Having problems with your Euro-Pro Cordless Bagless Upright Sweeper - Blue/Gray ?
My shark v1917 jammed on a throw rug, won't start.
\015 Sucked up the corner of a throw rug and the machine quit. The brush turns freely by hand but when I turned it back on it won't rotate. The three red lights blink but no motor action. I can't find a reset button and did the "unjam" and wait 10 seconds, then turn it on and "it should run" but nothing happens. It's only been used 5 or 6 times and is fully charged. is it scrap?\015
Where do you find a replacement battery for this vacuum! It's a model V1917N 7.2 V. I can't find it anywhere!!
These machines do break VERY easy, however i would wait a couple of hours and try restarting it. If this does not work then i am sorry to say yes it is scrap.
Repair Help & Product Troubleshooting for Euro-Pro Cordless Bagless Upright Sweeper - Blue/Gray
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
My shark v1917 jammed on a throw rug, won't start.
Where do you find a replacement battery for this vacuum! It's a model V1917N 7.2 V. I can't find it anywhere!! ... Euro-Pro Cordless Bagless Upright Sweeper - Blue/Gray
Where is the reset button on shark navigator. vacuumed throw rug, and bar wont move
I'm not sure it has one. Check the owner's manual though.\015\012Try this. Turn off vacuum. Unplug it. Make sure there are no clogs in main hose, power head intake tube, or intake inside tank. Plug it in, turn it on, and let us know what h ... Euro-Pro EuroPro Shark Navigator Vacuum
My Shark steam cleaner S3325 wont start. Only used it 2 times. when plugged in the start light should come on and go off when the ready light goes on. Instead the ready light goes on and there is no heat. Any suggestiins will be appreciated.Thank you, Mary A
... Euro-Pro S3325 Handheld Steam Vacuum
My shark bagless sweeper worked for about 6 months. Like a previous blogger, I caught the edge of a rug that jammed the sweeper, three red lights blink, the brush is free moving yet the sweeper will not work. I did leave it plugged in all the time otherwise it would not run but for minutes. Very disappointed. New battery? what if that doesn't work? is it junk then, money down the drain.
This will probably cost you more to repair than to buy a new one. Does it turn on at all? ... Euro-Pro Cordless Bagless Upright Sweeper - Blue/Gray
Throw rug got caught in rollers and now it wont pick mup were are belts located on hoover windtunnel dual 5
Nylon belt in center of brush underneath . not a hard belt change. ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum
Wont start after a piece of paper got jammed in it.
... Eureka AirSpeed Bagless Zuum
I snagged a loose throw rug with the Dyson last night. It jammed the brushes which stopped spinning, Once I removed all the entangled fibers the motor won't turn. The vacume still sucks, but the brushes don't spin I'm concerned I burnt up the motor for the brushes
Have you checked the belt? You can do so by removing the bottom plate from the power head. Once removed, check the belt. If broken or worn, it needs replaced.\015\012An instruction video for replacing the belt can be found on the below link. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum
Shark Euro-Pro cordless vacuum won't start
Sounds like it needs to be serviced. Call customer service here to help you. \015\012\015\012\015\012\015\012Tel: 1 866 98SHARK (1 866 987-4275)\015\012\015\012Is it still under the 1 year warranty.\015\012\0 ... Vacuums
I have a Kirby Dual Sanitronic '50' Vacuum Cleaner I bought in 1966. The motor does not start when I attach the belt lifter of the rug nozzle. When I remove the rug nozzle and detach the belt from the motor fan shaft the motor starts when I depress the nozzle switch and the power switch . Seems like the brushes in the motor are worn out. I do not have a manual for this unit. Can you assist me as to what newer unit is this compatible to and the problem I'm having at present??
... Kirby Vacuums
Simplicity vacuum My vacuum just cut off and now it wont start. I pressed there restart button but nothing happens I have 2 fairly old Industrial hitachi dry vacuum in my workshop both 110v and both wont start. Both i was told were manufactured in Italy and both have a manual and auto switch. It has a black top, takes an orange paper filter inside and its bin is dark blue. Sorry i've forgotton the model number. I've inspected the wiring but it's fine, could it be the motor and how do i gain acc
Just take it in to your vacuum store. ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum
Wont start heater light on but wont start
If you mean power light (a vacuum) what is the brand and model number? ... Vacuums
Mt dyson dc5 wont start at all - have cleaned it and checked fuse but still wont start
My Singer Izek sewing machine starts and stops and wont sew continuously. When I push down the pedal it sews about 2 inches then stops and light starts flashing, I have to let off of the pedal and push it again, over and over. It did this once before for awhile and then just started sewing right for awhile and now its started it again. I've checked everything.
