Having problems with your Sebo K1 airbelt Bagged Canister Vacuum ?

Taking off the bumper from A Sebo K1 Airbelt - Sebo K1 airbelt Bagged Canister Vacuum


Answers :

First, remove the clip at the back of the machine where the airbelt joins (lever it off carefully with a screwdriver). The airbelt is in two parts - the bulky foam strip and a thin material cover. The cover is held in grooves, top and bottom, running all the way round the machine, by two thin plastic strips around which it is wrapped and which just slip into those grooves. The challenge is to get those strips, and the covering material, out without damaging them. Just prise one end out with a small screwdriver and work your way around the machine - it's more a matter of patience than anything else.
Repair Help & Product Troubleshooting for Sebo K1 airbelt Bagged Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Taking off the bumper from A Sebo K1 Airbelt - Sebo K1 airbelt Bagged Canister Vacuum


First, remove the clip at the back of the machine where the airbelt joins (lever it off carefully with a screwdriver). The airbelt is in two parts - the bulky foam strip and a thin material cover. The cover is held in grooves, top and botto ... Sebo K1 airbelt Bagged Canister Vacuum

Airbelt k1 komfort 2100 cylinder spool - Sebo K1 airbelt Bagged Canister Vacuum


... Sebo K1 airbelt Bagged Canister Vacuum

Cord reel for sebo airbelt d - Sebo Air Belt K2 Bagged Canister Vacuum


... Sebo Air Belt K2 Bagged Canister Vacuum

How to access the motor - Sebo K1 airbelt Bagged Canister Vacuum


OK, but be warned... it's not so difficult getting the thing apart, but making a neat job of reassembly has been known to drive grown men to despair. And that's because you have to remove the airbelt. But first things first:1. remov ... Sebo K1 airbelt Bagged Canister Vacuum

I have an Ecectrolux Epic canister vacuum. As soon as it starts sucking, the vacuum cuts off. I put a new filter and bag in, but it doesn't seem to help. If I open the front where the bag goes, take the bag out and depress the safety button the vacuum will run. Need some help or direction. Thank you


Try this.\015\012Disconnect hose. Turn machine on and place hand over intake. If it shuts off immediately, first try turning dial on top of machine so largest dot matches up with arrow. Turn on and place hand over intake again. If it still ... Electrolux Vacuums

Take handle apart sebo vacuum - Sebo Automatic X1 Bagged Upright Vacuum


... Sebo Automatic X1 Bagged Upright Vacuum

How to take canister apart electrolux 2000 - Electrolux UltraLux 2000 Bagged Canister Vacuum


... Electrolux UltraLux 2000 Bagged Canister Vacuum

Electrolux Diplomat canister vacuum. The bag light comes on and it stops. It has to do with the hose because if I take the hose off, then the vacuum keeps running. I can't see anything blocking the connection. any suggestions on what else to look at?


... Electrolux Vacuums

How do I turn it on? - Sebo Air belt K3 Bagged Canister Vacuum


... Sebo Air belt K3 Bagged Canister Vacuum

Found old J.C Penny vacuum cleaner on garage, looks industrial, canister model. It takes intake from the front but just expels it off the back. After opening, I see it needs a bag and a filter, the model is J.C Penny wet/dry 10 gal. MOD-SVP-017 Catalog # 824-4327. Unable to find any info on the web regarding it. Any help??


... Vacuums

Machine keeps cutting out intermittenly - Sebo Air Belt C2.1 Bagged Canister Vacuum


My Sebo Air Belt C2 Total. The automatic electric cable wire won't stay out when pulled, it just springs back. When I'm hoovering I have to wrap the wire around the small wheels so that it doesn't shoot back in the machine. ... Sebo Air Belt C2.1 Bagged Canister Vacuum

Taking apart the wand - Miele S251i Plus Bagged Canister Vacuum


Try this linkhttp://www.totalvac.com/manuals/miele-vacuum-S2000-manual.pdf ... Miele S251i Plus Bagged Canister Vacuum

I just purchased a Sebo Airbelt D canister vacuum. I plugged it in and used it for ten seconds then turned it off, retracted the power cord and now cannot get the power cord out of the machine. Did I not spend enough money to get a quality product? Does anyone have any idea how to get the power cord out without breaking the machine?


... Vacuums

How do you take the handle off of the hose - Electrolux Guardian Bagged Canister Vacuum


Give me more details about your question ... Electrolux Guardian Bagged Canister Vacuum

Overheated vacuum After I finished vacuuming the library last night I changed the bag and shook out both filters and vacuum would not restart. The canister unit felt real warm to the touch but I had been using it a least 1/2 hour non stop. The bag was pretty full but not overly so. It's a Simplicity canister with power head. The carpet is long shag from the 70's Did it just over heat? Thanks Shauna


It normally won't over heat unless the bag is too full, the filters are clogged, or you have have a clog in the hose or down by the brush roll, the inlet may be clogged. Some will restart after a while, some others have a reset to push. If it won't ... Simplicity 7850 Premier Bagged Canister Vacuum

Need technical help for my miele s2180 momentum canister vacuum .Bought a display open box at fure shop..Came with a filter bag..there are no tears in the bag...Perhaps they put the wrong bag..Anyway after 30 minutes of use..The motor stopped working ..so I opened up the unit only to see,.the dirt was everywhere inside the vacuum...only a little was in the bag itself..can you hepl..Dave


... Vacuums

My Hoover s5620 central vacuum is not sucking. I cleaned out the canister and vacuumed the inside bag in the canister. The hose is clear as is the central vacuums tubing. Any suggestions ?


Try getting some compressed air source and blow back whatever is stuck in the hose. ... Vacuums

Lid to kenmore canister 360 hepa vacuum cleaner, lid to change vacuum bag stuck in open position


GoVaacuum2,\012\012I have the same problem and that didn't work.. ... Kenmore 25512/ 25513 Progressive Canister Vacuum

I have an old Miele canister vacuum and I do not know how to disassemble the hose to check for a clog. I think it sucked up a nerf ball the size of a ping pong ball. I changed the bag but it did isn't appear to be in the bag. The vacuum powers on but I do not have suction with the hose, and since the hose has hard plastic elbow joints I do not want to pry them apart and break it


Hi Emily: If you have the model number for your machine you may be able to find your manual on the Miele website. Check ... Miele Vacuums

My canister vacuum is losing suction (oreck) - Oreck Super-Deluxe BB870AD Bagged Canister Vacuum


... Oreck Super-Deluxe BB870AD Bagged Canister Vacuum

The vacuum stopped working when i was vacuuming. The bag had a hole in it so all the dirt and stuff where clogging the filters. I cleaned them and put a new bag in but it will not turn back on. So I want to take it apart to see if there is more dirt on the inside,


... Fuller Brush FB-PT2 Vacuum

Kenmore canister vacuum how to replace belt - Kenmore 22313 Bagged Canister Vacuum


... Kenmore 22313 Bagged Canister Vacuum

Poor suction on Sebo x4 - new bag inserted - Sebo X4 Extra Bagged Upright Vacuum


... Sebo X4 Extra Bagged Upright Vacuum

Need a hose for shark ep 238 canister vacuum - Euro-Pro HEPA Shark EP238 Bagged Canister Vacuum


... Euro-Pro HEPA Shark EP238 Bagged Canister Vacuum

Change bag in magic blue vacuum - Kenmore Magic Blue 24195 Bagged Canister Vacuum


... Kenmore Magic Blue 24195 Bagged Canister Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1167 seconds