Having problems with your Shark Vacuums ?

Missing plug for Shark intelligent electonic 2 speed control sweeper


Answers :

Repair Help & Product Troubleshooting for Shark Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Missing plug for Shark intelligent electonic 2 speed control sweeper


... Shark Vacuums

SHARK CORDLESS SWEEPER 3 SPEED CONTROL FLOOR, CARPET, TURBO BATTERY EURO-PRO 8.4V - 1.3 Ah SB617U 3305 BELT Turned on and almost immediately turned off At least four years old - not used all the time - not used in six months Checked belt - seems O.K. Do I need a new battery, if so, where do I get one? Or should I just get a new sweeper? Cost?


... Vacuums

Vacuum cleaner We have a panasonic MC-E47electronic which seems dead. It has a speed control which we nearly always had on full anyway. Have tested continuity through plug, flex and on/off switch and all OK. from then is open circuit through speed control which consist of slide rheostat and mystery small green box (2cm x 2cm x 1cm approx). Across motor there is negligable resistance. Machine is quite old and not worth paying out loads on poarts if it is safe to bypass speed control and connect


Yes it is safe, but i would make a switch? ... Vacuums

Loose handle on shark v1950 sweeper - Shark Euro-Pro V1950 VX3 Rechargeable Stick Broom Sweeper, 13" Motorized Brush Roll, Folding Handle, 2 Speeds, 50 Min Cleaning, Carpets & Floors


... Shark Euro-Pro V1950 VX3 Rechargeable Stick Broom Sweeper, 13" Motorized Brush Roll, Folding Handle, 2 Speeds, 50 Min Cleaning, Carpets & Floors

My shark bagless sweeper worked for about 6 months. Like a previous blogger, I caught the edge of a rug that jammed the sweeper, three red lights blink, the brush is free moving yet the sweeper will not work. I did leave it plugged in all the time otherwise it would not run but for minutes. Very disappointed. New battery? what if that doesn't work? is it junk then, money down the drain.


This will probably cost you more to repair than to buy a new one. Does it turn on at all? ... Euro-Pro Cordless Bagless Upright Sweeper - Blue/Gray

The battery will not charge in the sweeper. I can remove the battery and wire it to the power supply for charging and it will charge up and run the sweeper. So the power supply and the battery are both good. Obviously there is a circuit failure in the on board charging control. Anyone know a fix or a likely faulty component? I had a shark handheld about 8 years ago and it developed the same problem. I examined the little circuit board inside but saw no visible indications that would isolate t


... Euro-Pro Cordless Bagless Upright Sweeper - Blue/Gray

Mu Shark Electonic Steam Mop, Model SE200 is new, straight out of the box. I have followed all directions, plugged in, blue light flashing, pressed button for steam, and no steam. I have done all of the trouble shooting and still no steam. What is the problem?


... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Shark V1917-SI Cordless 3 Speed Sweeper


... Vacuums

Oreck trouble I replaced the plug and switch. black from motor to pole 1, black from plug to pole 2, white tied to white with a wire nut. When I plug it in it is powered in the off position. I have high speed at the high speed position, low speed at the low and off positions. Any ideas?


... Oreck XL Ultra Bagged Upright Vacuum

Shark VX3 cordless sweeper making loud noise - Euro Pro Shark Vx3 Floor & Carpet Sweeper - EU-V1950


... Euro Pro Shark Vx3 Floor & Carpet Sweeper - EU-V1950

When I charge my shark vacume sweeper is the green light saposed to be on ? I'm trying to charge the battery for he first time. I do not have a manual. this is a factory rebuilt model #V1950 The brand is Shark cordless sweeper.


... Vacuums

I just bought kaz model K76P (M) humidifier in Kyoto. I filled it to the right water level (a bit below) and plugged it in (nothing else is plugged in at that socket). The light comes on, but the water doesn't heat up. I can't read Japanese so can't read the instruction manual but it seems a simple procedure: fill with water, set the heating thing the water, plug in. Am I missing something or is the humidifier defect?


Take it back to the shop it should work and even though its in japanese ,they will know if your doing it wrong ,but i think it may have a damaged heater or a wire off where its been in transit ... Vacuums

Royal vacuum cleaner model 4600 wiring diagram I have a Royal Vacumm Power Tank Model 4600. I replaced the switch (6 wire - 3 position) that is on the tank. One side of the switch control just the blower. The other side control the blower and the POWER head - wand with a variable control speed. The middkle position is off. After I installed the swith, the power head - wand is powered in either position. There are three wires comming out of the wand: White, Red and Black. I guess I wired somethin


... Vacuums

My HEPA Shark Model 238 is great when the moter operates at high speed. However, periodically, it slows down resulting in no turbo action and virtually no pick up of eve the lighted dustball! Sometimes a good swift kick will bring the moter speed back to "HI", but sometimes no matter what, it won't speed up.rnHELP!


