Having problems with your VAX Appliances 2000 Canister Vacuum ?

My vax 612 green solution pump light is now orange, why might this happen?

\015 Vax612 multi function cylinder. After a short use the solution pump button on light is glowing orange instead of green as it was at the start of the cleaning session.\015

Answers :

Repair Help & Product Troubleshooting for VAX Appliances 2000 Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My vax 612 green solution pump light is now orange, why might this happen?

... VAX Appliances 2000 Canister Vacuum

Vax 612 Green pump light now orange after originally glowing green so what would cause this to happen?

... VAX Appliances Vacuums

I have a Roomba 560 (it's still in warranty !!) and, after my summer vacation, it has a problem. When I'm charging Roomba, the orange light blinks (and this is normal!) but this orange blinking continues forever.... the light doesn't change to green. If I detach Roomba from the charger, the light become green and it works normally until the light changes to red and I have to charge it again. WHY, DURING THE CHARGING PHASE, THE LIGHT DOESN'T CHANGE FROM ORANGE-BLINKING TO GREEN? HAVE I

The problem is not with the charger itself but it is with the battery inside the Roomba. It sunds like one or more of the cells has gone bad so its not holding the same charge as it did. I would recomend sending it in while the warranty is still vali ... Roomba Robotic Floor Bagless Vacuum

I have an electrolux Enviro multi steamer which I was using this morning. I turned the steamer off for approximately 1 1/2 to do some shopping, and when I turned it on again, the steamer light turned on (green light) and then I waited for the orange light to go on, which too a while. When the orange light does turn on, there is no steam when you press the yellow button on the handle. I have checked for water, and the steamer is full, I have turned it on and off several times just in case that wi

Problem fixed itself. Turned off for couple of hours so unit can cool down completely and when I turned it back on it started working again. ... Vacuums

My new H2O Mop Ultra (Danoz) seems to heat up ok then when the light switches to green and I start using it, the orange light comes back on as well as the green. Produces steam to start with but then it starts to spit water too and everything ends up wet. Any ideas on whats wrong or should I just send it back?

That is a major hardware fault, I have seen this numerous times with these H2O mop's... They seem to either work perfectly for a long while or have problems right off the bat. You definitely want to send this unit back and either get a refund or at ... Vacuums

The unit is charged, the charge indicator light is green, and the three lights on the top are lighted and steady but nothing happens. What am I doing wrong?

Press each cycle button and see if it starts up. I don't know if this is new and you just got it, but if so, you may need to remove any straps and retainers blocking the brushes etc. ... iRobot 4150 Roomba Vacuum

Miele S5000 (revolution 5000) vacuum cleaner - How do I open the casing? When the power button on the handle is pressed the green power-level lights on the handle light, but the motor sounds like it gives a little 'jump' but nothing more. The orange power light on the body also dims. I assume the motor or fan is jammed, but I can't open the body to find out. I've taken out to screws inside near either end of the handle, but to no apparent effect. I'm assuming the body is held together by plastic

... Vacuums

Hi, my Dyson DC16 works fine but after removing from charge base following recharge the red and green lights remain lit and the unit will not operate until i remove the battery and reconnect to vacuum,this extinguishes the lights and now can use with no problem.I guess that the charge control within the vacuum is not recognising that the unit has been removed from charge,is there a solution? Thanks

... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

No voltage to pump motor when the surface stain button is pressed, the unit is on and the green light for the pump is lit and stays lit.

You may want to contact one of BISSELL's Authorized Service Centers for assistance. Here's a link to locating one.\015\012http://www.bissell.co ... Bissell SpotBot Robotic Wet/Dry Vacuum

Hoover Savvy The red light for the dirt finder is on when pushing forward and the green light is on when pulling it back. This happens all the time. It's like the dirt finder sensor isn't working right. It seems to be picking up good and we keep the filter clean.

Does this happen at both Dirt Finder Sensitivity settings? ... Hoover U8171-900 / U8172-900 / U8173-900 / U8174-900 Savvy Bagless Upright Vacuum

Picked the zig cp3g at car boot sale,just what i was looking for,but no instructions just wires been cut,tidy little unit.on the battery transfer switch, red, green and blue. and from lights green,aux brown,and water pump yellow.....firstly how do i wire to power up,and how does the single wires from unit not have return wires,thanks.

