Having problems with your Usha janome ?

Machine is running in reverse only

After running in reverse for few seconds it is running in reverse only.

Answers :

Repair Help & Product Troubleshooting for Usha janome

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Some one just gave me a Salton Cappuccinoa Dolce Model PE-70 Pump - Espresso Maker and there where no instruction or user manual on how to run this machine. I would like to get a user manual or the instruction on how run this machine.


... Vacuums

Noise My Dyson DC08 is making a loud, rough, vibration/noise that seems to be coming from the from the rotating brush housing. I replaced the old belt which was several years old and slipping. When I run the motor with the new belt removed the machine sounds normal. The bearings on the rotating brush seem to be running smoothly when turned by hand both when out of the brush holder and when installed in the machine. I can't find anything rubbing on the belt or rotating brush. I applied a bit o


Hi there, it's Jack at Dyson.\012I'm sorry to hear you're having difficulty with your Dyson vacuum. From your \012description, it sounds like the model number you've supplied may not be correct, \012as DC08 is a cylinder vacuum which doesn't use ... Dyson DC08 Cylinder Bagless Canister Cyclonic Vacuum

Brushes run freely on the cog and I put on 2 new belts and new brushes on my Bissell Proheatx2 the brushes do not turn when the machine is running even if I have the handle in the relesed position


I know how frustrating it can be when the brushes don't turn when you're ready to clean.Here's a quick link to troubleshooting steps to assist you:\015\012 ... Bissell Vacuums

Cleaned and running well, taken downstairs, put to work my 530 has developed a distinct knock. about 1/2 second speed as going along. does not happen if brushes removed. machine runs for a few mins th


Click the link below :----http://wikisolutions.blogspot.in/2012/02/get-free-answers.html ... iRobot Roomba 530 Robotic Vacuum

I have a kitchenaid artisan coffee machine which is 15 months old just out of warranty. when you start to make an esspresso coffee the machine runs but no water is being pumped through the coffee to the cup you can hear the machine working but no coffee. Thanks Lloyd


Hello lloyd..... There are a few possible causes of this problem. The first is using coffee which is too fine a grind. The second is a machine which needs to be thoroughly cleaned. Most can fix those two areas themselves. The other causes have to ... Vacuums

After using the vacuum for a while it would stop running. After sitting several hours it would run again. Now it won't run at all. It was just a couple of months old and I haven't been able to use it again. It was never used much and we paid good money for what has turned out to be a poor machine. Any suggestion?


... Dirt Devil M130000 ''i'' Dual Cyclonic Upright Vacuum Cleaner Vacuum

Reverse button does not work and machine only sews on reverse Kenmore 385.1884180


... Vacuums

The number 2 light is blinking and I can't get the machine to run. I know that when number 1 light blinks its because of the lid. What is the problem for the number 2 light on the island oasis machine?


... Vacuums

No, I was trying to find a singer sewing machine model no. 4525. The machine is approx. 20 years old. It runs but real slow.


I would spring for a tuneup. It is a machine and does need attention and if you like the machine, invest in it. You can download a free manual at www.singerco.com under customer su ... Singer Vacuums

Machine running hot. new bag but red flag indicator is fully closed at stsrt up. Runs but overheats and shuts off and red reset light comes on


You may have a blockage in either the hose, the telescopic wand or the power nozzle/floor attachment. The easiest way to tell, as you have a new bag in there is to disconnect the hose and start the machine. If the suction is good there, start to narr ... Miele S548 Bagged Canister Vacuum

My Singer Sewing machine (model 6215) is now only sewing in reverse. After pressing the backstitch button, the button seemed to stick in the backstitch position. I was finally able to pull the button out but my machine continues to only stitch backwards. What do I do now?


It's stuck inside. Open it up so you can see inside the bottom, look for the feed dog mechanism and you'll find where length of step is varied, this is where the reversing takes place too. Tapping gently and oiling will free it up.lp ... Vacuums

Little suction and pours water underneath machine on the floor. This all happens while i am using the hand attachment tool, but also occurs when i tried just the machine is running..what am i doing wrong. it is new..only used once about 6 months ago


Press the handle release kick-button with your foot, extend the handle all of the way back, and take a look at the gap between the base of the unit and the handle/reseviour assembly. You should see several black hoses attached to the base and running ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

I have a Z5930 vacuum and i want to trace an electrical fault. I need to disassemble it to get to the electrical connections and it is quite a tricky one to get in side. The machine will run and then cut out after a short time. It will then re-start in about 2-3 minutes and run normally again and so on. I was not able to give you the exact model but it is Ultra Filtration Oxygen line


... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

I have checked the machine for blockages, none found.However, the machines turns off after running for about one minute. Any ideas?


The electric motor inside your Dyson has a built in over-current trip to protect itself (and you if it seriously overheated and caught fire). This normally automatically resets itself, however if the motor has just about had it, next time it is switc ... Dyson DC07 Bagless Upright Cyclonic Vacuum

The machine runs for brief periods, then shuts itself off. If it is allowed to sit for several minutes, it runs again, then shuts itself off.


The motor is heating up to much and the cut out switch is kicking in.\012You need to check the the motor filter, and worse case you may need to new motor.. ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

I dont have directions on how to run it sister gave it to she had lost directions i need to know how to run the machine i have some spots i want to clean


You don't mention the model, but user guids can be found at the below site.\015\012\015\012 ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

I have a Polti Vaporetto Lecoaspira 710. I have filled the tank and set the machine up as usual. When I turn it on the boiler pump runs continuously for a minute or so and then the 'beep' begins and the machine shows that the boiler is empty. Obviously the water is not getting through. We don't live in a hard water area so it shouldn't be 'limed -up'. The manual says to leave it to cool down and then try again. That had no effect. The only answer that Polti 'Service' could give me was to try 'G


... Polti Eco Pro 3000 Canister Steam Vacuum

My g5 will not run, I checked the cord and it has power to the machine. Is there a fuse or breaker in the machine?


There is no fuse or circuit breaker in your G5. However, here's a basic check list to follow: did you check the cord for continuity with an ohmmeter? Bad cords on Kirbys are fairly common. Your Kirby has 2 safety interlocks that stop it from running; ... Kirby G5 Bagged Upright Vacuum

Need the manual on how to run (put together and all) the hoover steam vac v2 (widepath) with auto rinse) we tried today and when we leaned it back (so we could run it on the carpet) water started pouring out all over the machine and got the carpet (like flooded) wet :( this one was me mom's and she passed on approx 2 1/2 years :( she always kept the manuals for everything but we caint find this one :( ... thnx


God Bless Your Mom.\015\012\015\012Hope this was helpfull to you. Sawdust46\015\012\015\012http://www.hoover.com/pdfs/manuals/F7411900.p ... Vacuums

Little Green Machine not spraying water or sucking up, but motor running. Help!!!!


... Bissell 1200B Handheld Steam Vacuum

Hoover SteamVac Al Terrain Spin Scrub motor running in reverse


If it dosent **** up the water send it back but some hoover steamvacs blow air to dry the carpet or floor faster ... Hoover F7431-900 SteamVac Vacuum

When machine is running the brush does not turn


You need a new belt. In order to change it, turn the machine compleatly upside down and place the head on a counter, handle on the floor.\015\012There is a L shaped base plate to remove that has 5 screws in. Once the base plate is off, you see ... Dirt Devil Featherlite Bagless Vacuum M085845Vacuum

We have bissell pro heat and I have put new belts on and took off the top plastic cover I blew out the lines and I still can't get it to pump water or solution. The red little spinner flow indicater does'nt get water, if I pour water into it it runs out the front. I guess I don't know what else to do. The machine worked fine the last time we used it about 6 months ago. Any suggesttions?


Did you check and make sure the belt is still on right? They do come off from time to time.There are like 6 long screws holding the top cover to the bottom. The are real pain in the behind to put back together once you take them off. T ... Bissell Vacuums

HAYDEN 3600 RED LIGHT REMAINS ON THE CIRCUIT BOARD BUT MACHINE RUNS FINE. WHY?


... Hayden Industries SuperVac 6000 Central System Vacuum

I have two older Filter Queen (brown vacuum cleaners). Besides unclogging the hose area and making sure it is not filled with dirt, what else would cause the machine to run hot and have a high pitched sound? Is there another area where I might have clogs?


There is a secondary filter under the paper cone that gets filled with fine dust. It can choke off the airflow. The noise motor sounds like a bearing going dry. That should be replaced ... Filter Queen Majestic Canister Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0327 seconds