Having problems with your Vapor 3000 Steam Vacuum ?

Steam sparging line attached to downcomers on HRSG

\015 A 2" sparging steam line is connected to a set of 24" Downcomer lines just before they enter into the Evaporator of a HRSG unit. Could you explain what the purpose of this line is in the operation of one of these units?\015

Answers :

The reason for this is to keep the HRSG warm to reduce fuel costs. Due to the price of Nat Gas, it is adventageous to supply sparging steam to keep the HRSG warm so that when the Comb Turbine is called upon to start the HRSG metal temperature will be greater than ambient temperature.
Its used fro pre-heating
Repair Help & Product Troubleshooting for Vapor 3000 Steam Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Steam sparging line attached to downcomers on HRSG


The reason for this is to keep the HRSG warm to reduce fuel costs. Due to the price of Nat Gas, it is adventageous to supply sparging steam to keep the HRSG warm so that when the Comb Turbine is called upon to start the HRSG metal temperature will b ... Vapor 3000 Steam Vacuum

My steam mop gets hot but steam is not coming out when i pump it. However when I release the bottom attachment steam comes out of bottom of the base (purple part). I took the attachment off to see if it was plugged but dont see anything. Any suggestions?


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Floor Attachment I took off my floor attachment, but now the belt seems to be off and I can't seem to get it back on right. I can't use the attachment and I don't know why it's so hard to figure this out. They say, just turn it to belt off, but when i turn it it lift's it up and can't line up with the belt off label. Then, when I turn it the other way, it's off. So I've been trying to pull it off so when it lines up with belt off, it's off. But the I turn it the other way and it's still off a


Try this,\015\012\015\012With the floor nozzle off the machine spin the belt lifter around until the red arrows match. If you look at the side that attaches to the vacuum you should be able to see the belt up on the hook. If is not on t ... Kirby Generation 3 Bagged Upright Vacuum

The extra large mop head attachment will not release steam. It seems to be clogged, and the steam escapes above the head attachment. How can this be resolved?


Hi,I saw this post, so I had to go and checkout my wife's shark....If you pull the attachment off and look inside you will see that there is a small hole that the steam travels through into the flexible hose with the spring around it and ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

No steam My SV1000 steam cleaner will not make steam. It heats up, but I think the small portholes where the steam comes out are clogged up. Are parts available to change the steam line?


I used the straw to prime the lines and 50/50 mix of vinager and water and it worked perfectly. I then mixed the water container with the same mix and ran it through the system. All works fine now. ... Black & Decker SV1000-4 SteamBuster Vacuum

After plugging in the steam mop, waiting for the 30 sec, pumping 12-15 times - no steam comes out. the tank is full and if i take off the bottom attachment the steam sprays everywhere. but the steam will not come out when mop head is on. thanks


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it may not be getting steam to the head...Euro ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

The steam is comming off the tip of the body but the attached floor piece will not let the steam out to the floor through the pad. The body tip has turned white because of the steam pressure build up.


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it may not be getting steam to the head...Euro ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

HOOVER STEAM VAC. I CAN ATTACH THE SOFA CLEANER ATTACHMENT AND THE SOAP WILL COME OUT BUT I CANNOT FIGURE WHERE TO ATTACH THE ROUND PART THAT WILL **** THE SOAP BACK UP


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Shark steam mop not sending steam to attachment


It sounds like the head could be clogged up. Try running water in the head and see if that works ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have a Polti Vaporetto household steam cleaner that I bought 16 years ago. I haven't used it for about 10 years because the connection between the steam er and the attachments doesn't work properly and it is difficult to use. The shop where I bought it no longer sells them and can't get them fixed anymore. I'm about to ditch it, but thought I would have another go at using it. (It was very expensive). Now I can't get the safety cap off so I can't fill it or test it. Any ideas on what I can do


... Polti Eco Pro 3000 Canister Steam Vacuum

When I attach my rectangle head ,steam will not come out, then when I take it off steam goes everywhere. It looks like something has melted in it.


Hi,You need to clean that hole out...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I just bought a used euro pro steam shark model ep903, has all parts but when I turned it on to use it water and steam poured out of the handle grip area. Am I not doing something right? The manual says to attach the brush directly to the hand grip but I can't use it without getting burned. Any suggestions would be greatly appreciated! Thanks!


