix it or will it require expert attention?


You can fix it easily. All you need to do is change the belt and you'll be good. Here is a link to the belt you need and the manual which has instructions. ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum

Mine is the Discovery model but the fix it should be the same. My problem is that it only goes in a small circle and will not move on. It ACTS likeit is stucfk in the "spot" mode.


Hi,\015\012 \015\012You are correct though you have the discovery model the way to understand the code and find the troubleshooting steps are same. First when the status light comes on, the Discovery is goi ... iRobot Roomba Red 4100 Bagless Robotic Vacuum

I vacuumed a sock and it started to smell like it was burning. i removed the sock from the brush head. now it still sucks, but the brush doesn't roll anymore. any ideas how to fix it?


Change your belt. ... Electrolux Vacuums

My miele s571 hoover is humming from a normal sound to a real low hum sound and their is a smell of burning it even through my smoke alarms off what would be wrong or is it worth fixing


It could just be a slipping belt, hair and lint get under the belt and make it stretch the it slips and the spinning drive post heats it up until it starts burning. ... Miele S318 Bagged Canister Vacuum

Smoking belt Hey I have a Eureka 2961 avz bagless vacuum, and if it's on for a few minutes i can smell the belt burning.  If the vacuum is left on any longer the belt starts smoking.  I took the case off and there was a little debris but not much.  Is there a cause and fix or just time to replace the belt?


Belt is slipping because the bearings on the beater brushes, which it turns, are jammed or full of dust. \015\012Alternatively the belt has stretched after being overheated and needs replacing because it now slips. ... Eureka 2961AVZ Bagless Upright Vacuum

The motor has a large electrical arch and burns when it is turned on. Is there anything I can do to fix this?


Usually there is some dirt that has gotten into the motor compartment and is making the brushes arc. You can make sure your vacuum is unplugged and lay it on it's back so you can see the bottom part of the vacuum where the roller is. There are about ... Oreck XL2000 Bagged Upright Vacuum

Something is moving around inside the vacuum (Dirt Devil Featherlite), sounds like plastic ou metal just rattling around and if left on too long it smell like burning. Can it be fixed?


If it smells like electrical burning or not like rubber then its probably your motor bearings making all the noise which means its not worth repairing. ... Dirt Devil Featherlite Bagless Vacuum M085845Vacuum

BOSCH ERGOMAXX MODEL BSG82000GB/01 BAGGED VACUUM CLEANER NOT WORKING AFTER VACUUMING MY CAR, CHECKED FUSE IN PLUG AND CABLE WIRES ALL OK, I SUSPECT THE MOTOR HAS OVERHEATED BUT THE MACHINE JUST WENT DEAD JUST AS IF YOU PRESSED THE OFF BUTTON, NO SMOKE OR BURNING SMELLS??? PLEASE CAN ANYONE HELP.


... Bosch Vacuums

Beater bar not moving. Is there a belt? My mom sucked up a sock and didn't know. So she kept vacumming and then smelled something rubbery burning. And then we found the sock and cleared it. Then the beater bar wouldn't move after that. How do I fix it.


Hello,The belt is broken or badly stretched and needs to be replaced. Here is a link to download a manual.Look for the "Download Manual" on the right side of page. Scroll down towards bottom of page and you'll see how to open it up to cha ... Eureka 4700A Maxima Bagless Upright Vacuum

We have the bissell quicksteamer and as I was shampooing I began to notice something burning so I unplugged our machine immediately; then my mom and I started cleaning all the filters assuming that could be the source of our problem and yes it was a little dirty but I suspected that it would take more thant that to cause our machine to somke soI turned it upside down and noticed there is a cable of copper threads that appear to have some type of rubber or plastic insulation tubing around it but


Was the exposed copper wiring on the electrical cord? If is then replace the cord. The main problem with this model is that Bissell obsoleted it as well as parts for it. But if all you need is a cord, you should be able to get one from a repair shop. ... Bissell 1960-3 QuickSteamer Plus Upright Vacuum

My Generation 3 Kirby Vacuum is giving off a burnt rubber smell when I vacuum. I have tried to raise the height of the head but it still happens. Can you tell me what could be causing rubber to burn? What needs to be fixed?


The belt driving the brush roller in the power head is slipping. It is really just a big thick rubber band. Where it wears out it slips and burns due to friction. Look at the bottom of the power head. There is a cover plate held with 2 to ... Kirby Generation 3 Bagged Upright Vacuum

Burning smell. i think the belt is broken. how do I fix it?


Turn the power head over and you will see (2) screws. Remove the screws and the top cover will come off and you can get to the belt. Here is the belt you need: ... Kenmore 23812 Progressive PowerMate Bagged Canister Vacuum

My bissel vacuum model 61c5-w smells like its burning an loud how can i fix it


... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum

Hi Fixya team -- Here's hoping that your refrigerator gurus are as super duper as your TV champs. I have a Genair fridge-freezer with zero power except to its internal light. Otherwise, no fans working, no noise, no nuttin'. It's a JSD2789GES. Please aim me at the 3 likeliest suspect parts fast because I must visit the owner and fix tonight if possible. Many Thanks, Gramps. PW: renthelp BDCD928E


Hello,These are the parts that might be faulty.\015\012\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012\015 ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0307 seconds