If it's not the thread and not the pedal then it's definitely a power problem. You need to replace the power cable and then check again the functionality. ... Vacuums
When I turned on the sweeper it would not start. I put a different power cord on it and it worked fine. now it won't start but the light on the brush and the bag full will flash when i turn it on and off but it wont start. i have 2 of these doing the same thing. do you have any idea what could be wrong. I have checked for clogs but have found none. Bob
Its sounds to me like the computer board inside the machine has gone bad. Keep in mind that the filters in these machine do need to be replaced regularly to keep the vacuum working correctly. Any good vacuum shop should be able to fix your problem. R ... Windsor SR12 Sensor Bagged Upright Vacuum
While using my Dyson a rug got caught and that ratcheting sound started. I removed all signs of strings, etc until the brushes rotated fine but when I started the Dyson the ratcheting started again. I have the DC 14 Animal.
The rattly sound means the drive belt has snapped or the protective clutch has slipped. This needs repair by someone who knows how to repair Dysons officially. Sadly its the kind of model that can't be done by the owner. ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum
The kirby wont start no power
... Kirby G6 Bagged Upright Vacuum
Loud noise I have a brand new Dyson and it is great on all my floors except one of my area rugs when it starts making this really loud vibrating noise. I am not sure why - nothing is stuck in the roller or vacuum and it doesn't make it on any of my other rugs. Also it is really hard to push whereas all the other floors it just glides. I don't want to return it but I also don't want to hear this sound every time I vacuum.
This is the clutch as it jams up in the brush. Usually happens with rugs that are not secured to the floor. ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum
My roomba no longer works on my area rug, it starts backing up continuously once it encounters the rug.
Sorry to read about your problem, I hope this helps you out.iRobot Roomba Vacuuming\015\012 Robots and the iRobot Dirt Dog Workshop Robot are equipped with four \015\012infrared Cliff Sensors that prevent robots from falling off sta ... Roomba Robotic Floor Bagless Vacuum
A friend who bought a multimaster less than a year ago has had his start a loud 'clattering', dry, noise, and the gearbox started to get hot. The output shaft now has about the same amount of slop as the total movement should be. It is one of the quick attach type. I bought one of the allen key attach type, and have found in the past with various 'name brand' tools, drills, angle grinders etc that they usually use a 'dry' type grease which soon throws off the necessary parts and they run dry u
Fein is an excellent tool and has an excellent warranty that will be void the moment you open the gearbox. I do not recommend this action. Fein is quick and responsive, especially for a less than one year issue.\015\012Farmerbear at FixYa.com ... Fein Multimaster Rs - Msxe 636 - 2 Rs
My Ryobi 720r wont start. Absolutely no response at choke + engage lever. I checked the spark plug but no luck. Just test i put little gas in the spark plug chamber. It started only to burn what was in the chamber then stopped.
Question mark light has come on my vacuum and it wont run. I replaced the bag, but it wont start. I don't have a new filter is that the problem?
... Electrolux Vacuums
Bissell proheat 2x rug cleaner wont spray water out on rug when you press button
Hi,Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem.B ... Bissell 8910 ProHeat Clear View Upright Vacuum
While vacuuming my carpet, a corner of a throw blanket was sucked into the beater bar. I turned the vacuum off and was able to pull the corner of the throw blanket out without much resistence. I plugged the vacuum in and started it and now the beater bar isn't rotating.
Try pressing the reset button on the nozzle, probably just tripped out the brushroll motor ... Dyson DC15 All Floors - The Ball Bagless Upright Cyclonic Vacuum
I tried to start it and it wont start it isnt the outlit Please help
Internal switch may be too tight to toggle and became disconnected from plastic mechanical slide mechanism. Replace switch for $20.00 and you should be good to go. ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum
Just wont fire up it was ok til i stopped to empty the bag now it just wont start
Try and remove and replace the same bag , watch for a switch that the bag may press on as a safety thing so it will not **** in dirt without the bag in ... Vacuums