Having problems with your Hoover S2220 Flair Bagless Upright Vacuum ?
Flair motor shorting out?
\015 My 4-month-old Hoover Flair exhibits an intermittent failure: after running for 30 minutes or so, the motor will no longer switch on. Toggling the switch all the way forward turns on the brush, which spins away merrily, but in both the middle ("bare floor") and forward ("carpet") position, no motor, and thus no suction.As noted, this problem is intermittent and if I let the Flair sit for a few days, it seems to restore function, but only very briefly. Could this be heat-related? Is there perhaps some sort of "cut-off" in the design which disables the motor if it seems to be running hot?I should note that Hoover "support" did not respond at all to my email inquiry well over a week ago, so unless I\015\012can get the Flair running reliably in fairly short order, back it will\015\012go. I will then shop for a product whose manufacturer actually supports\015\012it.Thanks for any assistance you can provide.\015
There's a thermal cut-off when the unit has overheated. Mine does this quite often and I remedy it by emptying the canister and making sure the filter is clean, especially of lint and things that prevent good air flow.
THERE IS A STICKER RIGHT ON THE BACK THAT SAYS IT NEEDS 30 MINUTES TO RESET. THE FILTER MUST BE KEPT CLEAN. i USE A SECOND VAC TO CLEAN IT. WORKS WELL THAT WAY.
Repair Help & Product Troubleshooting for Hoover S2220 Flair Bagless Upright Vacuum
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Flair motor shorting out?
There's a thermal cut-off when the unit has overheated. Mine does this quite often and I remedy it by emptying the canister and making sure the filter is clean, especially of lint and things that prevent good air flow. ... Hoover S2220 Flair Bagless Upright Vacuum
Eurika Whirlwind vacuum cleaner. Nearly new. Suddenly lost succion.l I cleaned and dried the filter. It developed an odor, then stopped short. I believe the motor may be burned out. Motor is cool, but it won't start. Is there a fuse??t
Look around the nozzle it might have a reset switch ... Eureka WhirlWind Litespeed 5844 Upright Vacuum
DT 1300 As I am vacuuming the motor seems to fade in and out and sometimes stops running for a few seconds and then resumes. If I move the hose a bit near the vacuum end, it runs smoothly again. Does this sounds as if there might be a short in the motor? Would this be something I can fix myself or does the vacuum need to go in for repairs.
... Oreck DutchTech DTX1300C with Motorized Carpet Brush Bagged Canister Vacuum
Kenmore Progressive 21514 canister vac motor is weak and shorting due to debris. Can motor be opened to clean out?
My vacuum cleaner has power through the switch and through to motor but will not go .The motor has no short in the winding what can be wrong
If you are sure voltage is going to the motor, then replace the motor brushes if its older than 4 years as they will be worn, what you may find is a broken wire @ the coils...... ... Hoover S3630 WindTunnel Bagged Canister Vacuum
The motor is overheating and shutting off -- after vacuuming for a short time the vacuum motor shuts off
Sounds like there is a clog somewhere or a filter needs to be cleaned if it has one. Or the bag may need emptied.Jim ... Vacuums
Malfunction 8 franke flair. I have removed the brewing unit o rings to free up the drive. Drive motor keeps over running the top and bottom limits hence gears grinding. Could it be the sensor on the back of the motor? What is it measuring? Any help appreciated
We have a dyson dc 07 animal the machine was working fine then switched off after returning to the machine minutes later it wouldnt switch on, i removed on off switch cover and used a short piece of wire across the brown wires flicked the wall switch and it worked, aha i thought faulty switch aquired a new one to no avail and now even the short piece of wire trick doesnt work, has the motor died do you think, it wasnt over heating or making strange noises prior to refusing to work
It could be the motor. I'm having to replace the brushes on my DC 05. It appears that you can only get brushes for the YDK motors in the DYSON, not the Panasonic motor. Which might be saying something about the YDK motors. What happens is that the ca ... Dyson DC05 Cylinder Bagless Canister Cyclonic Vacuum
Hi., If anyone could help it would be greatly appreciated, I have a Flair 3055 ventalation system in my house and over the last five years two fan motors have gone bad. it has been mickey moused together by a local repair man, and as of last week, it has died again. At 4-5 hundred a pop I would like to fix it myself, can anyone suggest a good replacement motor that will fit and work. My honey has breading problems and at this time of year, every penny is allocated, so time is of the essence. t
Hello George, Sorry about your predicament. Various fans are available for your unit but since you say the unit has been mickey moused together adjustments must have been made to the fan seating and system therefore if you order any particular fan th ... Vacuums
I have a kenmore canister vacuum cleaner, 4 yrs. old, model #116.27815701. The powermate assembly, the one for the carpet, seems to have a short or something. The light goes on and off and the motor
... Kenmore Vacuums
It acts like it has a short in the hose you can hear the motor running and then it will quit. Moving the hose around you can get it to turn back on.