If the motor is over heating, it will slow down and may even stop all together. A solid knock could reset the thermal switch prematurely. Clean it as best you can around the motor and try it again. If it does the same thing, turn it off for 20 minute ... Euro-Pro HEPA Shark EP238 Bagged Canister Vacuum

I bout this vacume in mid December 07 and about February-March it started not picking up the dust on the floor. So in early April I bout a new filter and it still wasn't picking up the way it had in the beginning. I've taken it a part several times and cleaned it out with it being plugged at the bottom hose with dust bunnies. Well I just took it back to Walmart where I purchased it and I failed to keep the reciet they could not do any thing about the sweeper. I went back to the sweepers and re


Pull the hose out of the holder, is there suction there. If not, then there is a clog in the hose. If there is suction, then check the dirt outlet by the brush roll. Also if the belt is slipping, it may appear to not have as much suction, belts wi ... Dirt Devil Vacuums

I HAVE A NEW SHARK STEAM CLEANER - PURPLE - I PUT ABOUT 1/2 CONTAINER OF WATER - PLUGGED IT IN AND NO STEAM??? WHAT AM I DOING WRONG THE BLUE LIGHT SHARK IS LIT UP


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have a Dirt Devil magnum MPR and the problem is that after working for some minutes it slows down and then works at an erratic speed. I suspect it is the speed control pot. Any help? Thanks


... Vacuums

Hooked everything up per directions. I plugged it in to the closest electrical outlet and nothing happened. The lights did not light up, the connected wall control and sensors leds do not light up. It appears the unit doesn't have power. The electrical outlet socket is fine as everything else I plug into it works fine. I have tried every other electrical outlet available. The unit won't power on from any outlet, and all of those outlets run other things, like power tools an refrigerators


Dear Davehibshman,Firstly; dismantle the plug and replace the fuse with the same rating as the one you have just taken out. Replace the plug cover, put the plug into the socket and try again. If this doesnt work, there may be a problem wi ... Vacuums

Shark steamer will not work. no light on,no heat, no steam. yes it is plugged in and plug works on other appliance. give me a phone number. prefer talk to live body. thank you.


The number is 1-800-798-7398.\015\012Here's the Shark site for chat help. The second link provides phone number and other info.\015\012They will need to know the model number.\015\012\015\012 ... Euro-Pro Vacuums

The unit has no power to it. The plug in which the unit is plugged has been tested and is fine. Unfortunately I'm not at the property as it's a rental. Is there something obvious that we are missing?


... Hayden Industries SuperVac 2400 Central System Vacuum

I have an older Bernina 830 Record sewing machine and I've noticed that it makes a growling noise when I first step on the foot control with the machine in the low speed setting. The noise goes away when the speed picks up. Is this serious? What's the fix?


... Vacuums

Sweeper belt Hey , i own a fantom thunder sweeper and recently my belt keeps slipping off, i've disassembled it and put it back on a hundred times but it keeps doing it after a few minutes of cleaning , Am i missing a part to hold it on or somthing else wrong i've cleaned it and checked all the ports just cant figure it out and cant find any info online thanks for your time tina


Greetings from GoVacuum.com,Have you replaced the belt with a new one yet? You may want to try replacing the belt, as with flat belts like the Fantom Thunder, they do stretch out 4 -5 inches after time. We in fact recommended replacing ... Fantom Vacums XT450K Upright Vacuum

I have a Kenmore canister vacuum - model 25614506. Some time ago, I was not able to turn the vacuum off with the on/off switch, but could still use the vacuum. Turned if off/on by pulling the plug. The other day when I went to plug it in, I heard a pop. Now the sweeper runs but the vacuum cleaner does not **** - no air flow. What could be the problem. The cleaner is only 4 years old.


The motor has an inline fuse ... Kenmore 25614 / 25615 Progressive Bagged Canister Vacuum

I bought a Hampton Bay Hawkins 44 " ceiling fan (117 391) and would like a remote that I can control the speeds with not just the on and off. I have a pull chain for the speeds but would like to use a remote instead. Is this possible? I have a Hampton Bay Redington IV and love the remote. I'm looking for something like that. Thanks Madeline Lepisto


... Vacuums

The charge light no longer turns red when plugged in and in spite of being plugged in does not seem to accept a charge any longer. I miss the vac use of my flipease!


Providing the charger is working must be the battery or input socket. Get charger checked out 1st... ... Bissell 52889 Flip-Ease All-in-One Vacuum and Mop Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0369 seconds