Having problems with your Vacuums ?
Why wont my steamvac **** the water back up after shampooing
\015 My hoover steamvac used to work fine when sucking the water back up now it will barely suck the soiled water back up\015
Go to page 16 off this link> http://hoover.com/file/605/
Repair Help & Product Troubleshooting for Vacuums
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Why wont my steamvac **** the water back up after shampooing
Go to page 16 off this link> http://hoover.com/file/605/ ... Vacuums
My steamvac wont pick up the water. it is spinning and blowing out the water, but it wont **** it back in
The most common reason for lack of pick-up is that the lid is not seated firmly on the recovery tank. Lack of pick up is always caused by an air leak. A less common possibility is that the large round rubber seal that the recovery tank sits on has fa ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum
My Kirby shampooer - G4 - hardly used any water from the tank and no suds at all. Pet hair did blow out of the small slotted holes in the tray as I moved the shampooer back and forth, but the carpet was basically dry. I did vacuum before shampooing, so the brush part seemed to work great during shampooing, but no water! The small screen was stuck in the crook of the hose that attached to the tank so I did get that out and put it on the small hole on the tank, but it didn't make any difference. I
Few things:Make sure the sponge and the valve under the sponge (water tank) is clean.Make sure you follow the instructions (f you do not have the manual you can find one ... Kirby Ultimate G Bagged Upright Vacuum
My Bissell Proheat Turbo puts out too much water and cleaner and won't **** it back up like it should. Also when I use the attachments dirty water runs out the the hose when I am done. It's used a lot, I shampoo all the carpets about 2 times a month and I shampoo the funiture 1 time a month. I bought it about 3 months ago.
Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum
Water leak I just bought this steamer a few days ago, and already I am having problems, when I fill the water tank that your suppost to fill the water runs out before I even turn the machine on. I have tried using plugs to keep it from doing this just so I can shampoo my carpet, this seems to work to a point, considering the fact that there are two holes underneath close to the brushes and one just a little ways back from that location. Do you know if this is something that should have plugs or
If you just pruchased this, then it is under warranty, take it along with proof of purchase to a warranty repair shop and have them fix it. If water just runs out, then there may be a seal missing or a water line off. ... Eureka Atlantis 2595A Upright Wet/Dry Vacuum
My hoover steamvac wont **** up dirty water float
This will also happen if the recovery tank lid is not securely latched or the lid gasket is bad and is leaking air. No vacuum, and the tank overflow ball snaps into place. I had a tank lid latch fail, and the symptoms you report were identical. ... Hoover F7431-900 SteamVac Vacuum
Hoover Steamvac model F7425-9000: The shampoo bollte attached to the clean water reservoir became detached and now leaks shampoo prfusely. jerryhof
... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum
Shampoo system just bought the vaccum last night and could not get the shampoo system to pick up the water and could not get the system back on and both belts snapped so im pretty frustrated
Try this link....http://reviews.ebay.com/KIRBY-CARPET-SHAMPOOER-INSTRUCTIONS-MANUAL-DIRECTI ... Kirby Ultimate G Bagged Upright Vacuum
WHERE DO YOU PUT THE SHAMPOO IN THE PRO SHAMPOO MACHINE THERE IS A CONTAINER IN THE BACK AND THERE IS THE WATER BAG IN THE FRONT SECTION
\015\012the sprayer will not spray i cant get the water to come out to claen the carpet ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
Brushes wont turn and wont spray water - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum
... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum
For the first time, I tried using my Kirby Sentria shampoo attachment. I've lost the manual but found instructions online for making the swap from regular vac to shampoo-er and got it all assembled. The foam laid down just fine, however, when I run the vac back over the foam to pick it up, there is not a stitch of water showing up in the tray. First I thought maybe it was bc I hadn't put that much of the foam/water onto the carpet, but 12 hours later, the carpet is still wet in spots. Clearly
Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=638285\015\012Generic problem for all Vacuums\015\012For the first time, I\015\012Posted by MHicks on J ... Vacuums
My hoover steamvac spinscrub wont **** up water
ITS THE DUCT PIECE ON THE FRONT OF THE DIRTY WATER TANK (DWT). ITS NOT LINED UP. 1. TAKE LID OFF OF DWT2. SLIDE THE LITTLE SQUARE PIECE (5'X5'X1) (THE DUCT) ON THE FRONT OF THE DWT AS FAR UP AS POSSIBLE AND IF IT BEN ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum
Hand tool to hoover steamvac does not suck back up the water
... Hoover F5900-900 Upright Steam Vacuum
Hoover steamvac maxextract 60 wont spray clean water
... Hoover F6055-900 SteamVac Maxextract LS Wet/Dry Vacuum
Shampoo attachment wont pick up water
How do i hook up ... Kirby Ultimate G Bagged Upright Vacuum
I have a kirby sentria and after I shampoo'd the carpets I put it back together to be a regular vacuum and now it wont turn on. Any ideas what could be wrong?
