Having problems with your VAX Appliances 2000 Canister Vacuum ?

My vax hoover performance 2200 keeps overheating and cutting out after only 10 minutes

Answers :

Mine too.. I got local place to do a deep clean (sic) of all the filters but its made little difference. Hardly does a room before cutting out and then you have to wait an hour for it to cool down. am veryy disapointed
I have had the same problem as well. I found that the circular filter that sits over the top of the cylinder chamber gets sucked out of place and into the main suction tube which causes it to block and therefore over-heat and cut out. You can remove this filter and since then I haven't had any cut outs but you do run the risk of causing some damage to the suction motor by allowing something large or sharp into it...
Repair Help & Product Troubleshooting for VAX Appliances 2000 Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My vax hoover performance 2200 keeps overheating and cutting out after only 10 minutes

Mine too.. I got local place to do a deep clean (sic) of all the filters but its made little difference. Hardly does a room before cutting out and then you have to wait an hour for it to cool down. am veryy disapointed ... VAX Appliances 2000 Canister Vacuum

My hoover dirtmaster keeps overheating and cutting out

... Hoover Vacuums

My Dyson keeps overheating and cutting out. I have cleared a twig from the hose and checked everywhere else but it is still cutting out after aboout 5 minutes or less of vacuuming. What's the problem?

... Dyson DC14 Full Gear Bagless Upright Cyclonic Vacuum

Vax hoover my vax hoover keeps overheating and cutting out.

... Vacuums

My upright Panasonic hoover MC-E3002 keeps cutting out after a few minutes.

... Vacuums

Hoover 1600 dust manager bagless, keeps overheating and cutting out?

... Hoover Vacuums

The powerhead on my Dirt Devil keeps cutting out, and after a few minutes, making a burning rubber smell. Only used it less than a dozen times (same thing happened with my Hoover!) It is free of hair etc...

Sounds like you've done a lot of troubleshooting on this unit. It could be that the bushings are worn and the "play" in them is causing them to seize (this is often accompanied by a chattering sound from the bushings).\015\012\015\012I w ... Vacuums

My Hoover Windtunnel cuts off after using it for a few minutes. After an hour or so, I can turn it back on again. This keeps happening every time I use it. This is my third one. I have taken the other two back to Target for the same problem and they have exchanged them.

Yes this machine has a thermal protector in it to shut off the machine if it gets to hot, this is normal. if there is no clogs in the hoses or in the machine then you will need to wash the filter at the top of the machine. you will have to remove the ... Hoover U5780-900 Windtunnel Cyclonic Bagless UprightVacuum

Overheating Hoover My Hoover cyclonic 1800w keeps overheating and turning itself off, not sure if it's the filter, I've cleaned it but it didn't look very dirty.

Most likely caused by a lack of airflow. Check to see if you have airflow at the end of the hose. If not, Remove all of the hoses and ensure that they are not clogged. If there is airflow through the hose; check the air inlet immediately aft of the b ... Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum

My hoover keeps cutting out I have washed the filters and changed the bag but still keeps cutting out every 15secs

... Hoover Vacuums

My Miele vacuum cleaner has the red triangle light on and keeps switching on and off. Is it broken? have been hoovering upstairs and I noticed the hoover had the red triangle light on. I changed the hoover bag but it still kept going on and off. Is this an overheating problem or is the hoover on the way out?

... Miele Vacuums

Motor in hoover flair keeps overheating and turning off

... Hoover S2220 Flair Bagless Upright Vacuum

Hoover Model U8185-900 beater bar part keeps smoking and burning up We've replaced the part Hoover PCB Display Bridge U8172 three times and the vac beater bar works for about a minute then the part starts to smoke and burns out again. I've taken everything apart but cannot locate anything that would cause this part to burn up. I think if I did not disconnet immediately, he vac would catch my rug on fire. Help? I didn't send back the warranty card, so I can't get any help from Hoover. Any suggest

I'm not sure why this is happening. Perhaps if you would contact Hoover and explain the problem to them such that it appears that there is a safety issue with their product, they might be more cooperative. If that fails, I have had luck writing let ... Hoover U8185-900 Upright Vacuum


If it were mine and it was brand new I would bring it back and exchange it. It sounds like the motor is over heating and shutting off automatically. Does not sound good. My advice return it. ... Vacuums

Have an lg Hoover and the red light on the handle keeps flashing and the blue light on the Hoover is also flashing and then it cuts out. Has little suction with the head on it but better when you take it off. How do I fix the problem?

... Vacuums

I have a vax power 6 hoover, this was bought in January this year replacing the previous 2 I had bought in 2012. I get the same problem each time in that the hoover cuts out after using it for 5 minutes and I cannot use it again for another half an hour. WHAT IS THE PROBLEM WITH IT?

... Vacuums

After a few minutes the hoover stops. After waiting a few minutes it runs again but the problem keeps repeating

You haven't stated the exact make and model but in general what you're experiencing is a safety feature: your machine is overheating and cuts out to prevent a fire.Check that the bag isn't full and also check the moving parts for anything ... Electrolux Vacuums

I have a Panasonic MCE6003 vacuum cleaner. I regretfully leant it to a neighbour and it came back full of dog hair and keeps cutting out. I cleaned out the dust container and the main filter but it still kept cutting out after 5 minutes. I decided to unscrew the part with the motor and wash the filter inside.It was all going well until a large rubber washer bit, a piece that looks like the thermostat and a little white button attached to two black wires fell out and now I have no idea how to put

... Panasonic Vacuums

DC07 cuts out and stops after about 1 minute's use. It will restart after being left for c. 5 minutes. It seems, therefore that it must be overheating, but an independent electrician could not find any problem.

... Dyson Vacuums

Hoover 1900w keeps cutting out - Hoover Vacuums

Opened it up little senser near the moter on a wire moved away from the motor dont cut out anymore ... Hoover Vacuums

My hoover Wind Tunnel vacuum cleaner's motor spindle keeps overheating. Because of the high temperature, it keeps burning through belts (the big, wide ones). I have taken it in to the vacuum repair shop about three times now, and the problem has never been fixed. Does anyone have any advice on how to fix this or should I just buy a new vacuum?

... Vacuums

Russell hobbs hoover upright pets cyclonic 2000 cuts out after 10 minutes use

... Vacuums

My hoover keeps on cutting out.

... Vacuums

My hoover keeps cutting off and on, now it doesn't even come on. I have checked the fuse its ok and i can't cheak the wireing,the plug is moulded into the socket.

Chances are your cord was damaged inside the insulation and over time it finally opened. That would cause the cac to not operate any more. If you have access to or one of your friends has a multimeter then you can check the wiring by using that meter ... Hoover Vacuums

Old Hoover Convertible Upright U4109 keeps breaking belts. I just replaced the belts twice and both broke within 2 minutes.

Did you make sure the brush that the belt turns is free to move?\015\012Sometimes they get bound up and will not turn and as a result, the belts either burn or break.\015\012Remove the roller brush, clean the ends and remove any debris, lubricate the ... Hoover Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0518 seconds