Having problems with your Scunci 52067 Handheld Steam Vacuum ?

Heats up and produces steam but the release button does not open the flow of steam.


Answers :

To remedy this, I did the following:\015\012\015\012\015\012
\015\0121) Removed screws from: a) Lower area of handle (1 screw), b) Top of steamer, under round rubber flap around fill hole (2 screws), c) Front of steamer where nozzles attach (2 screws)\015\012
\015\0122) Removed back of handle, top of steamer, front of steamer where nozzles attach \015\012
\015\0123) Once all parts are removed, you can see a brass button that is pushed by the trigger\015\012
\015\0124) Using a needle-nose pliers, grasp and rotate the button several times in both directions (you may hear it cranking against the interior spring). Do this until it turns fairly easily with the pliers.\015\012
\015\0125) Once this is done, you fill find that the brass button can be very slightly depressed with a bit of force. You may also need/want to unfold a large paper clip to push into the nozzle hole to help unsticking the brass button (not sure if that helped in my case, but it was something I tried along the way). When the brass button moves in and out (again, it won't move much), the steam release mechanism is unstuck!\015\012
\015\0126) Reassemble all parts (everything snaps back neatly into place).\015\012
\015\012This worked for my unit!
To fix the problem of no steam coming out or steam coming out without pushing the buttom.
\015\012Do this:
\015\012
\015\0121. Remove the two screws from the from of the steamer then remove the end cap.
\015\012
\015\0122. Removed screw from the lower area of handle.
\015\012
\015\0123.Top of steamer, remove the two screws under round rubber flap around fill hole.
\015\012
4. Removed back of handle, top of steamer, front of steamer where nozzles attach.
\015\012
\015\0125. Remove the plastic tube where the steam comes out.
\015\012
\015\0126. Now look in the hole where the steam comes out and remove the 1/4 inch nut, metal washer, and rubber washer.
\015\012
\015\0127. Take a small punch and lightly tap the brass rod until it pops out the back.
\015\012
\015\0128. Remove the brass rod and spring. " The spring will have white crud on it and in the hole where it came out of. Clean the hole and spring realy good. This will fix the problem of steam always coming out with out pushing the button."

\015\0129. Clean the brass rod, spring, and hole that they go into. I use a very small round wire brush. "Like the kind you might use to clean a gun."
\015\012
\015\01210. Spray some WD40 in the hole and on the brass rod, then put a few drops of oil on the rod.
\015\012
\015\01211. Put every thing back together and it will work like new.
\015\012
\015\01212. Don't use tap water in the steamer and you will not get the build up.
Repair Help & Product Troubleshooting for Scunci 52067 Handheld Steam Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Heats up and produces steam but the release button does not open the flow of steam.


To remedy this, I did the following:\015\012\015\012\015\012\015\0121) Removed screws from: a) Lower area of handle (1 screw), b) Top of steamer, under round rubber flap around fill hole (2 screws), c) Front of steamer where nozzles attach (2 s ... Scunci 52067 Handheld Steam Vacuum

No steam I am using this product for the first time. I've followed the manual down to the letter, but is doesn't produce or releases any steam. The heating element does operate and the warninglight does turn off but yet there is no steam to be found, even though I'm pressing the lever on the pistolgrip. What can be the problem, and how do I solve it? Thanks in advance. Mrs. Brouwers


... Karcher 1201 Canister Vacuum

Producing steam i just got the shark assembled the mv2010, then it is not doing anything, it vacuumed just fine, but when i put the steam pad on it wouldnt ever produce steam or do anything,it felt like the water was heating up but even after it sat for 20-30 minutes when i pull handle back towards me nothing happens, no lights no steam no nothing, so why wont it work


This link is for the manualhttp://www.sharkclean.com/manual/MV2010_11_IB_ENG_110103.pdf ... Shark MV2010 Vac-Then-Steam 2-in-1 Vacuum and Steam Mop Purple

I have a Euro-Pro Shark Steam Pocket Mop. I used it twice last year, and then it stopped producing steam. Is there any way that I could easily fix this without dangerous chemicals? Everytime I call the company, I can't get anyone. The unit heats up, but doesn't produce steam. I've tried white vinegar to no avail. I am afried of using clr after reading that the unit blew up on somoone. I am visually impaired.