The only thing I can think of is the brush head is not on properly.If the head is not aligned right,then the saftey switch wont be activated.Otherwise,I'd say the saftey switch or power switch.Did you make sure not to run over the cord? ... Vacuums
Hoover steamvac spin brush puts out water, won't pull it back up. Checked all parts, no cracks. Cleaned filter.
Check for the front panel duct located on the lower tank front. this is the part you need to remove to attach the hose. also check to make sure the lid is on and secure on the lower tank. remove the lower tank and look on top of the motor cover towar ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum
When I shampoo The excess water that is to come back in bucket has never happen I bought it a long time agp at KMart didn't know why it doesn't work. I oly paid $100.00 so I don't want to spend to much money to repair. I just borrow my sons machine. Janet
I BOUGHT MY STEAM VAC AT WALMART BACK IN OCTOBER AND DIDN'T TRY IT OUT FOR A FEW MONTHS, JUST TO REALIZE IT DOESN'T WORK! IT REALLY UPSETS ME BECAUSE HAD I KNOWN IT WASN'T GOING TO WORK I WOULD'VE BOUGHT A DIFFERENT BRAND WHEN I HAD THE MONEY!! ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum
Lost Suction This is my second hoover steamvac and i am having the same problem with my new one as i did with the old one that i tossed out. I have used it about 12 times and it worked great the first 6 times... Now i'll empty a full tank of water and only half will get sucked back up. I have tried taking it apart and cleaning and also the rubber seal had some gaps so i sealed those thinking that it was leaking air from there...can anyone help? I am so close to chucking this one and buying somet
Usually when there is no suction, one cause is the lid to the recovery tank is not on all of the way in the back. Also if you have that foam filter on the underneath side of the recovery tank lid, it needs to have a 1/4 in or so gap from the top of ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum
My steam VAC upright wont **** up water - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum
The most common and simple problem with these involves the recovery tank. Take it off, remove the cover and check to be sure it fits snugly. All tabs must be locked front AND back. If this machine has tools you have to hook up in order to use you ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum
How do you clean out the SteamVac...for example..the area where the water is sucked back through is very dirty...where it is visible from the outside
The easiest way is to rake the debris out with a piece of wire. More difficult, but better, is to remove the screws that hold the "wondow" on and clean. Some disassembly required! We see a lot of posts for cleaners that are stopped up. I know you ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum
Wont **** dirty water back out of carpet and it has nothing to do with the lid not being on properly, just no suction...
Please check and see if the round gasket is on the round vacuum pipe under the hood, that contacts the dirty water tank. It should be a soft seal that touches the round open cylinder on the base of the dirty water tank. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum
It wont **** water up - Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum
Try putting the recovery tank on again. check the filter screen at the bottom by the brushes and in side of the recovery tank screen. worst case, it will be the rubber grament under the recovery tank, to get to it you will have to.... remove the reco ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum
Lost suction Been using hoover steamvac today, worked great for the fist 2 hours, got ready to start back at it, and it has lost suction, have tried and tried the water tank repositioning, and nothing seems to work.
There is a screen by the brush that may be clogged. Make sure the water tank is on tight ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum
My Hoover SteamVac has been doing a wonderful job but in two instances, after emptying the dirty water and reattaching the reservoir, the machine has lost suction. The first time I was able to make it work again after taking it apart and putting it back together about 10 times. I don't know what I did that fixed it but as long as it worked again, I was happy. But it's happened again and I can't get it to vacuum. I can see that it isn't clogged. Can you please help me????
Look for the lower tank filter to be clean. also make sure the lower tank lid is on properly. latch when installed on machine. Make sure the front panel duct is on the lower tank. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum