Having problems with your Steam mop s350iwmn ?

My shark steamers handle broke I screwed it back in now it heats up but dont steam

Handle came off put back in now it dont steam

Answers :

Repair Help & Product Troubleshooting for Steam mop s350iwmn

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I broke the handle part of the shark steamer #53101. I don't have the book to try to tell you the parts I need. Can you send me a picture or a copy of the steamer. It is purple. The above number may not be the correct one. It is broken in the center part. It has a little small circular piece that joins the two pieces which are broken. The beginning of the handle at the bottom of the steamer and the next session which has the steam release. The top of the handle is okay . It the middle and bottom


Hi,Ann there are very few parts for these...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Model number U5763900 Serial Number 090400013588 Handle broke off just above the four screws that attach it ti the boby of the vac. Hoover does not list parts for models that are more than two years old. The vac operates perfectly but without a handle my wife cannot use it, where can I find a part replacement. easy to remove four screws and replace. dont want to drive 100 or more miles to find a authorized repair shop. Oh yes, this is a Hoover Preferred Wind Tnnel Bagless


Get over it and buy a new one!!! ... Vacuums

Producing steam i just got the shark assembled the mv2010, then it is not doing anything, it vacuumed just fine, but when i put the steam pad on it wouldnt ever produce steam or do anything,it felt like the water was heating up but even after it sat for 20-30 minutes when i pull handle back towards me nothing happens, no lights no steam no nothing, so why wont it work


This link is for the manualhttp://www.sharkclean.com/manual/MV2010_11_IB_ENG_110103.pdf ... Shark MV2010 Vac-Then-Steam 2-in-1 Vacuum and Steam Mop Purple

Belt I have a bissell pro heat model number7901-1 and i dont know how to put the belt back on. The old one broke and i cant find my book.


First take off the cover on the left side of the top cover, then turn it over, remove the screw holding the red lock and pull the cap and brush roll out, remove the cap, remove the cogged belt, then you can put the new pump belt thru that slot, put o ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

My Shark is less then one year old. The Shark steamer will heat up - the water is hot - however, when I push the handle to mop the steam is not released, then it cools down and only cold water is releases from the mop head.


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Our dustbuster (dont' have model number with me-sorry) won't turn off when I pull back on the switch handle. I disassembled the unit and realize that the tab on the switch handle that pulls back on the internal switch handle to turn it off is not strong enough for its simple task. Does B&D have a proper replacement part?


If you can provide a model number, I can check availability of the switch and can either order it for you, or supply the B&D part number and you can order it from most local vacuum shops in your area or from Black & Decker direct online: ... Black & Decker 15.6 Volt DustBuster Vacuum

My shark steam mop will heat up but not steam when i push the handle down. I have put CLR in it and let it sit over night. it still is not steaming up but it heats up. Tina


Normal\012 0\012 \012 \012 \012 \012 \012 \012 MicrosoftInternetExplorer4\012 \012\012\012\012\012\012 /* Style Definitions */\012 table.MsoNormalTable\012\011{mso-style-name:"Table Normal";\012\011mso-tstyle-rowband-size:0;\012\011mso-ts ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I just got this euro pro shark steam mop. I dont have a manual for it so i dont know much about it. I put water in it and it heats up but when you start to use it. It makes a gurgling kind of sound and steam comes out, but not very much i dont think and on the floor you can't hardly tell where you went over the floor at cuz it's not very wet at all. So is it suppose to make a gurgling sound and should'nt the floor be alittle wetter?


Call Shark. They have good cust. support. ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I just purchased the hoover steam vac model F5853-900 from a garage sale and everything seems to be working well except i dont see any steam coming out from anywhere and the water in the vacuum stays cold. is there supposed to actually be a steamer inside this vacuum? if so, is there a button i need to turn on for the steamer to work? thank you so much for the help!


... Hoover F5837-900 SteamVac Supreme Wet/Dry Vacuum

I had a house fire and lost most of my belongings. But I had just purchased a Shark Steam mop 3501. Loved it. Well it did not get destroyed in the fire but someone managed to break the handle off. Just the handle itself was broke off the rest of the handle rod is ok. I'm trying to see if I can replace the handle and not the whole shaft. Can you help me.


