Having problems with your Steam Fast SF-275 Steam Max Canister Vacuum ?

When I push the button to release steam on the handle it feels soft and no steam is released. It has been going out for a while now.


Answers :

I didn't fix the problem but I did take the handle apart. There is a little metal piston that is pushed down by the button on the outside of the handle. It was very sticky and stuck in the off mode. I freed it when I took it apart but obviously it just stuck again. I am going to take the handle apart and see if a little WD40 will make it easier to push. Either that or glue it in the "on" position. I really love this appliance and if I can't fix it, I'll probably just buy something similar.
Repair Help & Product Troubleshooting for Steam Fast SF-275 Steam Max Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

When I push the button to release steam on the handle it feels soft and no steam is released. It has been going out for a while now.


I didn't fix the problem but I did take the handle apart. There is a little metal piston that is pushed down by the button on the outside of the handle. It was very sticky and stuck in the off mode. I freed it when I took it apart but obviously it ju ... Steam Fast SF-275 Steam Max Canister Vacuum

I have a Filter Queen Majestic canister vacuum cleaner. At the end of the wand, a button to release the attachement not only broke, but also one eyehole on the wand where one nipple on the button falls into. So therefore a new button isn't going to fix the wand because there isn't a hole on one side of the area where the button falls in place for a nipple to secure the button in place. IS THERE A REPLACEMENT PART FOR A NEW SECTION OF THE WAND WHERE THE RELEASE BUTTON IS SECURED IN PLACE THAT I C


... Filter Queen Majestic Canister Vacuum

Bissell carpet shampooer, how do I use it there was no manualI just need bASIC INSTRUCTIONS I'm guessing push button to release shampoo, go over the whole area, scrub as necessary, then it will **** up drity water. Question there is a rinse button Does that mean that I have to go over it again 3x?


Hi,Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem.B ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

While using my mop yesterday, it stopped letting steam come out. Tonight I plugged it up again and you could hear it trying to steam. I push the button in to release the square frame and it pushed out a burst of steam and pushed the head off. Put it back together and it still will not let steam out. No matter how much water is in it.


\012Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Ste ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

My shark steam cleaner won't "steam out" when I push the button, what's up. Light is on, when I release he safety cap,steam comes out??


... Euro-Pro Ultra Steam SharkTM II Hard Surface Steam Cleaner Vacuum

My Error light will not go off. I just bought new batterie, as I thought that was the problem. If I hold down the power button and the play button on the vacuum it will run. When released it stops. The remote will work for the unit if I am holding down the power button on the vacuum.


... Infinuvo QQ1 CleanMate 365 Robotic Vacuum

I have a Shark Steam Mop S3501CO model. When I press the release button to exchange mop heads, the mop head does not release. Nils Friis


Normal\012 0\012 \012 \012 \012 \012 \012 \012 MicrosoftInternetExplorer4\012 \012\012\012\012\012\012 /* Style Definitions */\012 table.MsoNormalTable\012\011{mso-style-name:"Table Normal";\012\011mso-tstyle-rowband-size:0;\012\011mso-ts ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Shark steam mop power light goes on, basin feels like it is getting warm, but there is no steam or water released. Pad is completely dry. What's going on.


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Heats up and produces steam but the release button does not open the flow of steam.


To remedy this, I did the following:\015\012\015\012\015\012\015\0121) Removed screws from: a) Lower area of handle (1 screw), b) Top of steamer, under round rubber flap around fill hole (2 screws), c) Front of steamer where nozzles attach (2 s ... Scunci 52067 Handheld Steam Vacuum

Steam not comming out when button is pressed. water boils steam builds and the only was to release is to unscrew cap slowley.


Corrosion prabably built up in the hose or end tip ... Dirt Devil PD20005 Handheld Steam Cleaner

Ciroa steam release button - Vacuums


... Vacuums

I have an electrolux Enviro multi steamer which I was using this morning. I turned the steamer off for approximately 1 1/2 to do some shopping, and when I turned it on again, the steamer light turned on (green light) and then I waited for the orange light to go on, which too a while. When the orange light does turn on, there is no steam when you press the yellow button on the handle. I have checked for water, and the steamer is full, I have turned it on and off several times just in case that wi


Problem fixed itself. Turned off for couple of hours so unit can cool down completely and when I turned it back on it started working again. ... Vacuums

The trigger on My Monster 1200W is not working. I poured the water in the canister and it sounds like it is steaming but when i go to push the button it doesnt spray.


