Having problems with your spin scrub 50 rug shampooer ?

how to fix water from leaking out bottom of spin scrub 50

When I turn it on water is leaking from underneath rug shampooer

Answers :

Repair Help & Product Troubleshooting for spin scrub 50 rug shampooer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover F7458-900 Spin Scrub leaks water from bottom without pulling trigger when turned on.

The soap causes the valve in the trigger to stick u should be able to clean it by just using hot water and opening a closing the trigger. thank you josh ill be here for more info if that dont work ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Need instructions how to use Hoover Steam Vac Spin Scrub. I borrowed it from my Sister and she left it with no instruction book or letting me know how to operate it. I put water & cleaner in top tank. That's all I know to do. Do I put any water in bottom tank? I figured not, since that is probably where the water goes when sucked up by vac. Do I leave lid on bottom tank? I usually use a commercial cleaner, and this is very different. I need to know NOW, as I must return it to her today, and I'm

I did have a solution in just a few minutes. Someone responded with a solution that gave me the website where I could go and print the manual in pdf, so did that, and checking instructions I was able to clean my carpets and get the shampooer back to ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover spin scrub 50 leaking from bottom

Uh, may I encourage everyone to check the trigger under the handle...we went through taking the whole thing apart and it was just that the trigger was stuck in the open position, which poured the water out continually! ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

My Hoover Spin Scrub leaks when I take it to the kitchen to dump the water. I leave a trail. Also, there is a lot of water under the machine when I remove the water tanks. ??

... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My Bissell ProHeat 2x is pouring water out of the bottom anytime it's turned on. I had it in the shop for no water, took it back again for the same problem, took it back again because it had no suction, finally took it apart and found the problem with the suction and fixed it myself. Worked fine for a day and now it is constantly leaking water, if it's turned on, and is useless for anything except for making a mess.

Took the unit apart and discovered my heater had small pinholes in the metal and they had put in silicone, instead of a gasket, which didn't seal. So much for the place I took it to "saving" my heater for me. I repaired it myself by getting a few o ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Hoover spin scrub clean water dispensing tank. How do I replace the spring, seal and valve stem at bottom of clean water tank?

... Hoover SteamVac SpinScrub 50 Carpet Washer with Hard Floor Tool and Accessories

Leaking Hoover Scrub Spin Carpet Cleaner

... Hoover F5906-900 Upright Steam Vacuum

I have an older model F6056-900 Hoover steamvac Spin Scrub Cleaner. My first problem was that I loaned it out to a friend. Anyway she ran over the hose (used for attachments) with her car. I tried using the cleaner for carpet cleaning this morning but when I tried to put the solution tank into place...its loose...won't snap back in like it used to. When I can get it somewhat in place the solution just complete drains out through the bottom fo the tank. The leak is where the small hole on the bot

... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My Hoover spin/scrub floor cleaner has stopped scrubbing- the brushes spin for a few seconds right after turning it on, then stop until I turn it off and then on again. How can I fix this? I do not have a lot of money. I have taken off and cleaned the brushes and bottom vacuum opening.

Hi giacoma11,The common cause for this problem is the belt of your vacuum. It could be that the belt came loose or already worn out and needs replacement. To check if the belt is loose all you need to do is unscrew the bottom of the vacuu ... Hoover H3060 FloorMate SpinScrub 800 Upright Wet/Dry Vacuum

Hoover steamvac when I use it it leaks out of bottom. when it off an water in tank leaks out of bottom,when its off an I pull the triggar it flows big time out of bottom. tank doesnt leak when off sitting with water in it

Let me start out with an apology. I did not ask my question very well - and you did not answer it as I needed.\015\012If you wish, we MAY be able to communicate in your native language. We can do most indian languages, Turkish, Ukranian and s ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover steam vac spin scrub leaking cleaning solution

The hose leading from the tank to the sprayer head on the bottom of the unit, or the tank is not seated properly or the tank has a hole or crack ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Water leaking out from bottom of 7901

That part can go bad, but I have found more often the a water line came loose. Take out the 6 screw and the flow indictor cap, remove the top, then inspect that area. If you find what the problem is, fix it then when you put the top back on, make s ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Envirosteamer 300 leaking water. Older yellow model. I put water in it and as soon as it heats up, all the water leaks out the bottom, and it barely gets warm! It worked fine before. Could it be seals need replacing or something? Thanks!!

... Eureka Enviro Steamer 370 Upright Vacuum

The Lower body of the Bissell QuickSteamer, water pours out from the body. Solution: I took apart the machine and there is a spring loaded valve with a rubber washer at the bottom. Think of the letter T upside down with the rubber washer on it. The washer stretches over the bottom and the spring creates a leakproof plug and won't allow water to pass till the button on the handle is pressed. This old washer came partially off and allowed water to leak. I purchased from the plumbing dept. a mi

... Bissell Vacuums

I have a hoover f7222-900 Steam Vac Spin Scrub. I

... Hoover F7222-900 SteamVac Upright Vacuum

Leaking tank After I put the water in the tank and put the tank in its spot, water leaks from the bottom of the tank. Also from the detergent tank.

(1) Does water or chemical leak from the tank when filled, but before it is installed? If not, then the tank is OK.\015\012(2) If the tank is not properly aligned to the lower handle when assembled and latched, the black rubber seals on the ha ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Bissell spotbot: leaking the dirty water from bottom. I took the bottom plate off and there is a really crappy rubber seal. I think it is leaking from there.

I had the same issue. After some research, I determined I was missing a black "duckbill" gasket on the bottom of the dirty water collection tank.\015\012\015\012This caused reduced suction, and for the water to pool at the botom of the s ... Bissell SpotBot Robotic Wet/Dry Vacuum

Water leaks out the bottom of vac have new tank but the water still comes out the bottom while running like it is automatic no control

Hi Steve I have the same problem can you help if you were able to fix? ... Hoover F7220900 SteamVac V2 Upright Vacuum

I have a Eureka Atlantis carpet cleaner and a little water always leaks out of the bottom. Recently, the head of my handheld upholstery cleaner keeps leaking water. How do I get it to stop? Thanks.

... Eureka Atlantis 2595A Upright Wet/Dry Vacuum

Water tank valve is leaking out of the bottom of the tank. The water leaks on the floor.

It could be a cheap fix. There should be a rubber o ring that's worn or ate away by chemicals.\015\012I'm hoping the tank isn't cracked.\015\012Remove o ring. Contact repair place. O ring shouldn't be more than 5.00. ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

Water leaking When I fill the canister portion with hot water and put it in my machine it immediately begins to leak out the bottom. It has just started doing this. Do I need to take it in for repair?

The water tanks on this unit have had a very bad history of leaks. Most of the repair people had never heard of this unit, but one did, and had a spare set of tanks. If the unit is still under warranty, it is worth your while to get a replacement u ... Eureka Atlantis 2595A Upright Wet/Dry Vacuum

My Eureka Atlantis Express is brand new - never used. I took it out of the box, read the manual, filled the soap and clean water tanks, put them in. I lifted the machine off the counter to take into the living room but all the water came running out of the bottom all over the kitchen floor. I can see where the little white plastic piece sticks up into the water release valve and lets the water out. How do you stop this? Can it be fixed?

... Eureka 2553A Atlantis Handheld Wet/Dry Vacuum

Hoover SteamVac Model F6056-900 SteamVac/SpinScrub. Indicator light and high pitch suction noise indicates that dirty water tank is full. However, water level indicator (yellow bobbing plastic thing) is at the bottom of the tank and there is no water in the tank. Have check all the hoses for clogs, none found. Checked water port from motor area to receptacle tank for clogs, none found. Fixed broken hose to upholstery wand with duck tape, (wire not broken, just cracked plastic hose). The onl

There are 2 filters, make sure they are clean, one is on the tank lid, the other is from the bottom, it is red, pull it out and clean it. If yours has a foam filter on the tank lid covering the yellow ball, make sure there is at least a 1/4 in. gap ... Hoover Vacuums

Water leaking from bottom and hose not connected

The hose just pushes on. You will have to take the top cover off to rehook up the hoses. There are scres on the bottom, then where the dirty water tank sits, there tabs that you have to unhook, then the cover will come off. Note: the filter inside ... Hoover V1 SteamVac SpinScrub Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0702 seconds