Having problems with your VAX Appliances Vax X3 Bagless Upright Vacuum ?

Hoover has no suction and base is getting very hot, have cleared all visible blockages


Answers :

Repair Help & Product Troubleshooting for VAX Appliances Vax X3 Bagless Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover has no suction and base is getting very hot, have cleared all visible blockages


... VAX Appliances Vax X3 Bagless Upright Vacuum

Bissell upright has weak suction and motor running hot but can't find a blockage


... Bissell 8975 CleanView Bagless Upright Vacuum

My eureka optima upright bagless vaccum has VERY low suction using the floor part. the hose has excellent suction. i removed the little translucent door underneath and there were no blockages, i cleaned the brushroll thoroughly and that hasnt helped either. i know this probably isnt recommended but i turned it on to the floor setting with the brushroll off and stuck my fingers up the intake as far as i could, the suction was good further up but it just seems to stop down at the base. because i s


I will try and help here. Is the sole plate on the bottom of the vacuum complety on and there are no visible cracks along the seam where it meets the body? This is the usual cause for this. Onc you take of the plate to access the roller and brushes, ... Eureka 431A Optima Bagless Upright Vacuum

No suction when wand is used. Checked for all blockage. If you disconnect no suction at base


Hi there,Sorry to hear you're having difficulties with your DC24. Although I note you've already checked for blockages, you may wish to follow the steps shown in our support guide, to make sure you haven't missed anything: ... Dyson Ball DC24 Bagless Upright Vacuum

No suction I've only had my vacuum for a couple of months and it seem I have a similar problem but there is no clear blockage. It seems like I don't have adequate suction that reaches the accessory hoses nor the main one. I'm not sure where to start. I've taken the darn thing apart but I can't see any obvious malfunction. Any suggestions?


If you have low suction at the end of the hose, then you either have a clog in the hose or a clogged filter. Take the hose off and drop something in it to see if it comes out the other end. If you have suction at the end of the hose, then the dirt ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

Motor sounds loud and high pitched. Suction seem ok, can't find any blockages. Cleaned filter at top of removable canister. Exhaust seems hot and low. Can there be a blockage within the motor housing?


Most likely your bearings are shot. it will need a new motor ... Kenmore Vacuums

When my dyson dc14 hoover is on it has a strange burning smell, and a noise like air popping, there seems to be suction from beater and it spins. and definitley suction from extension. Filters are clear and no blockages. Is it the belt I don't think it is. or motor ? Grateful for any advice.


It could be the belt. However, the popping sound does have me puzzled. The popping could be coming from a partially broken belt slapping against plastic.Jim ... Vacuums

My sebo 1.1 has a red light flashing, indicating bag needs emptied or clog. There is plenty suction with the hose attachments, and I cannot see any blockages in hoses etc. Some of the dirt seems to be collecting in the small flap in the base of the hoover. Any tips as to what could be the problem would be gratefully received


... Sebo Automatic X1 Bagged Upright Vacuum

Have a quite new easyvac. Worked great the first time. Emptied the cannister, put it back together, and now have no suction. Only hot air flowing out from near the bottom of the clear cannister.


Check the clear canister. You may not have:\015\012\015\012gotten it seated correctly\015\012there is dirt or some other object preventing a good seal\015\012you lost or dislodged ... Bissell Vacuums

I have a PAWS Windtunnel T Series with no suction. The roller and band on the bottom run fine and I've cleared all visible debris. NO LUCK so far.


... Hoover Vacuums

DC25 telescoping handle does not seat tightly. When pulling the vac back it unseats about 2 inches. This prevents the hose from engaging securely in the base and suction is affected. Do I need to replace the clear wand release catch? I've only had the vac about a year and am surprised it would wear out so quickly.


... Dyson DC25 Vacuum

I got a cord wrapped around the roller, and now neither the roller nor the suction work...only hot air coming out the top of the base.


