Having problems with your Toyota corolla actuator set, idle-up. heating & air conditioning - ?


Answers :

Disconect it and plug all vacumm lines if your idle stays steady, then you need a new idle up valve.
Repair Help & Product Troubleshooting for Toyota corolla actuator set, idle-up. heating & air conditioning -

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :


Disconect it and plug all vacumm lines if your idle stays steady, then you need a new idle up valve. ... Toyota corolla actuator set, idle-up. heating & air conditioning -

Omc specs 1989 rinker boat 4 cylinder gm/omc i need specs for: plugs, points,idle, prop size,etc. boat had been sitting for a while, i changed oil,points,plugs, new gas,etc. i can crank it, but it's a little rough and won't idle below 2000 rpms. any advice or help would be appreciated. thanks. tommy

You will need to repost this in the correct section, this one is for vacuum cleaner repairs. ... Vacuums

Need instructions for 8qt pressure cooker, model 65999. All it has on lid is a dial which says 'open', 'low', & 'high'. If it had a pressure guage it wouldn't be a problem, but I have never worked with a pressure cooker with a low - high dial. Please advise.

Hello. Here is a complete set of generic pressure cooker instructioins http://missvickie.com/workshop/stepbystep.html\015\012\015\012J. ... Vacuums

Oreck trouble I replaced the plug and switch. black from motor to pole 1, black from plug to pole 2, white tied to white with a wire nut. When I plug it in it is powered in the off position. I have high speed at the high speed position, low speed at the low and off positions. Any ideas?

... Oreck XL Ultra Bagged Upright Vacuum

Powerhead stops on its own. Sometimes it will restart sometimes it wont. Very frustrating. The hose always kinks.

... Dyson Stowaway DC23 Bagless Canister Cyclonic Vacuum

Vacuum height won't go on low carpet setting. Dial will go on medium and high, but not low.

Make sure you're not trying to adjust w/ handle in upright locked position because thewre is a cam which raises the vacuum head a little bit when handle is locked in upright position. If this is not the problem, turn vacuum upside down with handle in ... Hoover Vacuums

Henry vacuum high low switch does not work on low

... Vacuums

My HEPA Shark Model 238 is great when the moter operates at high speed. However, periodically, it slows down resulting in no turbo action and virtually no pick up of eve the lighted dustball! Sometimes a good swift kick will bring the moter speed back to "HI", but sometimes no matter what, it won't speed up.rnHELP!

If the motor is over heating, it will slow down and may even stop all together. A solid knock could reset the thermal switch prematurely. Clean it as best you can around the motor and try it again. If it does the same thing, turn it off for 20 minute ... Euro-Pro HEPA Shark EP238 Bagged Canister Vacuum

Low suction I have a Hoover central vacuum system. I've reset the fuse box, checked the fuses, all of the lines are clear and there are no holes for escaped air to travel out. The filter has been cleaned as well. The vac works well with high suction when hooked directly to the unit, however when using any of the indoor connections there is extremely low suction. The machine still turns on so I do not believe it is an electronic issue. I have troubleshooted the issue as best I could and would

... Hoover L2310 GUV Central System Vacuum

Is there an adjustment on Dyson for high-low pile. Nothing cleans better but I'm handicap & can't push or pull Animal Dyson vacume over high pile carpet.

Yes there is an adjustment called a power cam. I am enclosing a link to show you exactly where it is\015\012\015\012http://www.dyson.com/homepage.asp ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Tristar zeus magnum shotgun change over from high brass to low brass shell

... Tristar Vacuums

Vacum works on low but not on high??????

Ur rainbow cumpiter has 8 years warranty call Rexair and give them ur seriel # u should be covered under warranty ... Rainbow E series Canister Wet/Dry Vacuum

The e series rainbow 2 speed works only on low speed. High speed will not run. What is srong?

It is either the switch or the controller. Call us and we can see if it is still covered under your warranty.RainVacwww.rainvac.com800-523-0510 ... Rainbow E series Canister Wet/Dry Vacuum

12 amp motor upright. bristlewheel turing very fast. suction very low. high-pitched whine. air displacement

Sounds like you got a blockage somewere between power head to bag. good luck thanks ... Vacuums

Suzuki sam idles to high until it warms up - Vacuums

Throttle position sensor ... Vacuums

My electrolux oxygen cannister has the "bag change" light on when there is a new bag. The light stays on when the suction power is high (to pick up small particles) and it won't pick up, but the ight goes off when the suction power is low (to pick up big objects). I changed the hepa filter, cleaned the motor filter and changed bags, but all that didn't help.

