Having problems with your Shop Vac 585-08-00 Wet/Dry Vacuum ?


\015 Can I buy wheels and the support that slide on unit to hold the wheels.\015\012I just bought this unit but some one took off the wheel and 2 of the supports. The unit is like new but I would like to buy these parts .\015\012Thanks \015\[email protected]\015\012Dale Echols\015

Answers :

Repair Help & Product Troubleshooting for Shop Vac 585-08-00 Wet/Dry Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :


Contact the manufacturer http://www.shopvacstore.com/shopvac-accessories.php?srcad=shop+vac+parts. ... Shop Vac 585-08-00 Wet/Dry Vacuum

How do you wire a 2 speed fq motor. I know the blue/blue. the red/red. The yellow /yellow and I believe the whites together with the grey of the pn outlet. Does the black from the motor the black from the cord and the other grey from the pn outlet connect together ?

I have not seen the new two speed but sounds like the wiring is coded to teh switch by colorOn a single speed it would be this way.\015\012\015\012Power cord to side 1 of switch.\015\012Switch to motor 1 and PN receptacle 1, etc ... Filter Queen Cheetah II Ash - MU305 Bagless Canister Vacuum

Hi , I have an Electrolux powerplus 1800 hoover Z4492 the hose that attaches to the telescopic pipe snapped and tried to get out the grey plastic out in one bit but it snapped ..if i got another telescopic pipe would it come with the grey tube that sits in the hole to keep the hose in place ?

... Electrolux Vacuums

On the rear of the G5D Kirby there is 2 levers that mash with your foot , one is grey and marked with an "N" the other is green and marked "D", what is its purpose

Hi,"D" is for Drive, "N" is for Neutral. You cannot use the vacuum or even roll it into another room until the D is depressed. I believe Neutral is for bag and filter changes, repairs, etc. My thought is that it is designed that way so yo ... Kirby G5 Bagged Upright Vacuum

My grey & purple steam mop is getting very little steam at the head. is there a way to clean it without damaging the product? or is there another solution for low steam?

Mixing white vinegar with water about a cup of vinegar and a cup of water ratio and let it steam through the mop. This is also good for steam irons and other appliances such as coffee/tea makers. The acetic acid in the vinegar will dissolve the calci ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have bought new filters for my hoover sensory 2300w . Which way do I replace the the pre motor filter? White side inwards or grey side inwards ?

... Hoover Vacuums

I badly need a replacement for the small elasticized grey cloth part (filter??) that fits over the plastic form inside of the hand vac of GE Combiination Vac Bagless System---model 106687, type A. Can you just tell me if the name of that part is the filter? I did find one on a website but there's no image available and I don't want to order the wrong thing. Thank you.

... GE Combination 106687 Upright Vacuum

Shark steam mop will not syeam grey pruple shark steam mop

My Shark Pro QUIT Steaming so I took the mop head part off put some vinegar and hot water in water tank plugged it in and set to steam at highest setting I could see a tiny bit of steam coming out so I took a tooth pick and pushed in the tiny hole ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Steam is coming fromthe join between the white base and the grey plastic on which the iron sits.How do I separate the two plastic mouldings so that I can see the problem

Hi,\015\012\015\012You probably wont like the answer, but the unfortunate truth is that you don't separate the plastic mouldings. They are bonded together. Irons do not contain any user serviceable parts.\015\012\015\012If you ... Vacuums

My walkie talkies won't turn on. We've only used them a few times, and not recently. I charged the batteries, but it doesn't seem to want to switch on. I've pushed that grey side button. Is it possible that it's locked off? And, same problem is with both of them. Seems a basic question, I know. They should be working though. Thanks, Bruce

... Vacuums

Dear Sir: I just purchased a Bissell Rug Shampooer at a garage sale. The only thing I find for a model is on the back and it says Model 1695 there. Nothing on front. It is Navy blue and has a grey tank on it with a smaller one inserted at bottom of the large tank. It has two switches on the back of it and the trigger switch at the handle. The cleaner works, BUT, it does not extract any water back into the tank that is to pick up the dirty water. Could you suggest what I may look at t

... Bissell Vacuums

Im trying to replace the cloth bag on my Kirby G6. How do I release the belt that holds the cloth bag at the bottom of the assembly? It is grey and has teeth that grab when tightened on the bottom of the unit.