To unrap the cord from this vacuum you will have to do the following:\015\012First turn the vacuum upside down and place head on counter and handle on the floor. You will have remove the base plate. There are 3 screws that hold it in place. Sin ... Eureka Smartvac 4870 Bagged Upright Vacuum

My dyson has two gears as it were! One for normal suction and the other for deeper cleaning. There used to be a real difference in the performance between the two options, also the noise changed when you swithched from one to the other. This no longer occurs. I have taken it apart according to your instruction, cleaned all the various bits but still no luck. The cat fur is still clearly visible despite my best efforts. Can you please help!!!!


... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

The hose has no suction and shrinks up so that it can't even be put back on the vacuum w/o turning it off. I have checked everything that I can think of and don't see any blockage anywhere. I washed the filter about one month ago and I clear it at least once a week.


Just happened to me. Took everything apart. No blockage in the flexable tubing or connections then I looked down the hard, telescoping tube and saw that it was occluded. Everything's fine and dandy now. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Hoover z400 I accidentally vacuumed a fairly large object through the hose attachment. Suction is now limited and I do not know how to clear the hose (obviously at the base).


Take off thebottom plate and brush roll, then you can check the inlet from the bottom. If it is clear, then it is probably in the hose. Remove the hose and try to fish it out. ... Vacuums

Dyson DC 14 hose has no suction, with or without brush attachments. Hot air shoots out from the base of the canister when I try to use the hose. I cleaned the top filter, but can't figure out how to remove the hepa filter to clean it without destroying the case. It looks like it might take three hands to insert pennies and "flip" the case open as is suggested on a youtube video for a different model. Would this even help, assuming I could get the thing open?


... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

No suction. I have followed the detachable parts no suction. I have followed the detachable parts and it seems to have suction through to the base but doesn't pick up anything significant. I have looked through the hose connecting the base but I can not see anything obstructing it.


Poor suction can be caused by obstructions, poor air flow or a compomise in the air flow (hole in the hose). Since you have started with that I would next look at all filters and clean them. First check for suction at the motor, then at accessory hos ... Vacuums

I have an older model fantom vacuum (model TH56SK 00) that I was given without the manual. It is whistling and stamped on top is "whistle = blockage check manual" which of course I can't do, but I need to find and clear the blockage. I need to clear the blockage now, but would like to obtain the manual for future issues.


... Vacuums

Bissell 2x has suction coming out of the "base" part(when I put my had over the rubber ring that leads from base to the handle part there's suction), but there's no suction coming out of the hose. I'm not certain if there's a clog, 'cause I can't get the hose off.


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

No blockage, but no suction and food disaappeared?


Make sure the bagless canister is snug in place. This will affect the suction also. ... Dirt Devil M086700 Vision Bagless Upright Vacuum

Suction through hose but not base


Mine did the same when new, i checked all as above then i noticed that i could twist the round peice that will unplug) (right behind the carpet-bare floor knob) and then i got suction at the base to be able to vacuum the floors, then i notice that th ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Vaccum does not seem to have good suction replaced bag & hose is clear


... Kenmore 23812 Progressive PowerMate Bagged Canister Vacuum

My vac has lost suction. When I vacuum it picks up very little, but when I remove the wand hose it has good suction. We have cleaned both filters, checked for blockage in all hoses & cleaned the beater bar brush. All to no avail. Is it the motor? Or is there a blockage deep in the vac somewhere? We're debating repair versus buying a new one. Hope you can help. Thanks.


Hi there,Sorry to hear you're having a problem with your DC14. Since you say you've already washed the filters and checked for blockages, it's probably best if you get in touch with us so we can run through some simple troubleshooting ste ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

I have a DC17 which is only one year old. Today I lost suction and called for assistance. A Dyson technician told me to pull off the wand and see if it is clear. It was clogged so cleared out the obstruction. My filter was cleaned more than 24 hours ago. The vacuum still has no suction. Is it dead, any other suggestions. Please help.


Take the hoses off and give them a good shaking.\012or get a long piece of stiff wire and gently poke through the obstruction. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Kenmore vac has no suction in hose or base


Find a Shop that sells these & get them to show you.how it works. ... Kenmore 31912 Progressive Direct Drive Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0451 seconds