Having problems with your Samsung CASE-DETERGENT;WA80V3 - DC61-01759D ?

Wa80v3 (washing machine) not rinsing - Samsung CASE-DETERGENT;WA80V3 - DC61-01759D


Answers :

Repair Help & Product Troubleshooting for Samsung CASE-DETERGENT;WA80V3 - DC61-01759D

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Wa80v3 (washing machine) not rinsing - Samsung CASE-DETERGENT;WA80V3 - DC61-01759D


... Samsung CASE-DETERGENT;WA80V3 - DC61-01759D

Incoming water is outgoing without stopping - Samsung CASE-DETERGENT;WA80V3 - DC61-01759D


... Samsung CASE-DETERGENT;WA80V3 - DC61-01759D

Diamond drum WA80V9 Manual - Samsung CASE-DETERGENT;WA80V3 - DC61-01759D


... Samsung CASE-DETERGENT;WA80V3 - DC61-01759D

I have the SAMSUNG WA80V3 washing machine and I have tried many detergents but they all clogg. I also put a filter but still the problem remains. Is it the water quality? I live in Oman.


See the causes and fix it. God bless youstopped \012spraying. If the spray function has quit working on the carpet cleaner, \012check to make sure there is a full tank of water. If the water level is \012adequate, check the position of the gasket ... Samsung CASE-DETERGENT;WA80V3 - DC61-01759D

Model No. D-37272-100 when I have the brushes off the scrubber, they turn very easily, but once I mount them back in place, and turn the scrubber on the brushes won't move But the machine runs in wash and rinse cycle. WHY??


... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Hoover steam vac..F7452-900. not working in wash-auto rinse mode


It is not the pump. If it sprays on rinse the pump is fine. An easy test is to plug in the accessory hose and the spray nozzle hose. If it shoots liquid, there is no pump problem.You have a bad solenoid. There are two solenoids that control water ... Hoover F7452-900 SteamVac Upright Vacuum

Hoover 500 top load washing machine - water in-flow very, very slow


Check the water valve. Most of the hoses that are hooked to the water valve have a screened filter, turn water off, unhook hoses, check to see if they need to be cleaned. Other wise the water valve is bad and will have to be replaced. ... Hoover H3030 FloorMate SpinScrub 500 Upright Wet/Dry Vacuum

I have a new Hoover Dual V steam vac that I bought from a neighbor who only used it once. I have only used it once since then and it worked great. This time, because I am pregnant, I bought some non-toxic cleaner that was much thicker than the very watery Hoover soap. This vac has a wash option and a rinse option. The rinse option works (sprays and sucks properly), but the wash cycle doesn't at all-neither soap nor water comes out. Nothing comes out, but it still sucks. I took everything o


There's a powerful electric motor attached to a fan that sucks in air.Did you checked and cleaned that motor.If the dirt is got stuck up ion the motor then the motor will not spin as per its regular speed.For rinsing the motor spin on one cycl ... Vacuums

Lately we've been having plumbing problems to where our washing machine floods up our bath tub and toilet. And it happens while we have the washing machine on of course. Another problem is that whenever we are taking a shower our tub starts to clog up and water starts pouring out from the bottom of our toilet. We had a plumber come by to root out our pipes just last week and it was fine for about 3 days. And now the problem is back and driving me crazy. WHAT IS WRONG AND HOW CAN I FIX IT??


Possible tree roots best thing is to hire a plumber with a camera snake ... M&S Systems AirVac AVP1200 Platinum Series Central Vac - 12,000 sq ft Bagged Central System Vacuum

Hoover washing machine error E14 machine does wash cycle then finishes and says e 14 and wont open


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Our beautiful Bernina 730 sewing machine has been stored in the garage in its original case, and that wrapped in plastic, for a few years now. Temperatures have been both hot and cold in the garage, but the environment was dust-free. We have brought the Bernina in, set it up, oiled it as specified in the manual, with the original sewing machine oil. We have correctly threaded the machine and the bobbin thread is up. When we press on the pedal to sew, the machine gets electricity and buzzes


Hello and thank you for using Fixya ....From what you describe there can be only 2 causes...Either the machine is still stuck ..and the motor buzzes cause it can not spin it ..and in this case it needs to be oiled more..and be spun by hand unt ... Vacuums

We have a Hover F7411-900 which runs great but for some reason the wash does not dispense the cleaning solution. It works fine on rinse but not on wash. We tried cleaning the round piece at the base of the cleaning solution but that did not fix the problem. How can you repair so that the wash will work.


