Having problems with your Vapor TR-6 Steam Vacuum ?

After i plug unit in it starts continuously tr6 vapor clean

\015 After i plug unit in it starts continuously beeping and doesn't heat up\015

Answers :

Repair Help & Product Troubleshooting for Vapor TR-6 Steam Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

After i plug unit in it starts continuously tr6 vapor clean

... Vapor TR-6 Steam Vacuum

Asking again. Better wording? My lightweight Bissell carpet shampooer is continually spraying cleaning solution. The sucking action works well but can't keep up. This unit does NOT HAVE A HEATER. This is a simple unit. Is there a cable going down the handle from the trigger? ( it feels like that's the way it works. Could the drain be plugged. Also it will only use 1/2 a tank of solution at a time. Then must be filled again

Hi Sue. I understand how frustrating this must be. I'd like to help you with troubleshooting steps, but need more information.\015\012Here's a quick link to contact us: ... Vacuums

Electrolux Centralux I have a Electrolux Centralux. When I plug the hose in at one of the wall outlets the motor will not start. If I go to the motor and slap the unit it will start.....then...it will not stop unless I unplug the power cord to the motor. If I plug the power cord back in, the unit will not restart until I slap the motor unit again. The unit has only been used 20 - 30 times. Any suggestions?? Thanks, Bruce

I dont know if you had your unit looked at yet but it sounds like the Power module is going. I repair the machines so I know some of the work. ... Electrolux Centralux Vacuum

The roomba or I robot will upon pressing the start button go around in circles, than starts to goin one direction, than stops and goes in a circle. The unit is clean and the unit reset. Bill

Is the front bumper **** in? ... Roomba Vacuums

I was vacuuming my room and all of a sudden I hear this loud noise, then notice the roller brush isn't spinning. Thinking too much hair was caught I separated it from the rod and hose to clean it out, but noticed that the roller brush didn't move at all while I was cleaning it. I've cleaned the brush before and it would roll around with little effort, but this time I couldn't move it at all. After removing hair and string I put the vacuum back together and started it up, but the noise continued,

It sounds like if the rod is clean then there is debree inside the roller where the rod fits in too. ... Hoover Platinum Cyclonic Bagless Canister Vacuum With Power Nozzle

Wind tunnel hepa filter it stopped during my vacumning. It was plugged so I cleaned the plug but it won't start again. the outlet has power??

Let the handle all the way down look down at the vacuum head you should see a reset button reset it and see if it won't turn on then hope this helps ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

The unit works fine for 10-15 minutes, then the power cuts off. If I let it rest for 15-20 minutes, sometime it starts right up again. The filters clean clean, the brushes are not restricted, the retainer is empty. ???? Tom Abbott

Hi, it is over heating due to insufficient air passing through the motor and a heat sensor is cutting out the power due to a blockage maybe a filter or a cloged hose.\015\012\015\012\015\012The ... Dyson DC07 All Floors Bagless Upright Cyclonic Vacuum

The breaker on the vacuum trips after about 3 seconds on. The canister was extremely full and started to smell like burnt wood, we fully cleaned out the unit. Now when the vacuum is turned on, the motor sounds weak, and then turns off in a matter of seconds,and we have to reset the breaker on the vacuum to get it to start again for another few seconds.

This sounds indicative of a worn set of carbon brushes on a dieing motor for a central vac. the armature is ,likely damaged causing teh breaker to blow. Please post back with more details as to make and model. Do not atempt to run the vac ... Vacuums

The clean light on the Roomba 520 doesn't quit blinking even when it has been docked for hours, i checked all the plugs and i also pushed the spot button for 10 seconds. it is a a slow continual blink as if it is recharging continually. what is the problem.

Sounds like you didn't remove the batteries protective tape. If this isn't a new roomba, your problem may be the charging cycle. For a brief video of what to do click the link below.http://irobot-homesupport-en-eu.custhelp.com/app/answers ... iRobot Roomba 530 Robotic Vacuum

Our two-year-old miele antares stopped working...you cannot get it started when pushing the start button (yes, the cord is plugged into a live outlet); no external damage to the unit

... Miele S4210 Antares Bagged Canister Vacuum

I have a Hoover Platinum carpet cleaner, and it has stopped dispensing cleaning agent and water. This model has a separate tank for water and separate tank for shampoo dispensing. It also has a power hand unit that dispenses shampoo. All along the hand unit has continued to dispense shampoo. Symptom #1, the water tank seemed to be taking on shampoo, as it was getting sudsy. Symptom #2 - On wash mode, nothing would come out, on Rinse mode, sudsy water would come out. Later, symptom #3 - not

Somewhere on the outlet is a control tap thats driven by a rubber band and something is up with this control ,best advice here is put it in the boot of the car and take iot to a hoover dealer ,they will do it seconds for you ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

I have a two yr old Ariens model 939003 (5 HP 4-cycle) and it will not start! Have rel new gas, and an electric starter. Think I did everything right. Ignition key on and choke full; primed push button x 3 (at first when I was trying to mechanically start it I over primed it). Spark plug clean and dry. What next?

... Vacuums

92L3-W this unit was fine when new, did a good job, after a few months it got very loud. it is so loud you need ear plugs to use it. i have checked and cleaned it. there is'nt any visible problem with it. after cleaning and changing all filters it still is very loud a lot more than when it was new.

