Having problems with your Bissell Vacuums ?
Vacuum is very loud, bissell, not picking up as well, bagless vac, two years old
Repair Help & Product Troubleshooting for Bissell Vacuums
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Vacuum is very loud, bissell, not picking up as well, bagless vac, two years old
... Bissell Vacuums
Model number U5763900 Serial Number 090400013588 Handle broke off just above the four screws that attach it ti the boby of the vac. Hoover does not list parts for models that are more than two years old. The vac operates perfectly but without a handle my wife cannot use it, where can I find a part replacement. easy to remove four screws and replace. dont want to drive 100 or more miles to find a authorized repair shop. Oh yes, this is a Hoover Preferred Wind Tnnel Bagless
Get over it and buy a new one!!! ... Vacuums
Bissell Power Track Cyclonic Upright Bagless Vacuum.. ..The spin brush works laying down....when upright it won't spin! I cleaned any and all hair from the roller....belt is not broken....but do I need a new belt though? The vac is a few years old bever replaced the belt yet.
You need a new belt. ... Vacuums
I have had my Bissell Healthy Home for just over a year. I use it once or twice a week on five area rugs and two small bedrooms with wall to wall carpet. Just recently, the motor started to sound extremely loud and it smells like it's burning. The vacuum still picks up everything and all the brushes are turning. Advice? I really like this vacuum and would really like to fix it rather than replace it!
Hi,Here is a tip that I wrote about my Bissel but I bet you have the same problem and the hose is clogged...Bissell Bagless Upright Vacuum no ... Bissell 5770 Healthy Home Bagless Upright Cyclonic Vacuum
Vacuum is about 4 years old does not pick up well
Replace both filters and belt, all easy to do and reasonably cheap fix to a great hoover. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
My Bissell BS3920F upright (similar to the 10N6F) has been working wonderfully for the past 3 years but suddenly seems to not pick up dog hair as well as it used to. It has been pulled apart by my husband to ensure nothing is blocking the hoses etc and when running the suction seems to be there. It seems to grab the dog hair and leave it in a straight line directly under the unit without picking it up. I then disconnect the hose and use to hose to pick up the dog hair. This works well but obviou
Check to see if your brush is not worn down, they do wear with age - compare the length of the bristles with a new one. Replace the brush ir there is a significant difference in bristle lengths. Also check the flexible ben ... Bissell Vacuums
I have a Bissell PowerSteamer, Clearview approximately six years old. My son borrowed it two years ago and lost the instructions. I can't find a model number on it and need the instruction book. Thanks
Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum
Hi There I have got a Kirby 2 HG vaccum cleaner which is around 20 years old now. It was going really well until last week when one of the capacitors which are connected to the brushes blew up. There is two capacitors one for each brush. One of them completely blew to bits and the other one is still intact. My question is are they the same size and where do I get a new one from. I know it is an old machine, but I would like to fix it and get it going again. Any tips???
Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=541405\015\012Generic problem for all Vacuums\015\012Hi There I have got a\015\012Posted by opfinder on Apr 24, ... Vacuums
I have the Dyson animal upright vacuum. It's 2 years old and now it just isn't working as well as it once did. Suction seems to be lacking - it's not picking up pet hair or much else from the carpet. I have to go over the spot for a few minutes and still, the hair isn't picked up.
You might want to check and see if your cyclones are plugged with hair. this can happen and there is a great site to disassemble and clean the cyclone here: http://www.exonotes.com/content/node/4 ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum
My bissell worked well cleaning my carpets it's only 1 year old when i stop'd it to refill water it would turn on put not spray what can ido to fix this problem
TAKE OFF THE CLEAN WATER TUB IF IT COMES OFF TO FILL AND LOOK FOR SCREENS OR FILTERS THAT COULD BE PLUGGED OR AT LEAST LOOK FOR THE LINE THAT CARRYS THE WATER TO THE PUMP AND AGAIN CHECK FOR LIKE HARD SOAP AND STICK LIKE A NEEDLE IN IT BUT CARFUL NOT ... Vacuums
No suction Own a Bissell Easy vac (bagless). Only just over a month old & it lost suction from the brush roller & hose. We've cleaned all filters & checked hose for clogging. Any recommendations?
Http://www.fixya.com/support/t1845597-debris_getting_stuck_in_vacuum_hose ... Black & Decker Vacuums
The belt on my bissell 3065 power partner vacuum came off. i looped it around the post located under the roller but it just fell off again. how can i get it to stay on? this vac is 10 years old.
... Bissell 3065 Power Partner Vacuum
Bissell bagless vacuum-less than one year old
Http://geeksquad.fixya.com/ThreadView.aspx?prdid=50020&thid=706758\015\012Bissell bagless vacuum-less than one year old\015\012posted by nat9 on Jun 25, 2008\015\012 ... Bissell 3590 CleanView Bagless Upright Vacuum
The belt broke and after putting on new belt I dicscovered the cylinder with the brushes attached wasn't turning. After I finally got the cylinder to turn it makes a very very loud noise and also now it doesn't pick up the dirt. The vacuum is less than a year old.
