Having problems with your Sebo K1 airbelt Bagged Canister Vacuum ?

Sebo k1 komfort switch

\015 Switch not working\015

Answers :

Repair Help & Product Troubleshooting for Sebo K1 airbelt Bagged Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Sebo k1 komfort switch


... Sebo K1 airbelt Bagged Canister Vacuum

My Sebo X1 stopped working and my husband tested it and determined that the on off switch was not working. I purchased a replacement switch online but I cannot figure out how to remove the old switch. Please can you help?


Thanks for your question!I'm sorry that you haven't received an answer yet.The response rate on FixYa FREE questions is usually over 80%, but sometimes questions go un-answered when:1. the question is unclear, incomplete, or poorly ... Sebo Automatic X1 Bagged Upright Vacuum

My Sebo X1 stopped working and my husband tested it and determined that the on off switch was not working. I purchased a replacement switch online but I cannot figure out how to remove the old switch. Please can you help?


Www.manualnguide.com/manual/sebo-x1-repair/page/3/\015\012\015\012Above is your user manual, and below is an exploded diagram so you can see where it all goes. Find all the screws lock ... Sebo Automatic X1 Bagged Upright Vacuum

Hi, I have a Sebo X4 which is almost 3 years old. I haven't had any problems with it until the last couple of days when I notice a slight screeching noise when in upright position, coming from the roller mechanism area. If I slightly push the sebo forwards it gets worse, if I tip it back it stops. If I take the roller out and switch on, there is no noise. I have always been careful not to tip the machine forwards when using the hose, but I recently lent it to a friend whose hoover had broken do


I dismantled the top part of the machine from the bottom and there stuck right down in the bowels of the tubes was a piece of card, a dress label! somehow it was only making a noise when the machine was in an upright position. It took a bit of stretc ... Sebo X4 Bagged Upright Vacuum

My Sebo automatic X1 has stopped working Every time I attempt to switch it on the only thing that happens is the bag and roller warning lights flash briefly. This suggests the power is ok but the Sebo doesn't start. Any suggestions?


Check for clogs, and also check the brush rollers' belt.Really, i think you should take it to a vacuum shop and have it inspected for problems ... Sebo Automatic X1 Bagged Upright Vacuum

Sebo automatic X1. After switching on the motor


As sure as possible without actually seeing your machine, the carbon brushes on the motor are worn out. They are quite easy to replace (and not expensive). If you need help with doing the job, just post a reply here and I'll guide you as best I can. ... Sebo Automatic X1 Bagged Upright Vacuum

Sebo automatic x1 - switch


Have a vacuum store look at this ... Sebo Automatic X1 Bagged Upright Vacuum

Paul, I have samer problem with SEBO X4 height adjuster. Please can you explain to me where to locate the reed switch and magnet.


... Sebo X4 Bagged Upright Vacuum

SEBO 360 will not run when turned on. How do you test power cord and switch?


Here is a video that will demonstrate how to check cord and switch ... Sebo 370 Bagged Upright Vacuum

Sebo X4 when switched on bag full and check brush lights momentarily light up then go off and motor doesnt work


... Sebo X4 Bagged Upright Vacuum

Faithful Sebo X1 upright, about 12 years old, stopped working today. I replaced old with new dust bag, checked all dust paths were clear, checked main brush was clear/clean, and drive spindle rotated OK with fingers. When power switched on, the two red indicators briefly flash on then off, but nothing more happens, motor does not start - even with power reaching machine. Tried removing all consumables, refitting and turning on a few times to reset, no joy. Removed base cover, both belts were i


At 12 years, this vacuum has had a good long life. I suspect the motor is shot, but it could be due to faulty wiring and connections. A bad switch, break in the power cord, and worn brushes in the motor are other causes.\015\012I recommend ta ... Sebo Automatic X1 Bagged Upright Vacuum

My Sebo hoover trips the house mains sockets every time I switch it on, yet doesn't trip the kitchen mains. Have replaced filters/bag to reduce load but still no good. What should I be investigating in the hoover? Thanks


Hello,It sounds like your vacuum is fine if it works when plugged in the kitchen outlet. It is tripping the breaker switch in the other room because the circuit is overloaded (too many things plugged in this circuit). Try unplugging some things ... Sebo Air Belt C2.1 Bagged Canister Vacuum

Hiya...my Sebo hoover is hoovering well on wooden floors but when it comes to carpet its not switching to pick up on carpet? Is it a quick fix ?


