Having problems with your VAX Appliances Vacuums ?

Vax air 3 brushbar blocked

\015 Air three\012upright hoover brushbar will not go round\012please advise\015

Answers :

Repair Help & Product Troubleshooting for VAX Appliances Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hi I have a new sunbeam Eskimo ice maker I have had it on now for 3 hrs approx the water is cold and i have it on the med size blocks its only bringing down 4 ice blocks in the 3 hr period is that normal as its not doing much else i have tried to switch it off and on again and is not making any difference i have been watching and waiting and follpowed instruction booklet to the letter so why am i not getting lots of ice blocks as i said water is nice and cold.


Sorry to read about your problem, I hope this helps you out.yesI tried to help you. Please help me and Rate/Vote on my response, thanks and good luck ... Sunbeam Vacuums

Lindhaus 031207 blue wire from motor pulled out from terminal block - need wiring diagram to tell where it goes back into the terminal block


I am sorry that this happened. It appears the unit is proprietary and you can download most of the information that you seek from:\015\012http://www.lindhaususa.com/support. ... Lindhaus HEPA 14 HealthCare Pro Bagged Upright Vacuum

Blocked suction The FLOOR suction line (Hose) is clogged. I Can vaceum the floor, but it will not pick up anything because the hose to the bagless canister is blocked. I can switch from floor to hose and can vaceum furniture. it will not pick up off the floor. I have tried running a wire down/up the hose. I Can feel the blockage, but I cannot get it out. I am afraid to pull the flem hose out as I do not know how it is attached at each end.


Hi,Here is a tip that I wrote about my Bissel ... the hose should just pull out... it is just stuck in there tightly...\015\012Bissell Bagless Upright Vacuum ... Royal 088500 Featherlite Upright Vacuum

Is it possible to take the Hoover Brush Block Assembly F7220-900 #48437029 apart so that I can thoroughly clean inside the block? It looks like it could, but I don't want to break it by trying.


... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

How do I block text messages that I'm receiving from the same caller. I know the callers number and want to block them from contacting me. Hope you can help Kindest Regards


Contact your service provider they can walk you through it on your online account or otherwise manually enter the data you need to block or restrict calls from - typically there's a fee for this service.Best regardsCk ... Vacuums

Just stopped steaming. something must be blocked.


Add vinegar and let soak over-nite, think of it as cleaning out your iron.thanks ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Dyson DC01 Blocked Hose


Unclip the hose and push a garden hosepipe throughit. that will clear any blockedge in the dco1 hose. ... Vacuums

Polti vaporetto 2400. Steam is escaping from the central connector block. Help!


... Polti Vaporetto 2400 Canister Steam Vacuum

F5915-900 hoover steam vac brush block diassemble


Click the link below for the manual it will give you step by step instructions how to dismantle the brushes.http://hoover.com/file/601/ ... Vacuums

Guinea pig bedding has blocked the sweeper hole


The base of the vacuum needs to come apart. You will need the service manual if this is not a common task for you. It may be possible to reach the vacuum hole if the roller is removed.The service manual is here:http://www.hoover.com/shop/ ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

My bush bag less vacuum cleaner 1800 is not working properly keeps saying blocked cant find manual


... Bush Vacuums

Hoover HCV 280 multi cyclonic filter block


... Hoover Vacuums

Hoover eite rewind vacuum has blocked airflow, how do i fix?


I had the same issue, but with a little time and a screwdriver, i got my vacuum working like new.First, remove the bottom cover where the brush is located. Once the cover is off you'll see the vacuum inlet hose just behind the brush. Clea ... Hoover U5507900 Elite Rewind Bagless Upright Vacuum

I have a minuteman c37115-14 MPV14 vacuum. When I turn it on the brush will rotate for a second or two and then it stops. The light indicates "brush is blocked". Any idea what my problem is? TY Mark


Check your brush roll for string (from the carpet) or other debris in and or around the bearings on the ends of the brush roll. Or check your brush height. If you have the brush too low/close to the floor it drags the brush down, telling the circut b ... Vacuums

Won't **** I have a kenmore progressive upright bag vacume. when I turn it on it sounds find, then all the sudden it sounds like it has sucked something into it blocking the suction. Can you help?