You may have a clog in the hose, and/or the inlet by the brush roll. A clog will turn on that light as well as a full bag. ... Vacuums

Brushes do not spin when it is on low carpet you have to have the knob on high carpet for it to work.

That means that the belt is starting to wear. When the belt starts to stretch it can't turn the roller brush against the resistance of the carpet. The lower the setting the more resistance. You simply need to change the belt. Here is a link to the be ... Eureka 2961AVZ Bagless Upright Vacuum

Oreck XL upright - has a 2 speed switch. Now only works in high speed not low speed. Will a new switch correct or is it the motor

Your vacuum is fine. The switch can either run at full speed or half speed. You are running at full speed, you need a new 2 speed switch. You can pick them up at an Oreck Store for $29 or around $15 on eBay ... Oreck XL Ultra Bagged Upright Vacuum

While vacuuming a rug on high (carpet setting) the power suddenly decreased. Now it will only run with low power, not picking up items on carpet

It sounds like you burned the belt. Turn the unit over, remove the cover plate where you see the brushes. On the side of the brush roller is where the belt is located. The belt should be very tight on the roller. Also, you may see little black ru ... Eureka 2991AVZ Bagless Upright Cyclonic Vacuum

Noise I have a filter queen majestic canister vacuum and it was given to me by my landlord,it is the red and black model, but dont know how old it is, its a great vacuum but sometimes it gets this high pitch noise, what could that be?

The high pitched noise could be because the vacuum is loosing airflow. does the red light come on on the top? if it does ot emptythe vacuum, replace the cone filter, the secondary filter, and the batting in the top of the machine. also hook the ho ... Filter Queen Majestic Canister Vacuum

I have a hoover steamvac model # F5915-900 and the brushes are not turning when I turn the selector from off to low or high. I've checked to make sure the brushes are locked in place and they turn manually with no resistance. What else can i do?

(1) Remove the brush assembly by pulling/unlatching it from base on each side.\015\012(2) Does one of the brushes have the drive pin present? It should be about ¼ inch square, and two inches lo ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I have an Electrolux Commercial Upright vacuum Model U129C. It has a device which turns off the motor driving the beater bar if something gets stuck in it. There is a simple reset button to restart the beater after clearing the obstruction. Just recently on flat dense low pile surfaces the switch cuts in after just a few seconds and turns the beater bar off. This doesn't happen on high pile carpet but the motor doesn't quite sound normal. There is no obstruction - the beater bar can spin freely

The motor is having a problem.There might be two reasons...either the coils inside it got heated up which will be needing rewinding or you can buy a new motor or there r capacitors attached sometimes u can make a check on that also if that's gone Kap ... Vacuums

When operating the bosch terrossa vacume cleaner its make a load noies when turning up from low powe setting to high power setting.

... Bosch Vacuums

I have a Kirby G7 and it will run on the low speed setting. When i switch to the high speed it starts to spark and smoke near the back of the motor near the windings. Do i have a motor going bad or is there a simpler fix.

It's probably doing that on low speed too, you just aren't noticing. What you'll have to do is get to the motor. Look at the armature and see if it's scared, missing an pieces, scratched up.. if so, then your motor is shot, throw it away.. If not, if ... Vacuums

I have a Napoleon Pellet stove insert Model NPI40. When the fire burn rate is extremely low it seems to operate normally. However, when I turn the heat up even a little I eventually get a high pitched noise that seems to be coming from the convection blower. Changing the speed of the blower has no effect on the noise level. I cleaned the blower but did not remove it. There was very little dust on it. Cleaning had no effect on the volum or pitch of the noise.

My theory is based upon 1st hand knowledge with a newer EPA compliant freestanding wood burner, with the air-tight and high efficiency ratings.its possible that its just the high rate of air moving through the air chambers , similar to a o ... Kenmore Whispertone 23312 Bagged Canister Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0188 seconds