Hi,\015\012\015\012For your requirement wiring will be following: the green wire will be from the knob beside\015\012the tree switch to battery switch. Red wire will be from another side of battery\015\012switch to circuit o ... Vacuums

The belt burnt out and it seems as though the red arrown does not release the belt. Like it is backwards from the green arrow. It had a burning smell and the belt broke. Then the second belt started to burn out when the brush roller wasn't spinning. Not sure what might be wrong. Green light will not come on either.

It sounds as if there may be a piece of the broken belt in there. Look carefully with a flash light and remove any remnants you find, using a pair of pliers if you have to.\015\012\015\012Also, remove the entire brush roller assembly and ... Kirby Ultimate G Bagged Upright Vacuum

I have a Sebo ET 350 e power head. Orange light is on along with green light and the roller is making a clicking sound - however brush looks clean and free of obstruction

... Vacuums

I own a old Bissell Big Green Cleaning Machine and am looking to replace the inline fluid/vaccum pump. The pump has an Eaton logo and is model CP7. I have not been able to find a replacement at your site. Could you tell me if one is still available or where I might find a replacement?

I just saw one on USAVacuum.com It's about $29 ... Vacuums

I recently bought a chefmate racket bug zapper from target, but can't seem to get it going. I pressed the buttons over and over so it would make it's high pitch sound and then i would know it was charged. never happened. what do i do next? I don't hear anything happening but do see the green light on. can you help?

... Vacuums

Hi, I have not owned my electrolux pronto 2 in 1 for very long but the roller brush has stopped turning. The handheld part works and the green light is on. I have done a thorough cleaning of the roller brush and all other removable parts. What might be causing the roller brush to not work? Thanks, Jen

Check the end cap bearings ... and replace the belt even though it may not be broken. Put a drop of sewing machine oil (no more) in each end cap bearing. ... Electrolux EL1000A2 Pronto Bagless Stick Cyclonic Vacuum

The light on Sunbeam Accura Digital Iron is flashing red instead of going from orange to green when switched on and reaching temperature. There is nothing in the manual to say what the problem is.

... Sunbeam Vacuums

I have a Bella Cucina beverage fountain and it is not pumping the beverage up the center to flow out the top. All that happens when I switch it on is that the lights come on.

... Vacuums

I have a Mr Coffee EMCP 50 Espresso maker. I tried to brew espresso but the coffee wasn't coming out because it was ground too fine. Now, there are 2 flashing lights one red and green-I have tried turning it off and turning it back on after waiting about 20 seconds so it will reset the pump but it is not working. Any suggestions?

... Vacuums

My Roomba 560 does not charge - Rapid orange flash on robot when charging. Both lights on Home Base are solid green.

Battery problem.If the battery is absolutely new,still it can be battery problem.But if the battery is old then replace the battery.To confirm the battery fault check the voltage of battery with meter.It should show exact volt.At least 12 volt.If the ... iRobot Roomba 560 Robotic Vacuum

You might not believe this but i don't know how to turn it on. I thought it was on the power nozzel but It is just got an orange light on. I know this sounds silly but please help me.

The on/off switch is located on the hose handle. The "O" is for off, "I" is vacuum only, and "II" is for vacuum and power nozzle. The light below the switch indicates there is power to the vacuum.\015\012If your vacuum doesn't run, there are ... Electrolux Guardian Bagged Canister Vacuum

I have a Shark Euro Sweeper, and it doesn't hold it's charge. I only use it a matter of a few minutes and already the green light turns to orange. I was told it would hold a charge for 30 minutes. So what's the deal?

I assume you've had the cleaner for a while and your battery is dying. Batteries can only be recharged a finite number of times and they also suffer from "memory loss" due to not being fully discharged before recharging.\015\012\015\012Ba ... Vacuums


Is there a reset on the top or on the back, if so, push it. If not, then you could have a bad connection or motor. ... Vacuums

Roomba Red shows pulsing red charging light, turns green, measured battery voltage - only shows about 5.5 volts. Borrowed and used neighbor's charging unit - same thing happened. It seems that the charging system inside the Roomba Red is not functioning. WShat else can I try?

... iRobot Roomba Red 4100 Bagless Robotic Vacuum

Plugged in vac and turned it on green light came but nothing happened it worked 2 days ago

... Simplicity 7850 Premier Bagged Canister Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0818 seconds