Having problems with your Sebo Automatic X1 Bagged Upright Vacuum ?

Full bag clog light

\015 I have the sebo X4 extra, the bag full clog light keeps coming on. There are no clogs in any parts and it has full suction. Machine automaticly shuts off after 30 seconds with the full bag/clog light lit very frustrating! I even replaced all filters & bag, took better brush off so I could get a real good look just in case I missed something.\015

Answers :

1.If your sebo is less than five years old, you have a reciept, and are not using it commercially, in most cases this machine will still be under factory warranty. To locate
\015\012an authorized sebo dealer simply call sebo or use the dealer locator on their website.
\015\012
\015\0122. If it is no longer under warranty:
\015\012First i would pick up something small such as a balled up gum wrapper and make sure it makes it to the bag, more often than not something is not checked, and its still plugged. Heres how i'd check for plugs.
\015\012
    \015\012
  • Pull the wand out and remove it from the hose by pressing the button on the wand look through the wand
  • \015\012
  • Remove the hose from the machine by pinching the hose clamp and pulling the hose out (it simply presses back in when you are done)
  • \015\012
  • press on the large button below the bag compartment on the front. (its often a different color and presses difficultly) lift the bag compartment and handle off the powerhead. (replace by simply pressing the bag compartment back onto the head)
  • \015\012
  • look down the powerhead and inspect the other areas of the bag compartment.
  • \015\012
  • open the orange/gray door on the bottom of the powerhead and look through checking for debris.
\015\012 Simply go back up through the steps to reassemble.
\015\012
\015\012If your test makes it into the bag just fine and you are not plugged, the tall filter inside the bag compartment would be my next suggestion and since you changed this it should not be a problem. This leaves few possible problems. Circut board error/Sensor error would be my next step. Essentally its one in the same, but there is no great way to test them without simply replacing parts. (an expensive proposition) The local sebo dealer will more than likely have a working used board they pop in and out to check for problems. Some dealers may let you use these others will require you either buy the parts or pay for labor.
\015\012
\015\012*Bad boards in sebo/windsor products are extremely rare, my bet is always on a plugged filter or plug in general. Be sure to look carefully something as small as a toothpick surrounded by carpet fuzz can set them off.
\015\012
\015\012Best of Luck
Repair Help & Product Troubleshooting for Sebo Automatic X1 Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Full bag clog light


1.If your sebo is less than five years old, you have a reciept, and are not using it commercially, in most cases this machine will still be under factory warranty. To locate \015\012an authorized sebo dealer simply ... Sebo Automatic X1 Bagged Upright Vacuum

It's an upright, model X4. The bag full or clogged light is lit. I've takent the thing apart and cleaned it out, and removed some clogs. But the light won't go out and when I run it, it stops after a minute or so. Also, the pedal for lowering the machine to use it has come off and I can't figure out how to reattach it.


There is a short hose inside the housing where the roller is. Did you unclogg this as well? ... Sebo Vacuums

Sebo X14 -red light comes in for clog or bag full. , bag is new. Cleaned out all clogs


Unless the circuit board is bad, you still have a clog, Either in the hose, or the dirt inlet by the brush roll. ... Sebo Vacuums

Sebo upright vacuum cleaner - Bag full or clog light on constantly when using as an upright but not when using detachment pipe. Bag changed and no sign of blockage. Is this a common fault or does it need to be taken apart by an authorised repairer?


Hello,\015\012\015\012I have actually written an in depth trouble shooting guide on how to find the clog in your Sebo. Since this light is coming on only when you have the wand inserted into the vacuum and are vacuuming the floor, this i ... Vacuums

Light on for "full bag or clog." I changed bag,


Check the airflow tube behind the brush. This is a common place for clogs. The hose is more common, especially at elbows, like where it attaches to the tank. Another possibility is a dirty filter. Check this first to rule it out, then check the r ... Sebo Automatic X1 Bagged Upright Vacuum

Red light comes on saying bag full or clogged. Bag has only recently been changed so what do I look at next?


You look for a blockage - almost certainly in the flexible hose. Remove the hose from the machine completely (both ends, that is), then switch the machine on and the red light should not come on unless you block the hole on the top of the bag compart ... Sebo X4 Bagged Upright Vacuum

Light saying bag full and clogged have changed bagand checked for blocks cant find anything.


OK - blockages are not always obvious (especially if they are deep within the flexible hose). One thing you can try is to remove the flexible hose from the top of the bag compartment and then switch on - if the red light goes out, there's a blockage ... Sebo Automatic X1 Bagged Upright Vacuum

When I turned on the sweeper it would not start. I put a different power cord on it and it worked fine. now it won't start but the light on the brush and the bag full will flash when i turn it on and off but it wont start. i have 2 of these doing the same thing. do you have any idea what could be wrong. I have checked for clogs but have found none. Bob


Its sounds to me like the computer board inside the machine has gone bad. Keep in mind that the filters in these machine do need to be replaced regularly to keep the vacuum working correctly. Any good vacuum shop should be able to fix your problem. R ... Windsor SR12 Sensor Bagged Upright Vacuum

Bag light shows bag is full and shuts off.


It sounds like you have a bad control valve. The best thing to do is take it to an Aerus Electrolux dealer and have them replace it for you. It shouldn't be very expensive and they can probably do it while you wait. Good Luck! ... Electrolux UltraLux 2000 Bagged Canister Vacuum

While vacuuming the red light for the bag of the vacuum came on and the vacuum stopped. The bag was no where near full so I replaced it with a new bag - same problem. It vaccumes for a minute or then stops with bag light on. It is the correct bag for the machine - so what's the problem?


