Having problems with your Windsor SR12 Sensor Bagged Upright Vacuum ?

My windsor sensor xp12 wont turn on - Windsor SR12 Sensor Bagged Upright Vacuum


Answers :

Repair Help & Product Troubleshooting for Windsor SR12 Sensor Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My windsor sensor xp12 wont turn on - Windsor SR12 Sensor Bagged Upright Vacuum


... Windsor SR12 Sensor Bagged Upright Vacuum

Windsor s12 turns of and on when using - Windsor SR12 Sensor Bagged Upright Vacuum


... Windsor SR12 Sensor Bagged Upright Vacuum

Windsor Sensor XP18 brush - Windsor SR12 Sensor Bagged Upright Vacuum


... Windsor SR12 Sensor Bagged Upright Vacuum

Need to replace vacuum door - Windsor SR12 Sensor Bagged Upright Vacuum


I pried up the back of the cover holding the height adjustment wheel and was able to snap the cover axle with the cover installed into place. ... Windsor SR12 Sensor Bagged Upright Vacuum

Clogged vacuum cleaner windsor sr12 bagged upright vacuum


... Windsor SR12 Sensor Bagged Upright Vacuum

Brush won't turn vs14 windsor versamatic - Windsor VS14 Versamatic Bagged Upright Vacuum


... Windsor VS14 Versamatic Bagged Upright Vacuum

Agitator wont turn - Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum


Some of these have a resetable circuit breaker, if it has one, push it. There is a motor on the brush roll which could be bad. There also is an on/off switch, it may have a problem.Also may have a switch where the hose goes into, some models have a ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

Hoover carpet scrubber brushes wont turn - Hoover U6434-900 Bagged Upright Vacuum


... Hoover U6434-900 Bagged Upright Vacuum

Just quit switch wont turn it back on - Dirt Devil M085530 Featherlite Bagged Upright Vacuum


... Dirt Devil M085530 Featherlite Bagged Upright Vacuum

It wont turn on...is there a reset button? - Hoover U5134-900 Bagged Upright Vacuum


... Hoover U5134-900 Bagged Upright Vacuum

Brush wont turn u6485900 - Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum


Here is manual > http://hoover.com/file/509/ ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

I have a Kenmore Elegance Vacuum with Dirt Sensor, Model # 116.30750400C, Serial number M41901532. When vacuuming the carpet the power head will work for 3-6 mins then automatically shut off, power is still there and lights work but the power head motor turns off and the suction stops. I will turn it off and on, check the outlet, flick the on off buttons...nothing. I will turn it off for a couple minutes and it turns back on and runs like normal. I've check the bags, filters, cleaned the hos


It is an electrical problem in the handle, if you can or know somebody that has any fix it ability it can be fixed in about ten minutes. Oh, and Sears SUCKS!! ... Kenmore 34612 Bagged Upright Vacuum

I have a Eureka Upright vacuum (4800 Series). When I try to start it by turning the switch on, it wont. For few days, I was able to get around this problem by repeatedly turning the switch on and off until it turned on but that does not work any more. Could it be something related to the switch it self or the power cable. My wife mentioned that one of my kids might have pulled the power cable too hard (at the back of the vacuum). Any help to solve this problem will be very much appreciated. Tha


... Eureka Smartvac 4870 Bagged Upright Vacuum

My dirt devil bagged upright(swivel glide) wont turn on..light on


\015\012its clogged that is what the light shows is that if your vacuum is clogged then that light will come on and it will shut off, i have the same vacuum and mine does not come on cause its not clogged\015\01 ... Dirt Devil SwivelGlide Bagged Upright Vacuum

My Windsor Sensor XP12 says the bag is full when it's not. I have removed the hose, brush, and filter and cleaned everything. I can put a bag on without the cover and it works great. However, when I add the bag to the front cover and close the latch the right way, it does not work. I'm thinking that the cover is not seating the bag correctly over the hole, but I can't figure out how to fix it. Any suggestions?