Yes you can replace jus the handle, the replacement part for the handle is available at the manufacturer's web site in the Parts and Accesories section. Enter M/N: S3501 to confirm it's the same as on your unit.\015\012\015\012 ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have an electrolux Enviro multi steamer which I was using this morning. I turned the steamer off for approximately 1 1/2 to do some shopping, and when I turned it on again, the steamer light turned on (green light) and then I waited for the orange light to go on, which too a while. When the orange light does turn on, there is no steam when you press the yellow button on the handle. I have checked for water, and the steamer is full, I have turned it on and off several times just in case that wi


Problem fixed itself. Turned off for couple of hours so unit can cool down completely and when I turned it back on it started working again. ... Vacuums

Water seems not being introduced to heating element,which is hot, Depressing the handle appears not to be releasing water from tank; very little if any steam or water comes out base even after holding the handle down for a prolonged period and or pumping the handle.


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have a shark sc630 pocket steamer that supposed to steam clean microwaves so far No Steam will come Out of it at All it Heats up but No Steam Will Come Out Why? Please Help


... Vacuums

My ez1 Monster Floor Steamer - green light goes off when I lower the handle and stops steaming


It could be calcium deposits in the tank. Clean it with white vinegar. Good luck! ... Euroflex Ez1 Monster Floor Steamer - Cleans & Sanitizes

No steam, no heat from J4000 steamer.


... Jiffy J4000 Steam Vacuum

My shark steamer is not heating or steaming


I posted this video explaining how to clean the heater core.http://youtu.be/S4NglGXVv50Tons of water on the floor might mean that an internal hose or hose clamp has failed. Once you have it apart you can assess and replace ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have a Morplan Vitesse 1600w steamer. When switched on the steamer doesn't heat up, only a red light flashes on the steam level lights. Any idea what could be the problem?


Check the water lvel in the steamer, if there is water then take the unit to a repair shop for a checkup. ... Vacuums

My new H2O Mop Ultra (Danoz) seems to heat up ok then when the light switches to green and I start using it, the orange light comes back on as well as the green. Produces steam to start with but then it starts to spit water too and everything ends up wet. Any ideas on whats wrong or should I just send it back?


That is a major hardware fault, I have seen this numerous times with these H2O mop's... They seem to either work perfectly for a long while or have problems right off the bat. You definitely want to send this unit back and either get a refund or at ... Vacuums

My foot pedal to my Bernina 930 broke last night. The plastic around the screws broke off so everything fell out... I have the pieces, but not sure how to put it back together. Can this be repaired.


... Vacuums

Bissel steamer I took the base of the steamer apart and had trouble putting back together. The switch assembly the adjusts the flow of soap came apart. I dont know how to line up the the black valve to the switch. [email protected]


You can do this Jeremy just be take your time be patient and keep trying! ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I have a Hoover Slider, Model #S2105, Serial #050500084989, and I need instructions on putting it back together; with parts and assembly of parts. I took it apart because it was making a noise, and I believe one of the belts had come off. However, when I took the screws out of the bottom to check the belts, the whole thing fell apart. Now I can't get back together properly. It will not come on, and I believe it is because the switch that makes it come on when you lower the handle is not posi


Greetings from GoVacuum,\015\012\015\012Please see the link below for a parts schematic to your Hoover Slider, hopefully this will help you put the machine back together. If you find a part that is missing, and would like to order one, j ... Vacuums

My Pasquini Livia 90 S/E will not stop heating water. This builds up too much pressure. I have unplugged the machine and let it cool off and turned it back on and got the same result. I can relieve the pressure by opening the steam valve, but since the heating element does not turn off it builds up too much pressure very quickly


Your thermostat is failing. Given the initial price tag, look at your warranty options first. If you are out of warranty, then lets proceed.Since there is not a parts / assembly diagram to be found, you will need to disassemble your esp ... Vacuums

The handle on my steam pocket mop broke into - Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum


Hi,There is a year warranty..Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Eu ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Heats up, shows steam but does not produce push of steam when handle is pumped?


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Belt broke I have a bissell powersteamer and a belt broke and came out the bottom of it. I dont know how to put one back on it


There should be an access panel on the top side of the cleaner. Pry this open with a screw driver and this should get you access to the area where the belt can be changed. ... Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0604 seconds