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

When I push the button to release the water to start the steam process, nothing happens


You will need to remove the heater coil that is located in the handle, remove and mark allthe hoses and wires then remove the screws from the plate on the coil, make sure to not lose the red seals you will see alot of calcium build up use a brush to ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

I would like to always use the GO TO button to go to a specific bible locatilon, but I more often get something else from the square and arrow button.. I would like to always be able to use the GO TO button. How do I do this each time that I wish? [email protected]


Hello\015\012What is it we are working on here?, need specific make and model number of device. You also have this listed under the category of "VACUUM PROBLEMS" is this where you wanted it listed? ... Vacuums

My se200 motor is working but no steam is being released


... Shark Vacuums

Hi, I've a Tefal Steam Generator Express Turbo 2910. It won't "steam". The solenoid works when the button is pressed. The pump works. I've cleaned the tank (with white vinegar as recommended on this site!) thoroughly. The water from the steam tank is only "hot" (not scalding as I'd expect it to be). When first switched on and hot enough there is the TINIEST whiff of steam when the button is pressed then nothing more. Do you think this could be the Thermostat Part CS00094126, or can you


... Vacuums

No steam release


I solved the problem, the metal (hot!) release rod gets stuck & needs a little push.\015\012Unfasten the top by prying off the rubber gasket after removing the top. Remove the 2 small phillips screws, then remove the front that holds the no ... Euro-Pro Super SC710Z Steam Vacuum

Manual I realize it's probably something simple but how do I release the Cyclonic Chamber on top of the Dust Cup lid? I see the red 'open to clean' release button but how do I get down in there to push the release button? Thank you in advance for your help! Best, Christy


Manual > http://www.sharkclean.com/manual/NV22-NV22C-NV22P-NV22T-NV22Q_REV_1008.pdf ... Euro-Pro NV22 Shark Navigator Bagless Upright Vacuum

I have the Oreck Sanapathic DMS2000 Handheld Steam Vacuum, but no steam comes out when I push the button. I hear the motor, is there any buttons I am missing or any help on how to make it work, been plugged in for 5 min now. Held button down for 2... nothing. Just a drip of water.


ORECK DMS2000 No Steam First, tested tank and filter flow together using suction via plastic tubing. Worked freely Second, removed pump and disconnected hoses and terminals [watch location,three terminals on pump, two plugs] ... Oreck Sanapathic DMS2000 Handheld Steam Vacuum

This is embarassing, but I have just looked at the Dyson DC07 manual and at my Dyson for about 20 minutes, and I can't for the life of me find the wand release button on my actual Dyson.....the manual pictures don't look like the parts on my Dyson....I don't have a hose with a wand release button....the hose just goes straight up inside the handle....Can someone help me? Thanks :)


Hi the wand release button is located directly above the the Cylinder release button. The wand release button looks like the picture below. In order to releease the wand you must firstly make sure the Electrical cable is not wrapped up for storage. S ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My Steam Vac won't release any soap water mix


\015\012My model number Bissell is different than yours, but many models work similarly.\015\012 \015\012Capt. Obvious fixes: Water flow often stops unless b ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Release button Where is the release button to adjust the vaccum from its upright position, so I could vaccum carpet?


There is no button. You are supposed to place your foot on the area above the rolling brush and hold the base down while pulling the handle back.There is a small metal clip under the vacuum that you should bend out a bit to make it easier to re ... Euro-Pro UV209 Upright Vacuum

For some reason, our shark steam mop stop working. Usually after I plug the steam mop, the power light would light up then you would hear & see steam coming out of the mop's head but all of a sudden no power light would go on and no steam would come out. I can still use the mop, cause water from the tank still is able to flow down to the head. It's just that I'd have to use it like an ordinary mop not as the steam mop I liked. Pls help!!!


... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Mu Shark Electonic Steam Mop, Model SE200 is new, straight out of the box. I have followed all directions, plugged in, blue light flashing, pressed button for steam, and no steam. I have done all of the trouble shooting and still no steam. What is the problem?


... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0604 seconds