... Windsor SR12 Sensor Bagged Upright Vacuum

Hello, I have a problem with my Eureka Powerline bagged upright vacuum. It has a 12 amp motor and is model #4352, Type D. It was probably bought new in 1998. My problem is, while vacuuming today the motor seemed to slow down all of the sudden and then began smelling like burning rubber. I shut the vacuum off to check for blockages but could not find anything blocked. When I then turned it on again it runs but seems to only be running at 1/2 the motor speed and still has the rubber buring smell.


It sounds like a rubber sealing in the motor has come loose and is being constantly rubbed against the walls of the motor with would cause the smell and loss of motor speed caused by the fricton of rubber against the rod so if you can get to the moto ... Vacuums

My Eureka Altima Upright Vacuum Model 2996AVS Vacuum wont turn on. Any advice where to start? I would think it may be a fuse but do not know where it is on this vacuum.


... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

I have a Eureka 4800 series the Boss upright with a bag and Hepa filter. I love it! I was just vacuuming with the hose part and all was well and then suddenly the lower brush came on and a "burning" smell followed. Thought it was the belt so my husband was going to put on the new belt which I had on hand! When he turned it over, the "bar" that holds the belt looks as though it "shot through" the plastic side of the housing on the vacuum. There is melted plastic on the outside of the vacuum and o


I had the same problem. Take out the old belt if possible. Remove the 4 screws inside the filter and the 3 on the front of that housing. pull out the foam around the motor. carefully pull out the suction tube that is press fit against the motor. ... Eureka 4874 Bagged Upright Vacuum

My Eureka Altima Upright Vacuum Model 2996AVS Vacuum wont turn on. Any advice where to start? I would think it may be a fuse but do not know where it is on this vacuum.


Generally, on something with a cord and plug, the first thing I suspect is a bad spot in the cord where it connects to the plug. One way to check it is to turn the vacuum on, plug the plug into a good outlet that you have checked to make sure it wor ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

Vacuum will not turn off - Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum


(1) Please check the four screws that mount the upper handle to the lower handle. If they are not tight, the actuation of the switch may not be adequate.\015\012\015\012(2) Remove the four screws and the upper handle. you will see the r ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Vacuum is turning on and off intermittently - Hoover Breathe Easy U5250-930 Bagged Upright Vacuum


Turn the vacuum ON.\012Go to the plug while it is in the outlet, jiggle it and the wire going into it to see if there is a loose connection on that end. \012Then go to where the wire enters the vacuum.\012Jiggle that to see if that ... Hoover Breathe Easy U5250-930 Bagged Upright Vacuum

Hi there, I have an excellent Electrolux (but older) Diplomat LX model which stops when the bag is supposedly full. It''s not full however, but merely 1/4 to 1/3 full. I'd like to reduce the "sensitivity" of the sensor or turn it off altogether. I don't run my vacuum with a full bag, but there's a limit. Please tell me how to address this problem. Thanks very much. Pierre


... Electrolux Vacuums

We understand that your problem is: I currently own and use on a regular basis the Kenmore Progressive upright bagged vacuum. Model number 116.35923500. The headlight flickers and the intelliclean light stays red. Ive tried cleaning the intelliclean sensors, changed the bag, and cleaned off the agitator. Is this a power issue? Should I take it to the store? Any suggestions would be greatly appreciated


Welcome to fixya\012\012Hello\012\012 \012\012I have a solution for this ... Kenmore Progressive 35922 Bagged Upright Vacuum

Why won't my vacuum turn on? - Fuller Brush FBHD1 Bagged Upright Vacuum


... Fuller Brush FBHD1 Bagged Upright Vacuum

I have the bissell power force bagged upright vacuum and the brush is not turning, I have replaced the belt but the brush will not move but the metal piece that is hooked to the motor that spins the belt and brush is turning but the brush won't, and the belt starts to burn


Sounds like your brush roll is seized. Remove the brush roll (see picture) and make both of the end caps spin freely. If not, replace it and you should be set. *An example of a brush roll* ... Bissell 3522 PowerForce Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1091 seconds