... Bissell Vacuums

I have a Miele s251i vacuum that was working just fine until I umplugged it (while running) and re-plugged it in at a closer socket. When I replugged it, it started for a second and then stopped. Will not start now whether we use the on/off switch or not...suggestions? Would also like to know how to disassemble the unit so I could check out the wiring with a multitester..thanks

I just had exactly the same problem. Opened the vac, checked the circuit\012 next to the motor and it can be clearly seen that the Triac burned thru\012 the PCB. Will replace it and check again. Vac bought long ago, works \012extremely well. ... Miele Vacuums

Roomba 4270 stops too soon. my roomba got weird all of a sudden. it started not moving all over as it should. so I tore it all down as I had done before and cleaned all the hair and dirt out of every thing I could without getting down to the basic shell. it does work now and does move all over but stops after about 10 minutes. brand new battery so not a battery issue. could I have plugged some of the sensors in the wrong 'plug'

... iRobot Roomba 560 Robotic Vacuum

I have a vx550cc that keeps kicking in and out quickly, then shuts down for a few seconds and starts up kicking in and out again. There is lots of suction at all the outlets and sweeps. The dirt bucket has been emptied and the filter cleaned. Al the LED lights light up when the motor kicks out, then back to one green when it starts back up. This unit has worked great for four years with no problems.

... Broan-NuTone VX475 Bagged Central System Vacuum

My hoover wind tunnel vaccum has a hepa filter that is supposed to be self cleaning but continues to plug up. it is not easy to get to and takes forever to clean it out so the suction is strong again.

Do you have the SELF-CLEANING, rotating HEPA filter? \015\012\015\012I just fixed my HEPA filter not rotating!! \015\012\015\012It involves taking apart the vacuum HEPA area. All screws are the same size. There are a LOT of ... Hoover U5444-900 5100 Wind Tunnel 15 Inch Wide Hepa Filter Bagged Black VacuumVacuum

Wont charge new roomba for xmas. lights on charging unit both flashing but no power in roomba. it worked yesterday when i got it out of the box and did a full clean. i feft it on charge over night ready for the clean today but when i got up no power atall please can you offer a solution. i have held down pock and start - no joy. i have checked the battery connections - no joy please help many thanks caroline

Did you try plugging in 560 driectly to charger then run it? ... iRobot Roomba 560 Robotic Vacuum

Vacuum stopped as it got plugged up with fuzzy carpet stuff..cleaned it out but now it won't start.

This is due to the thermostat. If the cleaner can't breathe the motor will shut off if it gets hot. If you have new carpet, this will be a problem for a little while, until your carpet stops "shedding" unclog and wait. after cooling the unit will ... Kenmore Vacuums

Bad Motor? I have an upright Electrolux Prolux Heavy Duty "Appareil Industriel" and the motor does not seem to be working and turning the brush. Is there a trip switch somewhere to try and reset the motor? I have taken the plastic cover off on the base of the unit and cleaned it well, but can't seem to get the motor to start again.

... Electrolux Vacuums

Manual A friend of mine just cleaned out her garage and gave me a Westinghouse WST1600 vacuum that was rarely used. I purchased new #25 fuses and have had the battery pack plugged in for over 10 hours and when I put in into the vacuum and press the on button a green light flashes, but the motor does not start. Can I get this vacuum to work?

Here is a copy of the manual for your vacuumwww.thinkvacuums.com/pdf/uprights/Westinghouse-WST1600A.pdfWhat could be the problem is the battery could be shot after not being used for so many years that the life of the battery ... Westinghouse WST1600 Upright Vacuum

My vacuum is not working after cleaning a lot of dust. It starts w/o the hose but when i plug the hose it turns off on its own

Hi,\012 \012Take something and run it through the hose...your hose is clogged up...and yeah it has to be bigger then a wire... a wire will often push right through a clogg of dust...\012He ... Electrolux Epic 6500 Vacuum

REPEATDED CLOGGING My unit keeps clogging in the hose right where it meats the brush. My wife and I have cleaned it several times but it continues to clogg after every few uses. What can be done about this?

Are you sure there is nothing else in the dirt inlet. Alot of times a pin or nail will turn sideways and get stuck, then debris builds up and will clog up. It is either that or you are trying to vacuum up too big of things. ... Eureka 2961AVZ Bagless Upright Vacuum

My dc 05 isnt working and i cant understand why , i have cleaned all filters etc and i also changed the fuse on the plug , which after i didi that it attempted to start but then jus cut out again so i thought the fuse had blown again , so i checked the fuse but its working fine could there still be a blockage somewhere in it or is it something electrical which means my dyson has to go to the dump :(

Most common cause of this problem is a wire broken inside the flex, usually either just where it leaves the plug (easy to fix) or at the other end (more of a problem). In either case, this is no reason to dump the machine - it can be fixed at a fract ... Dyson DC05 Cylinder Bagless Canister Cyclonic Vacuum

I bout this vacume in mid December 07 and about February-March it started not picking up the dust on the floor. So in early April I bout a new filter and it still wasn't picking up the way it had in the beginning. I've taken it a part several times and cleaned it out with it being plugged at the bottom hose with dust bunnies. Well I just took it back to Walmart where I purchased it and I failed to keep the reciet they could not do any thing about the sweeper. I went back to the sweepers and re

Pull the hose out of the holder, is there suction there. If not, then there is a clog in the hose. If there is suction, then check the dirt outlet by the brush roll. Also if the belt is slipping, it may appear to not have as much suction, belts wi ... Dirt Devil Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0717 seconds