That would be the wash silonod, the thing that makes the soap and water mix together in order to make the soap come out at the bottom were the brushes are. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Electrolux ew910t after each washing small amount of water (about 1-2 glasses)appear under washing machine. I have checked both water filling and dump tubes - both are dry during whole washing cycle. Water commes from bottom corner of washer in drops. Do you have any idea what can be the problem? Many thanks, Pavel.


Are your loads spinning even if off balance it will cause the drum to spin off balance and water will come out of the bottom ... Vacuums

Jun 24, 2010 - Jun 24, 2010 - Needle not bent/ new needle not answer. I finally conclude that the entire bobbin case is ROTATING in its seat, which jams the needle. The "projection" is against the "spring" when I install it, but I can rotate the bobbin case PAST the spring without trying very hard. Bobbin case MIGHT get held in place better if it were closer to me (front of machine). I feel it is still not out from under needle plate as shown in diagram, but can't keep it closer to f


Hi,Your problem dated 24th June 2010 was re-posted today. If it has been already resolved, kindly ignore this message.Thanks for using FixYa ... Vacuums

Problem with washing machine


This got posted in the wrong repair section, please repost it in the laundry repair section, not the vacuum repair section. ... LG Vacuums

I own a Hoover Steam Vac V2 deep cleaner with Auto Rinse feature. The Model Number is not available ex: was on the bottom of the machine and the sticker is completely worn off the machine. I am having a problem with the bottle you fill with detergent ex: this bottle is seperate from the main clean water tank. THE PROBLEM: The little plastic part that goes in the bottom of the bottle has an "O" ring ex: cone shaped with a spring.....it keeps falling out. Can you supply a part number for this


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=641300\015\012Generic problem for all Vacuums\015\012I own a Hoover Steam\015\012Posted by w_brennan on ... Vacuums

How do I install the bobbin case and bobbin case body in a model #9420 singer sewing machine


... Singer Instruction Manual - 9420

Can cloth filter be washed in washing machine


... Eureka CV1801 Bagged Vacuum

Just had my dc24 for 6 weeks - decided to wash filters - do the filters stay in their plastic covers? They were a bit dirty but no visible dirt came out when i washed them 9in their plastic casings). Surely they will take ages to dry.


Hi there,\015\012\015\012To confirm, the filters do stay in their plastic casing when you wash them.\015\012\015\012You may find it helpful to refer to this Dyson video guide, which demonstrates each step in the filter wash pr ... Dyson Ball DC24 Bagless Upright Vacuum

Elna Corina Sewing Machine: the bobbin thread does not pick up. Someone took out the booin case from the machine, and it was never re-installed correctly. Now the thread will not pick up.


... Vacuums

I would really like to wash the outer bag of my vacuum, but I have a problem. I can remove the outer bag from the vacuum, but the plastic 'frame' that is inside the outer bag is sewn to the bag. So what am I supposed to do about that if I want to put it in the washing machine? I have the Oreck XL Silver.


Hi, you can wash the bag. However you cannot wash the bag in the wash machine. What you will want to do is look for the screw or depending on the model, untwist the cap down on the rod next to the machine. that entire pole section will co ... Oreck XL2000 Bagged Upright Vacuum

The water tank on my bissell proheat 2x is not keeping the clean and dirty water separate. I;ve checked the container and there doesn't seem to have anything wrong with it. Also when I switch the machine on you can see the "washing" action, after a few minutes this seems to stop - there is water and forumula in the machine. Only had it a year!


... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

The case for the bobbin is not locked in and the machine will now sew White Stylemaker 3100 (sewing machine)


... Vacuums

How to reset electrolux washing machine EWF551


Try this link > http://world.casio.com/wat/download/en/manual/ ... Vacuums

How to solve a bobbin case popping out of my singer 6233 sewing machine


... SewShop.com Singer Model 6233 Instruction Manual
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0645 seconds