Check the cylinder with brushes does not have hair or carpet fibers causing it to bind. With the belt removed the brush should turn freely and fairly easy. The original belt probably broke because of this. You may have to fully dis-assemble the head ... Dirt Devil Vacuums
The motor is very loud and dust is coming out. I was told (by a vacuum salesman) that bagless vacuums only last two years and that it would cost more to repair than to replace. Do you think this is true?
Depends on how often you use the vacuum, but I don't think the salesman is too far off the mark. Personally, I'd stay away from Hoover based on feedback I've read from others about poor quality. ... Hoover Elite Rewind Bagless Upright VacuumVacuum
I have a DC17 animal vacuum and it is not picking up as well as it used to. It misses small particles on the floor. The hand held piece seems to work ok, but otherwise, it seems to not have as much suction. What should I do. It is only a little over a year old.
It could be that you need a new belt. Over time the belt stretches and wears and then it doesn't pick up well. Here is a link to the belt you need.Dyson DC1 ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum
Vaccum is making a loud high pitched sound, doesn't work well through the hose or the floor piece and shuts its self off after about 5 minutes. I have cleaned the entire vacuum out several times but this problem persists. Usually after I clean it, it'll work for a couple months, not this time. Vacuum is only 2 years old, is this typical?
... Dirt Devil Featherlight Bagless Upright Vacuum
I have a hoover windtunnel bagless vac that is several years old. the floor vacuum part still works fine, but the handtool attachment has no suction and is useless all of a sudden.
Don't have your model number, but some have a valve down on the noozle part that may be broke. When it is its upright position, the valve won't change over to the hose only position. You would have to remove the top cover to see this. ... Vacuums
Unit is 3 years old and isn't picking up like it used to. Have to vacume over the same spot several time to get everything up and then it doesn't do it well.
OK. I'm not familiar with this particular vacuum, but I think you've said enough for me to give you some clues. Suction is one thing - air flow is another. If you've got good suction against your hand, then the problem is low air flow, and that's alm ... Kenmore 25614 / 25615 Progressive Bagged Canister Vacuum
Hoover Bagless Hello, My Hoover bag less (Model U5280-900) is not picking up dirt like it should. The brush roll is spinning fine, but the bristles on it are only about one quarter inch long. I am wondering how long they should be. The vacuum is quite a few years old. Do you think it is time to replace the brush roll. Could you email me at [email protected] about this topic. The product bar below did not contain my model no. The correct model no. is above in my message. Thanks
If the belt is more than six months old then change it even if it is not broken. then replace your filters if that doesnt work than check the hoses for a clog drop a marble down them and make sure it comes out. ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum
Hi I’ve got a Panasonic vacuum cleaner MC E468 1600W a few years old now but works well up to recent problem. Not picking up I checked the obvious things and found excessive air being sucked in around the hose housing at the back of the vacuum (as it enters the waste bag) On inspection it appears to me as if there should be some sort of gasket that may have perished and been sucked in, however I can’t identify any such part. Any thoughts on what the problem/solution may be will be appreciate
The hose on the back might be loose - check to see that the hose is not obstructing anything where it screws in at the back - or indeed the screws may be loose themselves; some of the MCE 468 models had an additional ring washer that sits between the ... Panasonic Vacuums
I have a Fein Turbo III shop vac for several years now...about a year ago, for no apparent reason it changed into a hideously LOUD beast! It's previously low decibel drone is now so loud it makes my ears ring afterwards...its sound is high pitched, almost like its hose is blocked, but it isn't...and suction remains good...I just can't take the sound...Help me.
It sounds like the bearings in the motor are shot. You can try to get a replacement motor, or if you're a mechanical genius type, you might be able to repair the motor bearings. If the shaft is worn, you'll have to buy a new motor.\015\012Y ... Fein 9-77-25 Turbo III Bagged Canister Vacuum
DYSON DC17 ABOUT 4 YEARS OLD. I HAVE TWO FILTERS THAT I ALTERNATE BECAUSE AFTER 2 HOURS OF VACUUMING I LOSE SUCTION. I HAVE TO WAIT 3 DAYS FOR MY FILTER TO DRY BEFORE I CAN SWITCH THEM AGAIN. THE FIRST TWO YEARS I HAD THE DYSON I COULD GO A COUPLE MONTHS BEFORE CHANGING THE FILTER. WHATS WRONG?
Hi there! This is John from Jerry's Vacuum Sales in Modesto Ca. Are you using any type of carpet fresh product on your carpet? If so the fine powder is leaking onto the filters and causing them to clog. Discontinue use and over time the problem will ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum
Bissel spot bot water not coming out of tank is not a year old and tried manual wand and the water doesn't come out there either. any advice. Is not a year old yet.
You could take the end of the handle off 2 screws i think check the line for a clog or just take it to a bissell service center it will be covered under warranty ... Bissell SpotBot Robotic Wet/Dry Vacuum
Hello, I have the same model. And though it is three years old, starting from the last month, it does not clean anything anymore. Cannot even pick up one single thing from the floor. Every dirt gets stuck in the hose. I cleaned the hose and cleaned the filters but it still does not pick anything up. Is three years its normal lifetime or do I have the change the filters, instead of cleaning them? Thanks.
I know bissell vacuums are very cheap but they should last more than 3 years. there should be two parts to the dirt cup. remove the dirt cup and above it there should be a round plastic part. unscrew it and check that filter. ... Bissell 6594 PowerForce Bagless Upright Vacuum