... Euro-Pro Ultra Steam SharkTM II Hard Surface Steam Cleaner Vacuum

Attachment Where can I purchase the carpet slider attachment. I live in St. Catharines Ontario Canada and purchased my Steam mop at Canadian tire


I just recently picked one up on ebay along with 8 more pads for a little of 20 dollars. You can also go to their website (sharkcompany.com) and order it there. I think it's 13 dollars. You can also order the pads there as well, I believe it's 20 ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Shark steam blaster model # s3300h. I need to replace the handle .the connection inside that goes to the steam line is broken


... Euro-Pro Vacuums

I have a Polti Vaporetto 910 steam cleaner with a iron attachment. Now the problem is the iron gets hot but no steam comes out. Please help


... Polti Vaporetto 2400 Canister Steam Vacuum

Can not get Shark steam mop to steam, green light is on? Purchased 5/4/09, Registered Product 6/2/09 Cynthia Friesema 973-222-7068 please call cannot get through on your phone line!!!! Tried many times, just gives me a fast busy signal every time I try to call !!!!


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have a Kenmore Progressive model 116.22812204 purchased 2003. The swivel (part nuumber 8195133) that attaches the extension wand to the power mate attachment snapped, so I can't keep the parts connected. I can order a replacement part on-line, but I don't know how to replace it - is it difficult to take apart the power-mate and replace this part? Do you have instructions on how to do it? Thanks!


... Kenmore Vacuums

Hi I have an Electrolux Envirosteamer and it has stopped steaming. I have made sure the water cap is on tight and also taken the head apart (where the hose finishes up and the attachments fit on) and the hose is intact there. I have no steam and wonder if I have a valve problem? if so can anyone tell me if it's worth trying to order the part and fix myself. I'm fairly handy! Thanks Sue


If the water is boiling and element is ok then it could be the outlet valve it is poss to diy but is a 2 person job as very fiddley ... Eureka Deluxe Enviro Steamer Vacuum

No I did not my hose on the dirt devil does not have much suction on it I took everything apart and found nothing wrong no clogs anywhere but when I add an attachment to the hose it loses all suction...I looked for a switch to change from regular vacuuming to attachment found nothing why is this??????? Need a manual where can I find some information and a download on line manual??????


Try this. There should be a little filter unerneath the tank. just clean that filter or replace it. (9 times 10) thats the problem.\015\012\015\012good luck. ... Dirt Devil Vision Turbo W/Bonus Upright Vacuum Vacuum

How do I attach the upholstery attachment to the Hoover Steam Vac F5910-900?


I assume you have a Hoover there. The hose only goes into the top of the tank. The opening of the hose is supposed to connect with the tank lid to deliver suction to the hose. I'm assuming that you think the hose is supposed to connect to the duct on ... Vacuums

How to attached stair cleaning attachment - Hoover F5835900 Upright Steam Vacuum


Hi There,I'll be happy to walk you through step by step how you can attach the hose to your Hoover SteamVac.Here are step by step instructions for you:Step 1. To prevent possible leaking, removeclean ... Hoover F5835900 Upright Steam Vacuum

Spin brushes spin freely on steam vac when not attached to cleaner indicator screen not dirty speed selector is in high position brushes are clean spin brush indicator when brushes attached to machine does not rotate


If this is a Hoover Steam vac, the turbine which drives the brushes is bad. If not a Hoover, then what is it, they are different, need brand and model number. ... Vacuums

After two years, my Euro-Pro Shark Steam Mop, Model S3101, no longer ejects steam. I have used tap water. I think the line is clogged with mineral deposits. The light is on when plugged in, and the unit heats up. I even put in vinegar for about an hour to break up the calcium deposits, but it did not correct the problem. How do I fix it, or, where can I take it locally to be fixed (Orange County, CA)?


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I used the steam mop for the first time on our hardwood floors. I tried it on a inconspicuous place first without problem. As I worked on it in the kitchen, two lines appeared on the floor. It didn't scratch it, but the lines will not come off. Any ideas of what this is or how to fix it? Thanks!


Hi,This type of problem usually\012is not he fault of the Shark Steam Mop.The problem is the old\012residue left on the floors by other cleaners.Here is a tip\012that I wrote that will help you out with that problem.. ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

On a bissell 9400 steam vac i am getting spray from the hand wand but not the floor spray. I checked all the solinoids and lines and switches. I blew throurgh the lines and got no clogs. can you tell me what else can be wrong


... Bissell Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0399 seconds