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Manual I realize it's probably something simple but how do I release the Cyclonic Chamber on top of the Dust Cup lid? I see the red 'open to clean' release button but how do I get down in there to push the release button? Thank you in advance for your help! Best, Christy


Manual > http://www.sharkclean.com/manual/NV22-NV22C-NV22P-NV22T-NV22Q_REV_1008.pdf ... Euro-Pro NV22 Shark Navigator Bagless Upright Vacuum

Cleaner heats up but no steam is coming out. It let loose a big ball of steam when I plugged it in, then nothing and still won't heat up enough to produce steam.


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Star elite sm-02 steam mop does not produce steam, the tank heats up but no steam. any suggestions


... Vacuums

When I push the button to release steam on the handle it feels soft and no steam is released. It has been going out for a while now.


I didn't fix the problem but I did take the handle apart. There is a little metal piston that is pushed down by the button on the outside of the handle. It was very sticky and stuck in the off mode. I freed it when I took it apart but obviously it ju ... Steam Fast SF-275 Steam Max Canister Vacuum

Machine will not produce steam. Machine will heat up but not enough to produce steam. Help ...


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

My mini steam zapper heats but produces no heat


You should get steam in the amount of time it take to boil water ... EuroSteam Vapor Steam Cleaner Vacuum

I have a EuroPro SC410 steam cleaner. It produces steam, but the steam button does nothing but cause the unit to hum. If there is valve to allow the steam to exit, is not working. I would like to replace it, where can I purchase the parts?


... Euro-Pro S3325 Handheld Steam Vacuum

Delux Steam Mop not producing steam. Motor comes on , but , no steam . This is the first time I have tried to use it. The instructions mention "Priming the mop like a steam iron" , but , there is no buttons etc. to push for priming.


... Vacuums

While using my mop yesterday, it stopped letting steam come out. Tonight I plugged it up again and you could hear it trying to steam. I push the button in to release the square frame and it pushed out a burst of steam and pushed the head off. Put it back together and it still will not let steam out. No matter how much water is in it.


\012Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Ste ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I loved my Shark Steam Pocket Mop, but it suddenly stopped producing steam through the mop heads. The water is heating and I can see and hear steam coming out of the actually body of the mop, but it will not go through to the head. I have thought of running white vinegar through it. Do you have any suggestions?


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam M ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

My shark steam cleaner won't "steam out" when I push the button, what's up. Light is on, when I release he safety cap,steam comes out??


... Euro-Pro Ultra Steam SharkTM II Hard Surface Steam Cleaner Vacuum

My conair sc 10 steam cleaner will not produce steam. The green ready light comes on, but all it does is make noise when you hold the steam button


... Conair SC20 Handheld Steam Cleaner

My shark steam mop has stop producing the steam to clean. I only get a little water to come out to wet the cleaning pad. Is it stopped up and if so how do I get the steam and water flow back


Dear Sir/Madam\012\012Good day.\012\012We're Auto-parts manufacturer from China. We are able to supply Axles & Axle tubes , Grease Nipple,Brake hose , Auto Springs, and some other fittings. If you have any requirements about auto- ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Bissell pro heat steam carpet cleaner, not releasing water.


That means that you need to replace the pump belt. Here is the belt you \012need and a manual you can view:\012\012Bissell 7901 Belt and ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Euro Pro Shark Light and Easy Steam Mop EU-S3250 light wont come on. heat or produce steamWhat's your problem?


THINK YOUR FUSSE AS GONE IN YOUR STEAM MOP ... Euro-Pro Shark Light and Easy Steam Mop S3250, EU-S3250

My Bissell Pro Heat 2X steam cleaner is not releasing the water


Have you tried cleaning out the small filterfrom the reserve tank? Also, check the tank/resevoir valve is operating properly, when you take it out to fill try to make water release from tank. ... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

My shark steam mop will not heat up and produce steam. it has only been used 4 times. help


Hi,Empty the water and try different water...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

It heats up but doesn't produce steam - Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have a Shark Steam Mop S3501CO model. When I press the release button to exchange mop heads, the mop head does not release. Nils Friis


Normal\012 0\012 \012 \012 \012 \012 \012 \012 MicrosoftInternetExplorer4\012 \012\012\012\012\012\012 /* Style Definitions */\012 table.MsoNormalTable\012\011{mso-style-name:"Table Normal";\012\011mso-tstyle-rowband-size:0;\012\011mso-ts ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Steam does not come out when we pump the handle.Water just pours out from the bottom. Water does heat, but steam does not release.


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Heats up, shows steam but does not produce push of steam when handle is pumped?


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0699 seconds