There is what they call an intake.disconnect the hose and see if it make the same sound.if not then its clogged up in the hose.if it still makes the same sound with the hose off then here is what you have to do.on the top of the base there are 2 slid ... Kenmore 35912 / 35913 Progressive Upright Vacuum

Kenmore 21875 One day it's working fine. Next day, it won't turn on. When I attach the hose to another vacuum cleaner, it runs. Is there a reset button on the canister? Could it be the receptacle is bad? My Kenmore Progressive won't turn on today either -but was fine last week. I cleaned the filters checked for blocked air, tried a different outlet and no luck. I'll check the pins on the connections and see if one of them is not matching up or appears worn.


Give the prongs a wiggle and see if there is any play in them.Might just be a plug end. ... Kenmore 25512/ 25513 Progressive Canister Vacuum

I have no suction on my vacuum, I have checked everything, belts are good, and hoses appear to be clear of any blocks, any suggestions


Please give the model number and manufacturer of the vacuum. ... Vacuums

LOSING SUCTION IT APPEARS WHEN IN UPRIGHT POSITION, ALTHOUGH SUCKING (TO SOME DEGREE) IT THROWS BACK SMALL PIECES TO THE BACK OF THE VACUUM OPNTO THE CARPET BEHIND, AND THE CONTAINER HOLDING THE STUFF ISNT WHIRLING AROUND THE CONTAINER. I WONDER IF THE PASSAGE TO THE WIND TUNNEL IS BLOCKED, AND OF COURSE THAT IS THE PART I CANNOT GET TO, AS IT NEEDS A SPECIAL TOOL TO UNSCREW THE BACK OF THE VACUUM.


Is brushes moving, if so it is clogged , usually takes a star bit to take apart to clean ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

Blocked vacuum hose


You'll need a sturdy stick like a thick bamboo stick to push this out but remove the hose FIRST from the vacuum and compact the hose up before inserting the stick. Either that or you may have to order a new hose which can be cheap. What model is it y ... Vacuums

Engine troubles I have a 1975 4x4 GMC full size van. The motor is a 350 cid small block on propane. The thing hadn't been running in 5 years and when I tuned it up I changed vacuum advance pod on HEI distributor and hooked to a better vacuum and now the hotter it gets the faster it idols and when I try and turn the timing back, it starts hard. Wondering if vacuum is too strong or what is up?


I haven't fixed it yet but I think I might have a solution for it. From the factory this thing had a 4 barrel carb and they put an equivalent size atomizer in it for the propane and over the years someone omitted the EGR system in it and propane is a ... Vacuums

The bissell spray tube on my carpet cleaner won't spray, could it be blocked?


Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=575408\015\012Generic problem for all Vacuums\015\012The Bissell spray tube on\015\012Posted by jules0173 on May ... Vacuums

Eureka 4467AV overheats and shuts down after about 3 or 4 minutes of operation. I pulled all the filters to assure no blocked air flow. I assume the motor is not getting enough cooling air but i can't figure out why. checked bag for blockages as well as hoses. could the thermal protection have gone bad?


... Eureka 4467AV Upright Vacuum

Clogged filter my problem is with the filter it is always blocked with hair and debris, it makes a high pitched sound when it is clogged up and i don't why but it is not going into the canister. i have an animal dyson. any suggestions?


I found that the rubber seal on the bottom of my cyclone is not properly seated to the bottom of canister, I guessed when I removed the clear canister bin completely from cyclone unit for cleaning, I put the cyclone down on the floor and rubber seal ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I have a bissel powersteamer and it quit spraying the solution on to the carpet... the jets are not blocked....how can i get it working again?


Does water squirt out of the hose nozzle, if it does, then check the heater inside the handle asm. Make sure that where the tubes hook up to it are not clogged. If water doesn't squirt, check for the seal at the bottom of the tank, it needs to be o ... Vacuums

Series6500SR starts then stops-bag full light on-remove hose and it will run until Ipartially block the intake with my hand to simulate the hose. Bad sensor? how do Iopen this baby up? Can you send me parts?


There is an adjuster for the size of the dirt particles you are vacuuming on the top of the vacuum. Inside this adjuster moves an "O" ring up and down in a tube to adjust vacuum flow. The "O" ring is held in place by a plastic flange which is thin a ... Electrolux Epic 6500 Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0187 seconds