Having problems with your Vacuums ?
I have a Kenwood PSP-2002 steam press that won't stop beeping. Can you help please?
Repair Help & Product Troubleshooting for Vacuums
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
I have a Kenwood PSP-2002 steam press that won't stop beeping. Can you help please? Thanks.
We have a black & decker bottom load water cooler. It has been continually running then stops and starts beeping. We have checked the connections, made sure the bottle is loaded properly. That the seal is tight and it still cointues to run and beep. Can you helpe me?
I have purchased a bellini pressure cooker and the beeping wont stop and it wont start cooking
Roomba 530 I have a problem with my robot roomba 530. IN fact after 2 minutes, i start to "dance" in circle and stop and the red light is on and 9 beeps.....i don't know what to do....thanks a lot for your help Christophe
Hey\015\012\015\012Please look for other same problem posted here ;-)\015\012\015\012You are probably facing a bumper sensor issue.Try to clean the bumper first and if this goes on, either call ... iRobot Roomba 530 Robotic Vacuum
I have a kennmore 2005 electric range model 790.9661* the stove top is ok but no power to the over no erro message just completely blank I tunr off the oven from the electrical box to try to reset it but now it is still black and wont stop beeping!! any ideas??
... Kenmore Kennmore/Pannasonic Canister Vacuum Cleaner Cord Reel Rewind Assembly For MC-V9658 AC99NBEEZV07
My Roomba will not move forward. It will try and spin itself and then try to move forward but then spin itself again until it stops and beeps. I tried cleaning the whole unit but it still is unable move forward. Help please!
Heyis it 5xx Roomba ? is it 9 beep that it sounds ?Please look for other same problem posted here ;-)You are probably facing a bumper sensor issue.Try to clean the bumper first and if this goes ... iRobot Roomba 530 Robotic Vacuum
Sebo upright barged hoover- good suction using hose, brush wont turn, sounds fine when running, nasty wineing noise when stopping?? help!! i love my hoover, have checked for bolckages....
The real clue seems to be the brush is not turning, a bad belt is possible or a blockage at that head, if you cannot get the brush moving the rest does not matter. ... Sebo Felix Classic Bagged Upright Vacuum
Roomba 560 flashing red exclamation mark and makes series of beeps then stops. i cleaned it and it is still doing this. Help?
... iRobot Roomba 560 Robotic Vacuum
My swan steam generator iron s15040n is showing a push button when it is turned on. im pushing the button but it continues to say push and keeps beeping. the iron wont turn on at all. please help!!!!! thanks
Hoover F7431-900 my carpet shampooer/steam vac was working fine until the brushes at the bottom of it just miraculously stopped working. they wont spin at all. Is this a motor problem? perhaps a water flow problem? please write back if you can be of any help. thanks
If the screen is not dirty, and the flapper valve to the turbine inlet is open, then the problem is mostly a stuck turbine impeller. The turbine impeller on my F7431-900 has seized TWICE!! The shaft for the turbine is not made of stainless steel, t ... Hoover F7431-900 SteamVac Vacuum
My bissell power streamer (power brush) wont quit spraying water/soap...when I let go out the triger it doesnt stop. Any help would be awesome!!! Thank you!!
Hi Kerri. I'm sorry to hear about the continual spray with your machine. You may want to remove the handle, then reinstall making sure the screw is going in perfectly straight. If the machine continues to spray, you may need to have a qualifi ... Vacuums
My roomba backs away from docking station then starts to go then stops and spin left then stops and spins right after a few times stops and beeps many beeps. What is the problem
It sounds like the 9-beep error. You can fix it by buying a repair kit from www.eesolutions.ca. I fixed mine in about an hour and a half. ... iRobot Roomba 530 Robotic Vacuum
My Roomba 560 just spins in circles and then stops and beeps 9
Very common error. The fix is available here step-by-step 9 beep fix ... iRobot Roomba 560 Robotic Vacuum
New battery!, roomba runs for 5 - 10 seconds, stops, starts running, stops, runs, stops, then beeps and low battery flashes. Have taken battery out, held start button 20 seconds, replaced battery and directly connect to charger, 72 hours min., still same problem.
