Having problems with your Singer Vacuums ?

SINGER AT7813 LAZER STEAMER


Answers :

Repair Help & Product Troubleshooting for Singer Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

SINGER AT7813 LAZER STEAMER


... Singer Vacuums

I need a filter for the Singer Lazer Storm Model AS01A AT7739


... Singer AT7739 Lazer Storm Bagless Upright Cyclonic Vacuum

Singer lazer storm model AS-01A - Vacuums


... Vacuums

I need a filter for the Singer Lazer Storm Model AS01A AT7739


... Singer AT7739 Lazer Storm Bagless Upright Cyclonic Vacuum

I have an electrolux Enviro multi steamer which I was using this morning. I turned the steamer off for approximately 1 1/2 to do some shopping, and when I turned it on again, the steamer light turned on (green light) and then I waited for the orange light to go on, which too a while. When the orange light does turn on, there is no steam when you press the yellow button on the handle. I have checked for water, and the steamer is full, I have turned it on and off several times just in case that wi


Problem fixed itself. Turned off for couple of hours so unit can cool down completely and when I turned it back on it started working again. ... Vacuums

I have a durabrand food steamer model number FS1146R (ASDA spec code: 195/121). it is white a the bottom with a timer and has two clear plastic steamer compartments. The problem I have is that the handle on top of the lid has broken off. My husband has repair it a couple of times but can't do it anymore. Is there any chance I can purcase a lid as the rest of the steamer is still in good working order. How much would the lid cost? Many thanks Barbara Waller


... Vacuums

I broke the handle part of the shark steamer #53101. I don't have the book to try to tell you the parts I need. Can you send me a picture or a copy of the steamer. It is purple. The above number may not be the correct one. It is broken in the center part. It has a little small circular piece that joins the two pieces which are broken. The beginning of the handle at the bottom of the steamer and the next session which has the steam release. The top of the handle is okay . It the middle and bottom


Hi,Ann there are very few parts for these...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have the scunci 1000 steamer- it was sitting for a while and the cap on the top looks like its corroded and i cannot remove it from the steamer - i just bought it a year ago, but i think the salt or vinegar from cleaning it got trapped in the top and i tried everything i could think of to loosen the top so i could pour water into the unit and use it again; otherwise it is in perfect condition, but i tried even pliers and i cannot loosen it and i dont want to break it, but am so frustrated - wh


Hi, Elaine, W/D here.Corroded items are difficult to break loose as the corrosion builds up a layer that binds the parts together. Try this, as I usually have good luck with this method:Tap around the perimeter of the cap with a wooden h ... Scunci SS1000 Handheld Steam Cleaner

I have a Morplan Vitesse 1600w steamer. When switched on the steamer doesn't heat up, only a red light flashes on the steam level lights. Any idea what could be the problem?


Check the water lvel in the steamer, if there is water then take the unit to a repair shop for a checkup. ... Vacuums

Is it okay to run CLR or vinegar through my steamer. We have really hard water and even though we have a water softener and use filtered water, my steamer seems to be clogged


I wouldn't recommend the CLR. My suggestion is to run a cycle using white vinegar, the accepted standby for removing sediment and deposits in small and major appliances. I hope this helps. If it does, please rate my solution. Good luck! ... Rowenta Vacuums

Singer futura electronic 2002 - Singer Vacuums


... Singer Vacuums

I have purchased a lumina steamer model sc-306 with out manual and i do not know where to put the water, i feel stupid i have looked all over the steamer and can not find where it goes


... Vacuums

I have the Rainbow vacumn and steamer, but I cannot find my instructions to use the steamer. HELP PLEASE


Your manual can be found by clicking on the link below:http://www.rainbowsystem.com/rainbowsystem/manuals/ ... Rainbow E series Canister Wet/Dry Vacuum

Shark steamer wont work. Green button came on and went off. No steam. Have used steamers for long time. What do I need to do?


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

How do you install the 210-1128 Bissell carpet cleaner steamer brushroll on the Bissell ProHeat 8910? The prong on the replacement roller is larger in diameter than the one it is replacing. How do you open it up enough to remove the plastic piece that is attached to the steamer - the one with the belt??


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 8910 ProHeat Clear View Upright Vacuum

Unable to locate needles for Singer Ultralock 14U34 overlocker. Needles required are Singer Cat. No. 2054 10-14. Schmetz Universal are too large to slide into machine. many thanks kaye


Try singer needles 2054 you should be able to find them on line or at a local sewing store ... Vacuums

Singer Commercial 16-188 S/N G 9466420. Just got new Table, Stand & Motor. The pulley on the Singer does not line up with the belt slot in the table top. Can the pulley on the machine be moved out or is this the wrong table? Table, Stand & Motor was ordered for the 16-188.


... Singer Vacuums

Steamer trips circuit when pluggig in - Eureka Enviro Steamer 310 Stick Vacuum


This product is shorted. check if it is still under warranty..and have it repaired. ... Eureka Enviro Steamer 310 Stick Vacuum

My eureka steamer mop just stopped working - Eureka Enviro Steamer 310 Stick Vacuum


... Eureka Enviro Steamer 310 Stick Vacuum

Need duplicate manual for europro shark steamer . lost manual, steamer is about 2 years old, never been used.


Hi,The link for the manuals...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pr ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

My steamer does not steam. Do you have a special de-clogger? Or what can we do. My steamer is less than a year old.


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Bissel steamer I took the base of the steamer apart and had trouble putting back together. The switch assembly the adjusts the flow of soap came apart. I dont know how to line up the the black valve to the switch. [email protected]


You can do this Jeremy just be take your time be patient and keep trying! ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

How do you thread a singer 95k10 - Singer Vacuums


... Singer Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0216 seconds