Kirby G6\015\012Im trying to replace the cloth bag on my Kirby G6. How do I release the belt that holds the cloth bag at the bottom of the assembly? It is grey and has teeth that grab when tightened on the bottom of the unit. ... Vacuums

Explain how to re-wire 16gal craftsman shopvac,switch wires are- 2 orange wires, one white, one black and one green(grd wire), I pulled them off and don't where each wire goes.

Im not looking at a diagram of your machine.\015\012\015\012Typically, in a switch circuit ... the green goes through; the white goes through; the black is broken by the switch.\015\012\015\012The two orange wires you speak of ... Vacuums

My vacuum pole has an extra grey pole attached to it how do i get this off

Hi,\015\012this manual will help you out to get ridd off it http://www.retrevo.com/samples/Electrolux-Vacuum-manuals.html\015\012 ... Electrolux Vacuums

Dyson DC07 My DC07 cuts out after 5 mins and I want to replace the thermal cutout. I have cleaned it thoroughly, including the cyclones but it still cuts out. How does the plastic moulding around the motor dismantle? I have started by removing the 4 torx screws but the upper grey housing does not want to detach and I am worried about breaking the plastic. Appreciate any advice.

Try this page: -http://www.fixya.com/support/t192124-overheating_dyson_dc07Regards Gualo ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I have a DC-17 Absolute. It makes a horrible noise when the grey button is pushed. The brushes rotate and I checked for clogs...can't stop the noise

... Dyson All Floors Plus HEPA Bagless Vacuum

We have a bissell and it the one to clean the carpet how do we use it i no to put hot tap water and turn it on and hold the grey thing to make the soap come out but nothing is picking up well i dont see nothing

Take this link to Bissel website, select your model and download yor free operation manual.\015\012\015\012http://www.bissell.com/ ... Vacuums

I can't open it to clean it, please help! I know I have to pull the grey cover, and I have tried hard but no luck. Seems attached from the bottom, so I am not sure how it will come out. Thank you for your help.

I had the same problem. It normally opens with a little tug on the door but if you are like me and you let it fill up with a year's worth of pet hair etc., the door will jam. The only option is to ... SweepEZE 600 C-1 Canister Vacuum

It leaks the nozzle at the bottom jam and burnt around the hole ,can this grey part be replaced or toss the hole thing out

\012\012\012Hi,Here\012is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it\012may not be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

White & grey model Roomba is moving much slower on carpet since I replaced battery and filter, but moves normal speed on linolium. How do I fix this?

You need to adjust the "Brush Height String" The new battery is a bit heavier than the old ( by 10 ounces if you got the new battery) dis assemble the roomba and you will see a string attached to a screw which allows the brushes to rise and fall with ... Roomba Robotic Floor Bagless Vacuum

Rigid 5.25hp 16gal shop vac makes a load whiring noise and smells like something burning not sucking as well

... Ridgid 9 Gallon Wet/Dry Shop Vac 96882 Canister Vacuum

I have the Purple and grey Shark steam mop was working great but now I get steam but when I pump it the steam does not shot out ....... tried filling it with vinigar and let sit no luck....any other solutions

\012Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it may not be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have an old Progressive vacuum cleaner that says "Hepa Filter" and "Whisper Belt". Not sure what the model # is. The problem is that the vacuum part itself (the part that touches the floor and rolls over) has ejected its filter that we can see through the little window- it just came out under the rollers under the device... we cannot see how to re-insert this piece of filter which looks like a kind of round, flat grey foam/fabric and clearly goes inside- (top of the part that touches the flo

Check this procedure:\015\012\015\012Unplug the appliance that you will be \015\012changing the filter in.\015\012\011\011\011\011\011\011\011\015\012\015\012\011\011\011\011\011\011\011\011\015\ ... Kenmore 23313 Whispertone Bagged Canister Vacuum

Dyson07 blue grey

One reason why it may not move is that you may have hovered some thing wet up what you need to do us clean out the whole of the cyclinder with a damp cloth then dry out completly ... Dyson DC07 All Floors Bagless Upright Cyclonic Vacuum

Black and grey rubber pieces

... iRobot Roomba 560 Robotic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0104 seconds