... Sebo Air Belt C2.1 Bagged Canister Vacuum

Airbelt k1 komfort 2100 cylinder spool - Sebo K1 airbelt Bagged Canister Vacuum


... Sebo K1 airbelt Bagged Canister Vacuum

10 yr old sebo won't work - rapid clicking noise (relay?) when switched on, no motor or brush - any ideas?


... Sebo Automatic X1 Bagged Upright Vacuum

Spare wire? My SEBO X4 flex had to have the fex shortened because the cable sheathing had come out of the internal gripper and there was a couple of inches of two strand wire hanging out the cable entry point before the insulation sheathing started. No problem doing this but on the live switch terminal there was a piggy back spade connector. The second wire from this went down inside the handle and just ended with a bare terminal hanging in space. It hadn't come off anything, there wasn't anyth


Greetings from GoVacuum.com,I took a picture of the Sebo X4 wiring in the handle of the machine for you. This is a brand new machine taken out of the box, this is how the wiring should look. You'll see that there are 5 total wires here. ... Sebo Automatic X1 Bagged Upright Vacuum

SEBO Dart I need a wiring diagram or instructions for the switch


... Sebo Automatic X1 Bagged Upright Vacuum

When I flip the switch on my sebo x1 upright, a red light comes to the brush and bag icons. However, I cleaned out the hose and checked to make sure there is no obstruction from the brush to the hose also, or from the hose to the bag. It is clear that juice is coming to the vacuum, but there is no sign of life except the two red lights.


Thanks for contacting fixya. You should pull out the bag and reset the machine. You should take all the user replaceable items. And turn it on. You will get lot of errors. Then turn the machine off. Put back all the accessor ... Sebo Automatic X1 Bagged Upright Vacuum

How do I change a mains cable on a sebo K1 komfort


... Sebo K1 airbelt Bagged Canister Vacuum

Hiya, I have a Sebo X4. It switches on fine, but the up, check brush and clog light are all flashing at the same time. What can i do to fix it?


... Sebo X4 Bagged Upright Vacuum

Sebo x1.1 - burning smell


Try replacing the belt. My vacuum cleaner had the same problem and once the belt was changed the burning smell was gone. ... Sebo Automatic X1 Bagged Upright Vacuum

Sebo vacuum cleaner cuts out ?why


It might be the bag.just check with your local vacuum store ... Sebo X4 Bagged Upright Vacuum

My Sebo AirBelt K1 just stopped working


I work with a Sebo dealer (in the UK), where we repair all makes of vacuum cleaner. It's testimony to the quality of Sebos that in several years I've only had one of this model to repair (so my memory is somewhat sketchy). \015\012However, from first ... Sebo K1 airbelt Bagged Canister Vacuum

Will Sebo K1 blow as well as ****?


Sorry, but the answer is - no, it won't! ... Vacuums

We have a dyson dc 07 animal the machine was working fine then switched off after returning to the machine minutes later it wouldnt switch on, i removed on off switch cover and used a short piece of wire across the brown wires flicked the wall switch and it worked, aha i thought faulty switch aquired a new one to no avail and now even the short piece of wire trick doesnt work, has the motor died do you think, it wasnt over heating or making strange noises prior to refusing to work


It could be the motor. I'm having to replace the brushes on my DC 05. It appears that you can only get brushes for the YDK motors in the DYSON, not the Panasonic motor. Which might be saying something about the YDK motors. What happens is that the ca ... Dyson DC05 Cylinder Bagless Canister Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0397 seconds