I'm assuming this is the Epic 6500 or similar model.\015\012Detach the hose, turn vacuum on. If it runs, place palm of hand against inport hole. If it shuts off the problem is with either the control valve setting or the control valve assembl ... Electrolux Vacuums

My electrolux vac shut off for a full bag. After replacing the bag the vac won't start and the bag full light stays on.What should I be looking for to resolve my problem?


If the suggestion that renevacdoc did not work, it is most likely that your valve assembly(full bag control) has gone bad and needs to be replaced. You will have to take your vac to the Aerus/Electrolux dealer/service store for repair. ... Electrolux UltraLux 2000 Bagged Canister Vacuum

'Bag Full' light indicates at 1/3 bag


The sensor is a small hole into the vacuum chamber. It moves the alert system as vacuum inside the unit builds up.\015\012\015\012The filtration, built into the bag, is getting filled up and creating a higher vacuum inside the unit, givi ... Windsor SR12 Sensor Bagged Upright Vacuum

I have the Miele S7280...the one without the clog hatch on the back. I took the bag cover off, then continued the remove the screws and cover underneath it to detatch the top from the bottom. Found the clog and cleaned it out. Heres the problem...now the power nozzle light comes on and the vacuum "on" is lite up red, but it will not come on. Checked the filters and the bag. It certaintly seems like the top and bottom are meeting up to latch into each other, but I have no power. Help!!


... Miele S7210 Bagged Upright Vacuum

Aerus Lux 7000: the full bag light keeps coming on but the bag is not full.


Electrolux uses a pressure differential control valve. This valve measures air before and after the bag. There is a orfice or small hole where the hose connects to the vacuum cleaner, and a orice at the back of the bag canister. As the bag fills up t ... Electrolux Lux 7000 Bagged Canister Vacuum

I replaced the bag full, but the bag full light stays on.


This is most likely due to a broken, worn, or clogged control valve assembly (CVA). You can try resetting the dial to the smallest dot, but I'm not sure that will work for you.\015\012Detach hose from vacuum. Turn vacuum on. If it runs, plac ... Electrolux Epic 6500 Vacuum

Full bag indicator light is on, just changed the bag. Motor turns on the cuts off immediately. I already paid $10.00 and there was no solution. I have an E2000 Does anyone know what all the symbols mean when they light up?


Turn the dial on the top of the vacuum all the way to the right and try it again. ... Electrolux UltraLux 2000 Bagged Canister Vacuum

My Dirt Devil M082476 Full Bag indicator light keeps coming on when I turn my vacum up to full intensity. I have tried changing the bag and checked that all hose is clear. If I leave the vacum on low intensity the suction is minimal and does not increas when I turn up the suction. Is there a solution to this? I look forward to your response


... Dirt Devil M084105 Jaguar Vacuum

Electrolux upright bag light stays on even when bag is not full


I took the hose off and discovered it was clogged very tight. There was a piece of a 3 inch wire also stuck in there. Thank you for your quick response. Have a great New Year!!!!! ... Electrolux UltraLux 2000 Bagged Canister Vacuum

Sebo x4 bag full light not working


Replace bulb ... Sebo X4 Bagged Upright Vacuum

The light for bag full is always on. model C104A electrolux.


... Electrolux Vacuums

I have the electrolux guardian-My full bag light indicater is coming on even with a new bag. It gets worst-the machine will cut off when I insert the hose or put my hand over the hole where the hose goes. I changed the filter on the back and put in a new bag. Help please :)


Hi,\015\012Check your hose you have something stuck in the hose...stretch it out straight and run something through it to push out whatever is stuck in there...\015\012\015\012heatman101 ... Electrolux Guardian Bagged Canister Vacuum

I have the Aerus Lux7000-My full bag light indicater is coming on even with a new bag. It gets worst-the machine will cut off when I insert the hose or put my hand over the hole where the hose goes. I changed the filter on the back and put in a new bag. Help please :)


Hi, you very likely have a defective control valve under the dial on top of\015\012the vac , or a kink or blockage in the tiny pressure hose that feeds\015\012the air from the throat of the vac or the back of the bag chamber\015\012against the two si ... Electrolux Guardian Bagged Canister Vacuum

When you put your hand over suction it shuts off and the bag light goes on it acts like the bag is full but its aq brand new bag


So what's the problem? Stop blocking the suction with your hand! The machine can't tell the difference between a blockage caused by your hand and a blockage caused by a full bag. Just be grateful that you've got a machine with such good protection. ... Vacuums

Model 2100 canister: Red light comes on to indicate bag is full and machine shuts off. The bag is empty...when I readjust bag, machine will start up again but shut down shortly.


Try this \015\012Electrolux LE, 2100 Hi Tech Canister ... Vacuums

Won't start. My son was using the vacuum & Didn't change the bag. The vacuum was making the full bag smell, but the light was't on & it didn't stop. I stopped him, changed the bag, checked the filter, closed the compartments & turned on the vacuum. Nothing happened. I checked to be sure that it was plugged in, that wasn't the problem. I've let the vacuum "rest" for several days, It still won't start. Any suggestions?


There is a reset button at the back of the powerhead. The user manual can be downloaded from the electrolux website, although I didn't find it very useful. There was some info on how to change the powerhead drive belt. ... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0382 seconds