... iRobot Roomba Discovery SE Bagless Robotic Vacuum
In my (almost new) Dyson DC31 Animal the rolling brush tends to stop like the bearing was kind of difficult to turn. I opened the side carter and removed the little belt. Without the belt the engine runs regularly. I cleaned the little knots of hairs trapped in the bearing but still the brush runs for a while then stops, tries for a bit then stops again. I even tryed putting a bit of synthetic lubricant with apparently no result. Could it be a defective bearing? Thanks for your help.
... Dyson DC31 Animal Bagless Handheld Cyclonic Vacuum
I have a dyson DC23 and the turbine head will not turn anymore can anyone help on how to reset. I have cleaned it and there is no blokage its just stopped? Please can someone help
Pull the plunger into the ''out'' position for vacuuming carpets.For vacuuming hard floors push the plunger into the ''in'' position to stop the brushbar spinning.Refit the tool onto the ma ... Dyson DC23 Bagless Canister Cyclonic Vacuum
I have a kenmore upright model 116.36933 vac. motor wont stop unless i pull th plug the buttons work on everything else but stopping the vac
I have a Hoover Windtunnel 2 upright vvacum cleaner. During regular use my wife turned it on and it staarted cleaning, then all of a sudden it stopped and then started again then stopped for good. I unclugged the hose, cleane4de the brushes , blew the main filer and still cannot get it to start. The motor seemed hotter than usual. Can you help me? Lenny Rentz e-mail [email protected]
Actually, if you don't have continuity, then you have an open, not a short. ... Vacuums
Tv well it wont go back to number 6 which is the output for the direct tv hd box.There are 7 total outputs and it only letting me get to 0,7 every thing in between it wont let me get to.
Did you try unplugging you box from the a/c power. If that doesn't work, then you should call Direct TV, they need to reset your box. ... Vacuums
My roomba stopped working. I just turns in jerky circles then stops and beeps 9 times and shuts down. I cleaned it pretty well and that didn't change a thing.Any ideas would be welcome.
HeyLook at this pageGood luckAvi ... iRobot Roomba 560 Robotic Vacuum
My 400 series Discovery Roomba will no longer charge. It shows a green "charged" light, but when I hit clean, all lights/vacuum, etc just go out and it stops. Irobot says that the entire unit needs to be replaced, but it has to have something to do with the charging mechanism. Any Ideas? I've tried the system reset, and removing/replacing the battery. No effect. The robot doesn't give me the "uh-oh" beeps to be charged. It just stops and goes dead.
... Roomba Robotic Floor Bagless Vacuum
My Singer Izek sewing machine starts and stops and wont sew continuously. When I push down the pedal it sews about 2 inches then stops and light starts flashing, I have to let off of the pedal and push it again, over and over. It did this once before for awhile and then just started sewing right for awhile and now its started it again. I've checked everything.
If it's not the thread and not the pedal then it's definitely a power problem. You need to replace the power cable and then check again the functionality. ... Vacuums
Just wont fire up it was ok til i stopped to empty the bag now it just wont start
Try and remove and replace the same bag , watch for a switch that the bag may press on as a safety thing so it will not **** in dirt without the bag in ... Vacuums
I have an old Friedland door chime (approx 30 years old). It has 5 terminal screws to connect wires. They are labeled 0-4. I removed the chime during remodeling and would really like to reuse it. I did not label the wires and where they connect when I removed it. I can't figure out how to wire it. I contacted Friedman and they were of no help... didn't have information on chimes that old. Can you help with how to wire the chime given it has five connections screws with no labels other t
Chatter We have a Kirby Ultimate G. Since we purchased it it bounces across the floor and the level of the sweeper has nothing to do with it. To get it to stop, it has to be at the highest level. The place we bought it, has done nothing to help us. We tried a new beater brush, no help. If I have to use it at it's highest level to sweep my carpet, I might as well not waste my time. ANy suggestions?
Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=11557&thid=576381\015\012Chatter\015\012Posted by CANRN on May 06, 2008\015\012We have a Kirby Ultimate G. Since we purcha ... Kirby Ultimate G Bagged Upright Vacuum