Hello. There is either a short or a poor contact at some location within the hose. In order to fix this you may have to replace the power hose. Joe ... Kenmore 23913 Progressive PowerMate Bagged Canister Vacuum
How do you access the on/off switch on a Nilfisk King 505? Mine appears to have broken, and I am handy enough that I can replace or maybe fix it - If I can reach it! When I went to switch it on, it gave a very short (half second) turn-over of the motor, and then totally died.
Did it work? Should we suggest other options? ... Vacuums
I have a BISSELL CLEANVIEW II, I turn the power switch to "on" and am able to clean carpet for 1/2 a minute until the power shuts off in the outlet the vacuum is plugged into! The same repeats itself! I wonder if the motor is damaged or just plain shorted out!
Well yes in deed it is time for a new vac. for the motor bearings or armature are ceasing up ang causing the breaker to pop. if the vac. cord is hot then you know for sure... ... Vacuums
Bosch terrossa 1700w vacume cleaner make load noise when turn up tp high setting and the motor make a shorting out noise
... Bosch Vacuums
I have a short in my hose for the GE 2 motor canister vacuum model106766 where do i get just the hose to replace it
Hi,Here is a website for parts for your vacuum: http://www.appliancefactoryparts.com/vacuumcleaners/brands/ge/106766.html#Other%20PartsI hope this helps. I was confused by your statement that you have a short in your hose. Are ... GE 106766 Bagged Canister Vacuum
My circuit board has a short on the soldering for the DC rectifier that supplies the carpet cleaning motor. Where can I order a new circuit board. Miele S251i
Just a suggestion, but you could try to re-solder the connection on the board. some of the circuit boards did not have enough solder on the board coming from the factory. That being said, if the component is damaged due to the burning, I ... Miele S251i Plus Bagged Canister Vacuum
Hoover HU 4205 not blocked up, motor overheats and trips thermal cutout ,after a short time.
... Hoover Vacuums
How do I take apart the body of dirt devil 82500? I think something shorted out, and want to see if I can fix it. I took all visible screws out of body, but still can't separate the two halves to get to the motor
This is sort of easy, and hard at the same time. \012\012First remove the dirt canister and hose. \012take out your exhaust filter. \012find all of your screws on the one side of the unit and remove them. \012you will fi ... Dirt Devil MO82500 Bagless Canister Vacuum
Vacuum cleaner shuts off after short use. What's the reason. Motor seems very hot.
Almost all vacuum cleaners have a thermal cut-out, which operates when the machine gets too hot. It resets automatically when it cools down. Overheating is almost always caused by a blockage. Either the filters need cleaning or changing, or the ... Bosch BUC11700UC Cyclone Jet Bagless Upright Vacuum
Motor grind Loud sound and smell on occasion. Started as just short sound as turned off, +/- 2 seconds. Now does it on star up unless I tilt the unit back. Ideas? Is it worth fixing? ns
Try checking the belt, that is probably the smell, might need replacing ... Hoover Floormate H3000 Upright Wet/Dry Vacuum
Belts on my vacuum last only a short time, the keep getting chewed up. Seems that the belt does not align properly between the brush bar and the motor shaft.
The belt is either contacting the \015\0121. Check to see that the roller is installed properly (make sure it is not reversed and that it is all the way in).\015\0122. Check to see if there is any play in the motor shaft and that the mo ... Eureka Smartvac 4870 Bagged Upright Vacuum
Power Head keeps cutting in and out while vacuuming???Canister motor keeps running but the power head starts and stops like there is a short or some loss of connection somewhere. Any ideas?
My kenmore progressive vacuum had the same problem. The electrical terminal at the bottom of the wand was corroded. I used a flat head screw driver to scrape the female portion of the connector as best as I could. I then took off the plastic cover on ... Kenmore 23913 Progressive PowerMate Bagged Canister Vacuum
I have a Bissell 9400 E pro heat turbo. It's only been used 4 times, today it sounded like something blew. All my house electrics went off...( blew the main trip) I did read some place that the motor can short out and blow the PCB. Hubby and I just took it apart..( what a pain that was) We can't see a thing wrong with the board...( I expected to see something black, or damaged).... because when it blew today there was a weird smell... sort of like garlic. Question... how on this spinning earth
I have the exact same problem! Just occurred today. When I switch it on it fires for a couple of seconds then takes all the electrics in the house out again.\012\012\012Did ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
There seems to be a short in the motor of a Miele S716 vac. Water was accidentally sucked up about 2 months ago
Are you sure about the model number, S716 doesn't come up. But it could be a bad motor, or it be a circuit board mounted by the motor. ... Miele Vacuums
Aquavac runs for short time then cuts out blowing the RCD . Have rewired mains cable thinking a broken or loose wire... still same problem. Have also noticed that a lot of sparks etc coming from the motor brushes. Vac approx 10-15yrs old.Aquavac is model 6310B